Zenoah G3801EZ - Manuals

G3801/G3801EZ G B GB-7 4. Fuel and Chain Oil ■ FUEL WARNING • Gasoline is very flammable. Avoid smoking orbringing any flame or sparks near fuel. Make sureto stop the engine and allow it cool before refuel-ing the unit. Select outdoor bare ground for fuel-ing and move at least 3 m (10 ft) away from ...

G3801/G3801EZ GB-8 6. When engine has ignited, first push in the choke knob to “START” position and then pull the starter againto start the engine. 7. Allow the engine to warm up with the throttle lever pulled slightly.At once pulling throttle lever out, the choke knob isautomatically returned to th...

G3801/G3801EZ GB-12 4. Spark plug Clean the electrodes with a wire brush and reset the gap to0.65 mm as necessary. 5. Sprocket Check for cracks and for excessive wear interfering with thechain drive. If the wear is considerable, replace it with newone. Never fit a new chain on a worn sprocket, or a ...

G3801/G3801EZ G B GB-13 WARNING: This saw is equipped with one of the following low kick-back bar/chain combinations: Zenoah Part Number Saw Model Chain Type Guide Bar Saw Chain G3801/G3801EZ 91VG 3608-52112 2932-52210 G3801/G3801EZ 95VP 2939-52110 2939-52210 side of a cutter. If a gap is observed b...

G3801/G3801EZ G B GB-15 Limited warranty Should any failure occur on the product under normaloperating conditions within the applicable warrantyperiod, the failed part will be replaced or repaired freeof charge by a ZENOAH authorized dealer. WARRANTY PERIOD: Six (6) months after purchased by end-use...