Braun Door 33657- User Manual
Braun Door 33657– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Secure Lift; as specified in Figures E and; stud. Place one large diameter flat; Maximum; must be equal
- Page 3 – Electrical, Hydraulic and Interlock; Pump; Figure K; Chassis; Figure L; Ground Cable Mounting; Figure N; must be; Power Cable
- Page 4 – DOT — Public Use Lift; Calibration and Floor Level Adjustment; Platform Sense Calibration
- Page 5 – Lift Operating Instructions; floor level; WARNING; Whenever a; Hand-held Pendant Control
- Page 6 – Note: Location of power; Cable-Activated Platform Manual Release System; Manual Operating Instructions; OUTER BARRIER; PLATFORM
- Page 7 – Maintenance and Lubrication; Cycles; Lubrication Diagram; WA; SG - Synthetic Grease
- Page 8 – Consecutive; Adjustments and Diagnostics; TSLV; Pump Module
Braun Corporation FMVSS No. 403 Quick Reference Installation Sheet 33675 Rev. A
DOOR OPENING
90
CENTER IN
DOOR OPENING
CENTER
ACROSS
VEHICLE FRAME
L
C
20-1/4"
20-1/4"
40-1/2"
1
All-Thread
Mounting
Brackets
Engage Platform Manual
Release System: The lift
cable-activated platform
manual release is disengaged
during shipment to prevent
potential drive chain stretch.
Handle the lift with care. En-
gage manual release before
attempting to install (raise, tilt
or move) the lift.
WARNING
Engage manual
release before
attempting to install
(raise, tilt or move)
lift. Failure to do so
may result in serious
bodily injury and/or
property damage.
Figure C
Locate Lift Mounting Brackets
Locate All-Thread Mounting
Brackets
1. Open both doors to 90°.
2. Locate center of door opening
(between doors). Mark the
center point.
3. Transfer center point to the
vehicle frame. Using a front-
to-rear framing member as a
guide, transfer the center point
across chassis to opposite side
front-to-rear framing member
(must be 90° to door opening).
Lift mounting bracket positions
are based on this center line.
4. Measure 20-1/4" to left and
right of the center line to
achieve the 40-1/2" center-to-
center spacing of all-thread
mounting studs.
5. Clamp the mounting brackets
securely in place (all-thread
studs must be vertical).
“DOT — Public Use Lift”
NHTSA Vehicle Physical Requirements
Alternative floor structures are allowed
providing the installed lift system pass-
es all FMVSS 403 requirements.
Figure A
VEHICLE
CHASSIS MEMBER
16
”
Maximum
VEHICLE
CHASSIS MEMBER
All-thread
Mounting
Brackets
Mounting Bracket Requirements:
A maximum distance of 16
"
from the
outermost mounting bracket to the
end of the cassette.
All four mounting brackets must be
connected to the framerails.
Vehicle Requirements:
All vehicles with a GVW over 6000 lbs.
and with unmodified OEM framerails.
Clear Door Opening Width
Maximum Floor-to-Ground
B
A
C
Figure B
Door Opening Dimensions
Vehicle lift access door opening
must meet specified dimensions.
Minimum Clear Door
Opening Height
A
B
C
604
NA
40-1/2"
34"
“DOT - Public Use Lift” verifies this platform lift
meets the “public use lift” requirements of FMVSS
No. 403. This lift may be installed on all vehicles
appropriate for the size and weight of the lift, but
must be installed on buses, school buses, and
multi-purpose passenger vehicles other than
motor homes with a gross vehicle weight rating
(GVWR) that exceeds 4,536 kg (10,000 lb).
Braun Corporation FMVSS No. 403
Rev: A
Quick Reference Installation Sheet 33675
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Braun Corporation FMVSS No. 403 Quick Reference Installation Sheet 33675 Rev. A VEHICLE BOX FRAME VEHICLE CHASSIS MEMBER 2 Secure Lift Attach Mounting Brackets to Vehicle Frame Mounting bolts must be routed horizontally through the verti- cal face of the “L” brackets and framing members as shown in ...
Braun Corporation FMVSS No. 403 Quick Reference Installation Sheet 33675 Rev. A 3 Electrical, Hydraulic and Interlock Pump Mounting Bracket Min. 1-3/4” to Wall Pump must face Out Mount Pump Vertical 1/4-20 x 3/8" Hex Screws Lock Washer Reinforcement “L” Bracket Cable-activated Manual Release (fr...
Braun Corporation FMVSS No. 403 Quick Reference Installation Sheet 33675 Rev. A Threshold Sensor Mat 5 FMVSS 403/404 Certification Checklist Dual Outer Barrier Threshold Area Platform Lighting Visual and Audible Threshold Warning Platform Inner Roll Stop DOT — Public Use Lift Public use vehicle manu...
