Windsor 10066300 - Manuals

Windsor 10066300 – Manual in PDF format online.

Manuals:

Manual

Manual Windsor 10066300

Summary

Page 2 - MACHINE DATA LOG/OVERVIEW; OVERVIEW; YOUR DEALER

MACHINE DATA LOG/OVERVIEW 86221970 17” SCRUBBER 01/03/07 2 OVERVIEW The Automatic Scrubber is a battery powered, hard floor scrubber intended for commercial use. The appliance applies a cleaning solution onto a hard floor, scrubs the floor with a brush or pad, and then vacuums the soiled water back ...

Page 3 - TABLE OF CONTENTS; OPERATIONS

TABLE OF CONTENTS 86221970 17” SCRUBBER 01/03/07 3 Machine Data Log/Overview. ............................... 2 Table of Contents ................................................. 3 HOW TO USE THIS MANUAL How to use this Manual. ....................................... 1-1 SAFETY Important Safety Ins...

Page 4 - HOW TO USE THIS MANUAL; REF –

HOW TO USE THIS MANUAL 86221970 17” SCRUBBER 01/03/07 1-1 This manual contains the following sections: - HOW TO USE THIS MANUAL - SAFETY - OPERATIONS - MAINTENANCE - PARTS LIST The HOW TO USE THIS MANUAL section will tell you how to find important information for ordering correct repair parts. Parts...

Page 5 - IMPORTANT SAFETY INSTRUCTIONS; When using a battery powered appliance, basic precaution; READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE.; SAVE THESE INSTRUCTIONS

86221970 17” SCRUBBER 01/03/07 2-1 IMPORTANT SAFETY INSTRUCTIONS When using a battery powered appliance, basic precaution must always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE. To reduce the risk of fire, electric shock, or injury: Use only indoors. Do not...

Page 6 - HAZARD INTENSITY LEVEL; WARNING; CAUTION; WARNING; Unless Operation Guide is Read and understood.

HAZARD INTENSITY LEVEL 86221970 17” SCRUBBER 01/03/07 2-2 The following symbols are used throughout this guide as indicated in their descriptions: HAZARD INTENSITY LEVEL There are three levels of hazard intensity identified by signal words - WARNING and CAUTION and FOR SAFETY. The level of hazard in...

Page 7 - SAFETY LABEL LOCATION

SAFETY LABEL LOCATION 86221970 17” SCRUBBER 01/24/07 2-3 NOTE: These drawings indicate the location of safety labels on the machine. If at any time the labels become illegible, promptly replace them. O R FIR E. DO NO T USE OR M ATE RIALS CANCAUSE EXP LOSIO N FLA MM ABLE M ATER IAL. PICK UP FLA MM AB...

Page 8 - TECHNICAL SPECIFICATIONS; ITEM DIMENSION/CAPACITY

TECHNICAL SPECIFICATIONS 86221970 17” SCRUBBER 01/03/07 3-1 ITEM DIMENSION/CAPACITY Rated Voltage 24 VDC Rated Amperage 30 Amps Batteries 2 x 12 Volt 105-130 AH Scrub Brush Motor 0.75hp (0.56 kw) Vacuum Motor 24 VDC 2 stage by pass Mass (GVW) 319 lbs (144.7 kg) Weight empty without batteries 142 lbs...

Page 9 - ITEM MEASURE; Height

TECHNICAL SPECIFICATIONS 86221970 17” SCRUBBER 01/03/07 3-2 ITEM MEASURE Height 35 in (0.89 m) Length 42 in (1.07 m) Width without squeegee 20 in (0.51 m) Width of squeegee 31 in (0.79 m) Width of scrub path 17 in (0.43 m) SPECIAL NOTES: The A-weighted sound pressure level emitted by the appliance w...

