Braun 403 - Manual

Braun 403

Braun 403 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
Page: / 8

Table of Contents:

  • Page 2 – Secure Lift; Figure F; must be equal; Figure D
  • Page 3 – Electrical, Hydraulic and Interlock; Chassis; Figure J; Ground Cable Mounting; Figure L; NHTSA requirements,; Power Cable; Figure K; Figure I
  • Page 4 – Calibration and Floor Level Adjustment; DOT — Public Use Lift
  • Page 5 – Lift Operating Instructions
  • Page 6 – WARNING; Manual Operating Instructions; Note: Close valve before operating electric pump.; Handrail Operating Instructions
  • Page 7 – Cycles; SG - Synthetic Grease; Maintenance and Lubrication; WA; Lubrication Diagram
  • Page 8 – Consecutive; Adjustments and Diagnostics; TSLV
Loading the manual

Braun Corporation FMVSS No. 403 Quick Reference Installation Sheet 34274 Rev. A

1

“DOT — Public Use Lift”

NHTSA Vehicle Physical Requirements

Figure A

Mounting Bracket
Requirements:

All four mounting brackets must be
connected to the vehicle chassis
floor members.

Door Opening Dimensions:

Vehicle lift access door opening
must meet specified dimensions.

Vehicle Requirements:

All vehicles with a GVW over 6000 lbs.
and with unmodified OEM framerails.

Clear Door Opening Width

Maximum Floor-to-Ground

B

A

C

Figure B

Minimum Clear Door
Opening Height

A

B

C

NUVL855RM24

NA

43½"

62½"

“DOT - Public Use Lift” verifies this platform lift meets the “public use lift” requirements of FMVSS No. 403.
This lift may be installed on all vehicles appropriate for the size and weight of the lift, but must be installed
on buses, school buses, and multi-purpose passenger vehicles other than motor homes with a gross ve-
hicle weight rating (GVWR) that exceeds 4,536 kg (10,000 lb).

WARNING

Engage manual
release before
attempting to

install

(raise, tilt or move)
lift

.

Failure to do so

may result in serious
bodily injury and/or
property damage.

Figure C

Locate Lift Mounting Brackets

Braun Corporation FMVSS No. 403

Alternative
floor structures
are allowed
providing the
installed lift
system passes
all FMVSS 403
requirements.

Lift Mounting Brackets

(typical both sides)

Right

Left

Inboard

Outboard

Quick Reference Installation Sheet 34274

Rev: A

Vehicle Floor

Chassis Members

DOOR OPENING

90

CENTER IN

DOOR OPENING

CENTER

ACROSS

VEHICLE FRAME

L

C

22-3/8"

22-3/8"

44-3/4"

All-Thread

Mounting Studs

Locate Lift Mounting Brackets

1. Open door(s) fully (min. 90°).

2. Locate center of door opening.

Mark the center point.

3. Transfer center point to the

vehicle frame. Using a front-
to-rear framing member as a
guide, transfer the center point
across chassis to opposite side
front-to-rear framing member
(must be 90° to door opening).
Lift mounting bracket positions
are based on this center line.

4. Measure 22-3/8" to left and

right of the center line to
achieve the 44-3/4" center-to-
center spacing of all-thread
mounting studs.

5. Clamp the mounting brackets

securely in place (all-thread

studs must be vertical

).

Engage Platform Manual
Release System:

The lift

cable-activated platform
manual release is disengaged
during shipment to prevent
potential drive chain stretch.
Handle the lift with
care.

Engage manual

release before

at-

tempting to

install

(raise, tilt or move)
the

lift

.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Other Manuals for Braun 403

Summary

Page 2 - Secure Lift; Figure F; must be equal; Figure D

Braun Corporation FMVSS No. 403 Quick Reference Installation Sheet 34274 Rev. A 2 Secure Lift 1. Attach Mounting Brackets to Vehicle Framing Members Position lift mounting brackets as detailed in Step 1 (see Figures C, D and F). Oval slotted mounting holes are provided in the mounting brackets to al...

Page 3 - Electrical, Hydraulic and Interlock; Chassis; Figure J; Ground Cable Mounting; Figure L; NHTSA requirements,; Power Cable; Figure K; Figure I

Braun Corporation FMVSS No. 403 Quick Reference Installation Sheet 34274 Rev. A Main Lift Wi ring Harnesses Strobe Alarm Platform Lights Threshold Mat 1 Main Lift W iring Harnesses Threshold Mat 2 MCI Door Operator MCI Full Closed To Lift 1 Disconnect and remove eye terminal 2 Connect vehicle interl...

Page 4 - Calibration and Floor Level Adjustment; DOT — Public Use Lift

Braun Corporation FMVSS No. 403 Quick Reference Installation Sheet 34274 Rev. A K MP916 0.010 Ω .5% R 321 321 321 LCD MODULE 8.00M L_DN B_UP L_OUT L_UP B_DN L_IN 50# CAL O_BAR D14 J27 U ? CYCLE DIAG U15 U11 U10 U2 J9 J1 1 J10 J17 J16 J14 J8 J5 J21 J19 J20 D9 D6 D8 D7 D13 D11 8 3 J 9 3 J K7 K10 D12 D...

Other Braun Models