Wolf DUAL FUEL RANGES - Manuals

Page 2 - Wolf Dual; CAUTION

2 I M P O R T A N T I N F O R M A T I O N IMPORTANT NOTE: Thisinstallation must be completedby a qualified installer, serviceagency or gas supplier. • INSTALLER: please retain these instructions for local inspector’sreference, then leave them with thehomeowner. • Please read the entire installation ...

Page 3 - WHAT TO DO IF YOU SMELL GAS:; WARNING; B E F O R E Y O U S T A R T; natural gas or LP; S I T E P R E P A R A T I O N

3 P R E - I N S T A L L A T I O N WHAT TO DO IF YOU SMELL GAS: • Do not try to light anyappliance. • Do not touch any electricalswitch. • Do not use any phone in yourbuilding. • Immediately call your gassupplier from a neighboringphone. Follow the gassupplier’s instructions. • If you cannot reach yo...

Page 4 - R E; Rolling Casters; U N P A C K T H E R A N G E; Installation

• The rear of the range has rolling casters which allows for easy move-ment of the range by picking up onthe front of the unit. Do not lift by oven door handle(s). See illustration below. NOTE: The range comes from thefactory at an overall height of 35-7/8"(from floor to the top of the bullnose)...

Page 5 - Oven Door Removal

NOTE: Only one of the hinge armsis spring loaded, which requires useof the hinge pin for removal. Refer tothe following illustrations for thelocation of the hinge pin on variousmodels. For 30-inch and 36-inch units, thehinge pin will be inserted throughthe hole in the right hinge arm(looking at the ...

Page 6 - Overall width of range (width may vary to +; Installation Dimensions; Peninsula Installation:; Installation Dimensions

6 P R E - I N S T A L L A T I O N Installation Dimensions 30" Range 36" Range 48" Range 60" Range A Overall width of range (width may vary to + 1 / 8 ") 29 7 / 8 " 35 7 / 8 " 47 7 / 8 " 60 1 / 8 " B Finished rough opening width 30 " 36 " 48 " 60 1 / 4 ...

Page 7 - I N S T A L L A T I O N D I M E N S I O N S

7 E LOCATION OF ELECTRICAL 36" (91.4) 36 7 / 8 " (93.7) TO COOKINGSURFACE 30" min (76.2) COOKING SURFACE TO COMBUSTIBLE CONSTRUCTION 44" min (91.4) TO CHARBROILER 30" min (76.2) TO BOTTOM OF VENTILATION HOOD VENTILATION HOOD COMBUSTIBLE CONSTRUCTION 18" min (45.7) TO COOKING ...

Page 8 - N S T A L L A T I O N; EXPLOSION HAZARD –

8 I N S T A L L A T I O N • Provide a gas supply line of 3/4" rigid pipe to the range location. Asmaller size pipe on long runs mayresult in insufficient gas supply. Pipejoint compounds, suitable for usewith LP gas should be used. For LPgas, piping or tubing size can be 1/2"minimum. LP gas s...

Page 9 - For UL installations:

9 E L E C T R I C A LR E Q U I R E M E N T S • Maximum connected load: 5,200 W (30-inch and 36-inch units), 10,000 W (48-inch units), 10,200 W (60-inch units). • Required power supply: 240V / 30A / 60Hz (30-inch and 36-inch units),240V / 50A / 60Hz (48-inch and 60-inch units). • Minimum supply wire ...

Page 10 - Gas Supply Line Connection; natural and LP gas; Where Local Codes Permit –

10 G A S S U P P L Y L I N EC O N N E C T I O N IMPORTANT NOTE: All connections must be wrench-tightened. Do notmake connections to the gas pipingtoo tight. Making the connection tootight may crack the regulator andcause a gas leak. Do not allow thepipes to turn when tightening fittingsas the tubing...

Page 11 - Put the burner heads on each; FLOOR; Raise the unit to its desired height

11 Leak testing of the applianceshall be conducted according tothe following instructions: Use a brush and liquid detergent totest all gas connections for leaks.Bubbles around connections willindicate a leak. If a leak appears, shutoff gas valve controls and adjust con-nections. Then check connectio...

Page 12 - Oven Door Reinstallation:; Reinstall Oven Door

12 I N S T A L L A T I O N E L E C T R O N I C I G N I T I O NI N I T I A L L I G H T I N G Range burners use electronic ignitersin place of standing pilots. When therange control knob is pushed in andturned to the "HIGH" position, thesystem creates a spark to light theburner. This sparking ...

Page 13 - W I R I N G D I A G R A M; Wolf Dual Fuel Ranges Use &

13 W I R I N G D I A G R A M The wiring diagram covering thecontrol circuit is located behind theskirt / lower panel, below the ovendoor panels. V E R I F Y R A N G EO P E R A T I O N IMPORTANT NOTE: Prior to operat- ing the range, please read the accom-panying Wolf Dual Fuel Ranges Use & Care I...

Page 14 - M P O R T A N T

C L E A N I N G A N DM A I N T E N A N C E If removing the range is necessaryfor cleaning or maintenance, shut offgas supply. Disconnect the gas andelectric supply. After disconnectingthe gas and electric supply, finishremoving the unit for cleaning andservicing. Reinstall in reverse orderand check ...