Yamaha MG32/14FX- Manuals

Page 2 - • Explanation of Graphical Symbols; IMPORTANT SAFETY INSTRUCTIONS; C A U T I O N; WARNING

MG32/14FX, MG24/14FX 2 The above warning is located on the rearof the unit • Explanation of Graphical Symbols The lightning flash with arrowhead symbolwithin an equilateral triangle is intended toalert the user to the presence of uninsulated“dangerous voltage” within the product’senclosure that may ...

Page 3 - PRECAUTIONS; PLEASE READ CAREFULLY BEFORE PROCEEDING; * Please keep this manual in a safe place for future reference.

MG32/14FX, MG24/14FX 3 PRECAUTIONS PLEASE READ CAREFULLY BEFORE PROCEEDING * Please keep this manual in a safe place for future reference. WARNING Always follow the basic precautions listed below to avoid the possibility of serious injury or even death from electrical shock, short-circuiting, damage...

Page 4 - IMPORTANT NOTICE FOR THE UNITED KINGDOM

MG32/14FX, MG24/14FX 4 Always turn the power off when the device is not in use. The performance of components with moving contacts, such as switches, volume controls, and connectors, deteriorates over time. Consult quali-fied Yamaha service personnel about replacing defective components. Copying of ...

Page 6 - Introduction; Features

MG32/14FX, MG24/14FX 6 Introduction Thank you for your purchase of the YAMAHA MG32/14FX or MG24/14FX mixing console.This console offers excellent cost-performance and is ideal for use as the main mixer in anSR setup or as part of an installed system. Please read through this Owner’s Manual carefully...

Page 7 - Connecting to Power

Introduction MG32/14FX, MG24/14FX 7 (1) Be sure that the mixer’s power switch is off ( ). (2) Connect the socket end of the power cord to the AC IN connec- tor on the rear of the mixer. (3) Plug the other end of the power cord into a standard household power outlet. Be sure to unplug the power cord ...

Page 8 - Front Panel; Channel Control Block

MG32/14FX, MG24/14FX 8 Front & Rear Panels Front Panel Note: Within this manual, all panel illustrations show the MG32/14FX panel. 11 8 10 3 4 2 7 6 5 1 9 8 Channel Control Block Master Control Block 1 MONAURAL CHANNELS Section (p. 10) 3 STEREO/MONO Section (p. 13) 2 STEREO CHANNELS Section (p. ...

Page 9 - Rear Panel; Rear Input/Output Block

Front & Rear Panels MG32/14FX, MG24/14FX 9 Rear Panel Note: Within this manual, all panel illustrations show the MG32/14FX panel. 12 13 Rear Input/Output Block 12 CHANNEL I/O Section (p. 19) 13 MASTER I/O Section (p. 20)

Page 10 - Equalizer Controls

Front & Rear Panels MG32/14FX, MG24/14FX 10 ■ MONAURAL CHANNELS Section STEREO CHANNELS Section 1 PAD Switch When this switch is on ( ), the mixer attenuates the input signal by 26 dB. 2 GAIN Control Adjusts the gain applied to the input signal level. To get thebest balance between the S/N ratio...

Page 12 - Monaural channels

Front & Rear Panels MG32/14FX, MG24/14FX 12 G PHANTOM +48 V Switch Toggles phantom power on or off to a set of eight adjacentchannels. The MG32/14FX has three of these switches: forCHs 1 to 8, for CHs 9 to 16, and for CHs 17 to 24. TheMG24/14FX has two: for CHs 1 to 8 and for CHs 9 to16. Ifusing...

Page 13 - Master Control Block

Front & Rear Panels MG32/14FX, MG24/14FX 13 ■ STEREO/MONO Section You use this section to independently adjust the levels of the out-puts from the ST bus. You can independently adjust the main stereooutput, the sub stereo output, and the mixed monaural output. 1 ST SUB OUT Control Adjusts the le...

Page 14 - TO ST Switches; Group Faders

Front & Rear Panels MG32/14FX, MG24/14FX 14 ■ GROUP Section This section adjusts the level and controls the flow of the signalsfrom the four GROUP buses. While the signal from each GROUPbus is always fed into the corresponding GROUP OUT jack (seepage 20), you are also free to use the TO ST and A...

Page 21 - Connector Polarities

Front & Rear Panels MG32/14FX, MG24/14FX 21 7 ST INSERT I/O (L, R) Jacks These are balanced TRS (tip, ring, sleeve) phone-type bidirec-tional jacks. You use these jacks, for example, to connect to anexternal effector, submixer, or other such device. Connection to an INSERT I/O jack requires a sp...

Page 22 - Appendix; General Specifications; Specifications

MG32/14FX, MG24/14FX 22 Appendix ■ General Specifications Where 0 dBu = 0.775 V and 0 dBV= 1 V 1 Rs = 150 ohms Measured with 12.7 kHz, –6 dB/oct. low pass filter (equivalent to 20 kHz, – ∞ filter). 2 Turning PAN/BAL to left or right. 3 Shelving turnover/rolloff frequency: 3 dB before maximum cut or ...

Page 23 - Input Specifications

Appendix MG32/14FX, MG24/14FX 23 ■ Input Specifications Where 0 dBu = 0.775 V and 0 dBV= 1 V 1 Input sensitivity: the lowest level that will produce the nominal output level when the unit is set to maximum gain. 2 MG32/14FX: CH29(L)/30(R), CH31(L)/32(R), MG24/14FX: CH21(L)/22(R), CH23(L)/24(R) ■ Out...

Page 24 - Digital effect type list

Appendix MG32/14FX, MG24/14FX 24 ■ Digital effect type list • Common to EFFECT 1 and 2 • EFFECT 1 • EFFECT 2 * The LED can not blink any faster than an interval of 256 ms (234.3 bpm). No. Type Description Controllable parameter Parameter Variable range 1 REVERB HALL Reverberation simulating a spacio...

Page 25 - Dimensional Diagrams

Appendix MG32/14FX, MG24/14FX 25 ■ MG32/14FX ■ MG24/14FX Dimensional Diagrams 1027 765 98.5 101 140 551 415 48 Unit: mm 819 98.5 557 101 140 551 415 48 Unit: mm

Page 26 - Block and Level Diagram

Appendix MG32/14FX, MG24/14FX 26 Block and Level Diagram