Page 10 - HOW THIS MACHINE WORKS

HOW THIS MACHINE WORKS 86221970 17” SCRUBBER 01/03/07 3-3 This Automatic Scrubber is a battery powered, hard floor scrubber intended for commercial use. The appliance applies a cleaning solution onto a hard floor, scrubs the floor with a brush, and then vacuums the soiled water back into the recover...

Page 11 - COMPONENTS; Solution Tank Drain Hose

COMPONENTS 86221970 17” SCRUBBER 01/03/07 3-4 14 13 12 11 10 9 8 7 6 5 4 3 2 1 1. Control Panel 2. Control Handle 3. Recovery Tank 4. Recovery Tank Drain Hose 5. Recovery Tank Domel 6. Scrub Brush/Pad 7. Solution Tank 8. Solution Tank Cover 9. Solution Tank Drain Hose 10. Solution Strainer 11. Solut...

Page 12 - CONTROLS

CONTROLS 86221970 17” SCRUBBER 01/03/07 3-5 1. Solution Control Lever 2. Brush Switch 3. Brush Lift Pedal 4. Vacuum Switch 5. Squeegee Lift Lever 6. Battery Charge Level Indicator 7. Hour Meter 8. Circuit Breaker 9. Brush Reverse Switch 1 2 3 4 5 6 7 8 9

Page 14 - MACHINE OPERATIONS; PRE-RUN MACHINE INSPECTION; Turn the machine off.; Measure; the chemical into the solution tank.

MACHINE OPERATIONS 86221970 17” SCRUBBER 01/03/07 3-7 PRE-RUN MACHINE INSPECTION Do a pre-run inspection to find possible problems that could cause poor performance or lost time from breakdown. Follow the same procedure each time to avoid missing steps. NOTE: See maintenance section for pre-run mach...

Page 15 - MACHINE OPERATION; EMPTYING AND CLEANING TANKS

MACHINE OPERATION 86221970 17” SCRUBBER 01/03/07 3-8 TO BEGIN SCRUBBING When operating the machine around people, pay close attention for unexpected movement. Use extra caution around children. Flammable liquids and/or reactive metals can cause explosions or fire! Do not pick up. 1. Lower the squeeg...

Page 16 - MAINTENANCE

MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-1 BATTERIES (WET CELL BATTERIES ONLY) The batteries provide the power to operate the machine. The batteries require regular maintenance to keep them operating at peak efficiency. The machine batteries will hold their charge for long periods of time, but t...

Page 17 - CHECKING BATTERY SPECIFIC GRAVITY; SPECIFIC GRAVITY; BATTERY CONDITION

MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-2 CHECKING BATTERY SPECIFIC GRAVITY Use a hydrometer to check the battery specific gravity. CHECKING GRAVITY A. Hydrometer B. Battery NOTE: Do not take readings immediately after adding distilled water, if the water and acid are not thoroughly mixed, the ...

Page 19 - ”. This feature will tell the

MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-4 SCRUB BRUSHES NOTE: All original equipment brushes are equipped with “Perform Alert © ”. This feature will tell the operator when it is time to replace the scrub brush. “Perform Alert © ” brushes have pre-trimmed bright yellow tufts to indicate the leng...

Page 21 - SERVICE SCHEDULE; MAINTENANCE DAILY

MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-6 SERVICE SCHEDULE MAINTENANCE DAILY WEEKLY MONTHLY ANNUALLY Check battery acid level * Check vac hose connections * Clean the squeegee blades * Inspect brush or pad for debris: wire string, wear * Inspect float ball screen * Drain & rinse tanks * Rai...

Page 22 - TROUBLESHOOTING; PROBLEM

TROUBLESHOOTING 86221970 17” SCRUBBER 01/03/07 4-7 PROBLEM CAUSE SOLUTION Poor or no water pick-up Debris caught on squeegee Remove debris Worn squeegee blades Replace squeegee blades Vacuum hose clogged Clear obstruction from hose Vacuum hose disconnected from squeegee or recovery tank Reconnect va...