Yamaha 001PO-03C0 - Manuals

IPA8200 Owner’s Manual 5 Introduction Thank you for purchasing the Yamaha IPA8200 power amplifier. In order to take full advantage of the IPA8200’s functionality and to ensure trou-ble-free operation, please read this owner’s manual carefully before use. After you have read the manual, keep it in a ...

IPA8200 Owner’s Manual 6 Introduction ............................................................................................................. 5 Features .............................................................................................................. 5 Precautions when rack-mounti...

IPA8200 Owner’s Manual 7 Controls and Functions q POWER switch and indicator Turns power to the unit on or off. The indicator lights green when the power is on. w PROTECT indicator When the protection system is active, the indicator lights red. When this is lit, the amplifier or power supply is auto...

IPA8200 Owner’s Manual 8 Controls and Functions q INPUT connectors These are balanced input connectors. The included Eurob-lock connectors can be used to make connections here. w SPEAKERS connectors These are barrier strip type speaker output connectors. • If using BRIDGE mode, connect the speakers ...

IPA8200 Owner’s Manual 9 Mode settings Speakers can be connected to the IPA8200 using the following three mode settings. The total load impedance of the speakers that can be connected will depend on the mode setting. Do not use a setup that has a lower impedance than the minimum values shown below. ...

IPA8200 Owner’s Manual 10 Connections Please be sure to use the supplied Euroblock connectors. If you lose them, contact your nearest Yamaha dealer. 1. If the wire insertion ports are closed, turn the screws ontop of the connector counterclockwise to open theports. 2. Insert the wires into the appro...

IPA8200 Owner’s Manual 11 Troubleshooting Indicator(s) Possible cause Remedy Protection circuit CLIP indicator is lit. Output exceeds 100 W (8 Ω ) or 200 W (4 Ω ). Lower the input level. Limiter circuit will operate to protect the power amp and power supply. PROTECT indi-cator is lit. Speaker output...

IPA8200 Owner’s Manual 57 Specifications General Specifications • Half power = 3dB below rated power• 0dBu = 0.775Vrms Output Power 4 Ω per channel 200W x 8 8 Ω per channel 100W x 8 1kHz, THD+N=1% 8 Ω / BRIDGE 400W x 4 20Hz-20kHz, THD+N=1% 4 Ω per channel 180W x 8 8 Ω per channel 90W x 8 8 Ω / BRIDG...

IPA8200 Owner’s Manual 58 Specifications Block Diagram Dimensions BA ATTENUATOR ATTENUATOR HA MUTE MUTE GAIN GAIN HA MODE MODE STEREO BRIDGE STEREO BRIDGE PARALLEL STEREO BRIDGE PARALLEL PARALLEL +– G CH A, C, E, G +– G CH B, D, F , H HPF HPF Comp. HPF Fc=55Hz HPF Fc=20Hz HPF Fc=55Hz HPF Fc=20Hz Com...

IPA8200 Owner’s Manual 59 Specifications Current Draw 1/8 power is typical of program material with occasional clipping. Refer to these figures for most applications.1/3 power represents program material with extremely heavy clipping.Test signal: Pink Noise, bandwidth limited from 22Hz to 22kHz1W = ...

IPA8200 Owner’s Manual 61 Information for Users on Collection and Disposal of Old Equipment This symbol on the products, packaging, and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste.For proper treatment, recovery and rec...