Windsor 10027100 - Manuals - manualsarea.com

Page 2 - MACHINE DATA LOG; YOUR DEALER

MACHINE DATA LOG 86038450 04/12/07 2ENG YOUR DEALER Name: __________________________________________________________________________________________________ Address: _______________________________________________________________________________________________ Phone Number: ________________________...

Page 3 - TABLE OF CONTENTS

TABLE OF CONTENTS 86038450 04/12/07 3ENG Machine Data Log. ............................................... 2 Table of Contents ................................................. 3 HOW TO USE THIS MANUAL How to use this Manual. ....................................... 1-1 SAFETY Important Safety Instru...

Page 4 - HOW TO USE THIS MANUAL; REF –

HOW TO USE THIS MANUAL 86038450 04/12/07 1-1ENG This manual contains the following sections: - HOW TO USE THIS MANUAL - SAFETY - OPERATIONS - MAINTENANCE - PARTS LIST The HOW TO USE THIS MANUAL section will tell you how to find important information for ordering correct repair parts. Parts may be or...

Page 5 - IMPORTANT SAFETY INSTRUCTIONS; When using an battery powered appliance, basic precaution; READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE.; SAVE THESE INSTRUCTIONS

86038450 04/12/07 2-1ENG IMPORTANT SAFETY INSTRUCTIONS When using an battery powered appliance, basic precaution must always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE. To reduce the risk of fire, electric shock, or injury: Use only indoors. Do not use outd...

Page 6 - HAZARD INTENSITY LEVEL; WARNING; WARNING; WARNING

HAZARD INTENSITY LEVEL 86038450 04/12/07 2-2ENG The following symbols are used throughout this guide as indicated in their descriptions: HAZARD INTENSITY LEVEL There are three levels of hazard intensity identified by signal words - WARNING and CAUTION and FOR SAFETY. The level of hazard intensity is...

Page 8 - MACHINE OPERATION; OPERATING THE MACHINE

MACHINE OPERATION 86038450 04/12/07 3-2ENG PRE-RUN MACHINE INSPECTION 1. Disconnect the battery charger. (See battery charging procedure ). 2. Close the cover. 3. To raise the deck: Turn on the main power switch and press the burnishing head switch. 4. Turn or install a new burnishing pad as needed....

Page 9 - BATTERY INFORMATION; BATTERY MAINTENANCE; BATTERY CHARGING PROCEDURE

BATTERY INFORMATION 86038450 04/12/07 4-1ENG BATTERY MAINTENANCE 1. When cleaning batteries use a solution of baking soda and water. (Do not allow cleaning fluid to enter inside battery cells.) 2. Keep a proper electrolyte level in battery cells. 3. Wipe down the battery tops at least once a week. I...

Page 10 - MAINTENANCE; SHUNT ADJUSTMENT

MAINTENANCE 86038450 04/12/07 4-2ENG WEEKLY MAINTENANCE 1. Use a hydrometer to check the condition of each battery cell. 2. Check battery cable clamps. Ensure clamps are tight on battery terminals. 3. Clean tops of batteries with a wet cloth and a solution of water and baking soda. Wipe battery tops...

Page 11 - MAINTENANCE DAILY

LUBRICATION & SERVICE SCHEDULE 86038450 04/12/07 4-3ENG The following symbols found throughout the manual indicate items requiring lubrication: NOTES: SERVICE SCHEDULE MAINTENANCE DAILY MONTHLY Check batteries after charging; add water if necessary * Check pad wear to prevent buildup of chemical...

Page 12 - MACHINE TROUBLESHOOTING

MACHINE TROUBLESHOOTING 86038450 04/12/07 4-4ENG PROBLEM CAUSE SOLUTION No power to machine Poor Cable Connection Clean battery cable clamps of any corrosion and tighten. Test voltage at points G to B should be from 34 to 38 VDC. Faulty Main Power Switch With the main power switch turned on, test vo...