Yamaha SVV-200 - Manuals

6 ● Controls VOLUME POWER switch ON/OFF POWER lamp EQ MODE 1 : GreenEQ MODE 2 : Red EQ CTRL(Equalizer control) Pickup balancer(located inside) EQ MODE switch(Equalizer mode switch) EQ MODE 1/EQ MODE 2 6F22 (S-006P) 9V battery PHONES jack : Stereo mini type LINE OUT jack : Standard phone type(monaura...

7 Setup ■ Installing the Bridge The Silent Viola is shipped from the factory with the bridge unfitted. First, set up the bridge and then proceed with tuning. • The lower side of the bridge supports the 1st string (A), the higher side supports the 4th string (C). Make sure the bridge is placed proper...

8 ■ The Shoulder Rest Most standard size viola rests can be attached to the body of the Silent Viola. Shoulder rest • Do not over-tighten or over-loosen the adjuster. It may result in damage to the instrument or be a source of noise during performance. • When removing the bridge from the instrument,...

9 ■ Changing Strings As the strings get old, sound quality will gradually decrease, and it will become difficult to tune the instrument. Change the strings as soon as you think they are getting old. Always change the strings one at a time, even if all strings must be changed. The adjuster should be ...

11 Power Supply The Silent Viola is powered by a single 6F22 (S-006P) 9V battery. Before installing the bat- tery, make sure that the POWER switch (ON/OFF) located on the backside of the instrument is in its OFF position. Bij dit produkt zijn batterijen geleverd.Wanneer deze leeg zijn, moet u ze nie...

12 Using the Controls q POWER Switch Used to switch the power ON/OFF. w VOLUME Used to control the volume. Rotate the knob to the right to increase the volume. e EQ CTRL (Equalizer Control) The SVV-200 Silent Viola is equipped with an Equal- izer Control that has the ability to isolate and control t...

13 t Pickup Balancer The Silent Viola's pickup system consists of separate sensors for low strings and high strings. Depending upon the type of strings and your playing style, you might want to adjust the balance of the high and low sensors. If so, please use the following procedure. 1 Remove the ru...

14 y LINE OUT jack This jack (standard phone, monaural) delivers signal output of the Silent Viola’s tone. Use an audio cable to connect the instrument to the audio input jack of powered speakers, mixing console, cassette player, etc. to listen from external audio equipment or recording. You can als...

15 Example Connections Silent Viola Stereo Earphones Electronic Tuner When connecting the instrument to external audio equipment, check the jack size and make sure to use aplug size that corresponds to the jack being used, and properly connect the cable to the jack. P.A. Mixer, Recording Device Powe...

16 Specifications Neck Hard Maple Body Spruce Fingerboard/Tuning Pegs Ebony Bridge Hard Maple (Aubert) Frame Plywood Chin Rest/Tailpiece Ebony Adjuster 1st string (Wittner) Strings Ball-end type (Dominant) Sensor Stereo Piezo pick-up (underneath the bridge) Connectors/Controls • Headphone Output • E...