Windsor SPD - Manuals - manualsarea.com

Page 2 - READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE.; This machine is for commercial use.; SAVE THESE INSTRUCTIONS

When using an electrical appliance, basic precaution must always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE. This machine is for commercial use. 1. Use only as described in this manual. Use only manufacturer’s recommended attachments. 2. Use indoors only. D...

Page 4 - Model

Adjust brush to proper cleaning position by using lever located on the front of the frame. Start at No. 1 “new brush” (black) position. If more carpet pile agitation is desired, lower brush setting one posi- tion at a time. (See fig. 1 below) Fig. 1 Model Rear Panel 230V Model Rear Panel SPD 98353

Page 5 - Filling Solution Tank:

Preparing the SPIRIT DUAL: For Hard Floor: 1.) Install the optional kit : Vac Shoe Squeegee (p/n 02285). Raise the SPD vac shoe and place the squeegee assembly over the vac shoe intake. Center the squeegee on the vac shoe and secure by tightening the two retain- ing knobs. CAUTION: Make sure that th...

Page 6 - SPIRIT

SPIRIT 1. A. NOTE: Starting the machine with dry brush rest- ing on floor may trip the brush motor circuitbreaker. 10. 11. 12. An overflow of foam from in the recovery tank into the vacuum intake can damage the motor. Always be aware of the waste water level and foam in the recovery tank, es ecially...

Page 8 - For infrequent use or long periods of stor-

This product contains moving parts. To reduce the risk of injury; unplug the machine before servicing. Maintenance and repairs must be doneby qualified personnel ONLY. CAUTION: Using non-Windsor parts to repair thismachine will void the 6-3-1 warranty. Warranty information is located on the back of ...

Page 10 - Troubleshooting Chart; Condition

Troubleshooting Chart Condition Corrective Action No Power To Machine: Dead electrical circuit breaker in fuse box Faulty power cord Power switch failure Faulty circuit breaker Internal wiring problem Electrical Shock: Equipment not grounding Receptacle not grounded Internal electrical problem Nuisa...

Page 12 - Servicing the Vac Motor; The green ground wire; Wire Terminal; Periodically check the length of the; BEFORE

Servicing the Vac Motor To access the vac motor first remove the solution tank. There are (2) screws which attach thevac motor mounting bracket to the chassis. Loosen the clamp to remove the hose. To replace the motor assembly it will be necessary to remove the (3) screws which attach the motor to t...

Page 13 - Vac Shoe Assembly; Reverse

Page 15 - RECOVERY TANK PARTS LIST

RECOVERY ASSEMBLY List RECOVERY TANK PARTS LIST; 2 87013 Washer, Flat 3 73280 Spacer, 1/4 ID x 3/8 Nylon 4 38088 Handle, Recovery Tank 5 75078 Tank, Recovery 6 1 4 0 4 2 1.63 ID Snap 7 39343 Hose, 1.5 x 34” Vac 8 3 9 4 1 1 Hose, 1.5 x Vac 9 27079 Cuff, White 1.5 Hose 10 27508 Cuff, Short Blue Hose 1...

Page 16 - Spray Jets; Rinse in hot water or use compressed air to

Spray Jets Rinse in hot water or use compressed air to clean. Nozzles can also be soaked in an acetic acid solution (white vinegar). CAUTION: Do not use pins or wires to clean or unclog jets. Using wires or pins to unclog jets may ruin spray pattern. Replace jets that no longer produce a fine mist s...

Page 18 - See page 4 for panel

Ground Arrangement See page 4 for panel configuration 18 SPD 98353

Page 21 - BRUSH DRIVE ASSEMBLY Parts List

BRUSH DRIVE ASSEMBLY Parts List 2 3 4 6 78 9 10 11 1213 14 09019 70078 03089 140080 140081 140156 87146 36166 70190 73181 70201 41296 7001187025 70020 Bearing, Brush Shoulder bolt, OD x L Axle, Pulley Brush, SPD Carpet Brush, SPD Hard Floor Brush, SPD Hard Floor (Grit) Washer, 1/2 ID x 1.0 OD x nyl ...

Page 24 - SPIRIT DUAL Squeegee Assembly; the SPD vac shoe and install squeegee assembly over

SPIRIT DUAL Squeegee Assembly 24 To attach to the SPIRIT DUAL... the SPD vac shoe and install squeegee assembly over the vac shoe intake. Center the squeegee on the vac shoe and se- cure by tightening the two retaining knobs.

Page 25 - SPR WIRING DIAGRAM

Page 26 - 0 DAY WARRANTY EXTENSION AVAILABLE; STATED WARRANTIES ARE IN LIEU OF ALL OTHER WARRANTIES,

LIMITED WARRANTY Windsor Industries, Inc. warrants new machines against defects in material and workmanship under normal use and service to the original purchaser. The warranty period is subject to the conditions stated below. 3 YEARS FOR PARTS AND I YEAR FOR SERVICE LABOR Exceptions: Rotationally m...