Page 2 - SPECIAL MESSAGE SECTION; PLEASE KEEP THIS MANUAL
2 FCC INFORMATION (U.S.A.) electronic devices. Compliance with FCC regulations does not guaran-tee that interference will not occur in all installations. If this product isfound to be the source of interference, which can be determined byturning the unit “OFF” and “ON”, please try to eliminate the p...
Page 4 - Main Unit/Accessories
4 Main Unit/Accessories After opening the packaging, please check that all the parts listed below areincluded. SVC110 • Cello • Bridge • S U M - 3 s i z e M a n g a n e s e batteries x2 • Audio cable (For connection of AUX IN jack) • Stereo headphones • Chest support • Soft case svc110̲e.pm6 06.4.27...
Page 5 - Nomenclature; Front
5 Nomenclature ● Front Fingerboard Neck Saddle Tuning peg Nut 4th string (C) 3rd string (G) 2nd string (D) 1st string (A) Adjuster Frame Tailpiece Body Bridge seat Tail nylon End pin End pin stopper Bridge svc110̲e.pm6 06.4.27, 10:45 AM Page 5 Adobe PageMaker 6.0J/PPC
Page 6 - Rear
6 POWER switch REV. ON/ON/OFF Lamp PHONES jack REVERB switch RM (ROOM)HL1 (HALL 1)HL2 (HALL 2) LINE OUT jack DC-IN 9-12V jack (+ –) (Power adaptor connector) Cord hook Wrap the Power Adaptor’s cord around the cordhook (prevents cord from being unplugged). Battery cover AUX VOL(AUX volume) AUX IN jac...
Page 7 - Basic Operation; reverberation found in a hall.
7 ■ AUX IN jack • The AUX IN jack, located on the rear of the in-strument, can be used to connect an external ste-reo signal source to the Silent Electric Cello.Connecting the audio output of a CD player, etc.to the instrument allows you to play along withthe external audio source. • The AUX IN jack...
Page 8 - Tuning and Changing the Strings; Set up
8 ■ Tuning and Changing the Strings The Silent Electric Cello is shipped from the factory with the bridge unfitted. First, set up the bridge and then proceed with tuning. As the strings get old, sound quality will gradually decrease, and it will become difficult to tune the in- strument. Change the ...
Page 9 - Winding the Strings; Before you string the instrument, set all adjusters so that
9 • If the adjuster is too loose, it could producenoise while playing. Caution Don’t loosen too much. Make sure that the Tail Nylon is cor-rectly positioned on top of the Saddle. Tall nylon Saddle Caution • When the instrument is not being used, loosen the strings until the pitch drops a whole tone....
Page 10 - About the Chest Support; About the End Pin
10 ■ About the Chest Support The chest support is used to rest the cello against your body. As shown in the illustration, insert the pins on the chest support into the attaching holes located on the back of the instrument. Rubber Foot End Pin End PinStopper ■ About the End Pin Loosen the end pin sto...
Page 11 - Power Supply; Using Batteries
11 Power Supply The Silent Electric Cello can be operated with either battery or AC power. Al-ways turn the power switch (OFF/ON/REV.ON) on the rear panel OFF beforemaking AC power connections or replacing batteries. ■ Using Batteries 1 Open the battery compartment situated on the back of the Silent...
Page 12 - Specifications
12 Specifications Neck Maple Body Spruce/Maple Fingerboard/Tuning Pegs Ebony Bridge Maple (Aubert) Frame Plywood Tail Piece Adjuster 4 pieces (Wittner) Strings Ball-end type (Helicore) Sensor Piezo pick-up Connectors/Controls • Headphone Output • AUX IN (w/Volume Control) • LINE OUT • Volume • Rever...