White 933R - Manuals

4 2 Section Assembly INTRODUCTION Please carefully follow these assemblysteps to properly prepare your machinefor use. We recommend that you readthis Section in its entirety before begin-ning assembly. NOTE: All references to left, right, frontand rear of the machine are determinedby standing behind...

5 Section 2: Assembly Contents of Hardware Bag (Parts are shown at actual size unless noted otherwise) Flat Washer, 5/16" Qty: 4 Cotter Pin, 3/32" x 5/8" Qty: 6 Hex Flange Lock Screw, 5/16"-18 x 3/4" Qty: 2 Shift Link - Gear Select Lever (shown reduced size) Qty: 1 Hex Flange Loc...

6 Section 2: Assembly C. Charge the Battery Charge a new battery for 24-48 hours toensure a full charge. If the mower mustbe used immediately, the battery mayhave enough of a charge to start the en-gine. If not, the engine can be startedwith the rope pull starter. NOTE: Chargethe battery after the i...

9 3 Section Features and Controls I M P O R T A N T : T H E M O W E R I S E Q U I P P E D W I T H A B L A D E - B R A K E -CLUTCH CONTROL SYSTEM WHICH ISD E S I G N E D T O S T O P T H E M O W E RBLADES WITHIN THREE (3) SECONDSA F T E R R E L E A S E O F T H E O P E R A T O RPRESENCE CONTROL. THIS S...

10 Section 3: Features and Controls Gear Select Lever Use this lever (C, Figure 3-1) to select any of four forward ground speeds (1 -Slow, 2 and 3 - Medium, 4 - Fast), N(Neutral) and R (Reverse). The gear shiftpattern is shown in Figure 3-2. To avoid damaging the transmis- sion, do not shift gears w...

11 Engine Throttle Control This lever (G, Figure 3-6) is used to adjust engine speeds and to stop the en-gine. Always run engine at fast speedsetting for best mower performance.The throttle settings are shown below. Ignition/Starter Switch - (Electric Start Model) This three-position switch (H, Figu...

12 4 Section Operation BEFORE OPERATING MOWER 1. Pre-Operation Checklist With the spark plug wire disconnectedfrom the spark plug, perform the follow-ing checks and services before each use: 1. Review Section 1: “Safety” and Section 3, “Features and Controls” in thisManual. Read the separate EngineO...

13 3. Test Blade-Brake-Clutch Control System The mower is equipped with a blade- brake-clutch which is designed to stopthe mower blades within three (3) seconds after release of the OperatorPresence Control or the Blade DriveControl. Never tamper with, or attemptto defeat the purpose of this safety ...

15 Section 4: Operation C. Put the Gear Select Lever (C, Figure 4- 2) in R (reverse) setting by first mov-ing lever to N (neutral). Then pulllever up, turn it to R position, and re-lease lever. D. To start the wheels, slowly squeeze Wheel Drive Control (D, Figure 4-2).To avoid sudden acceleration, s...

16 Section 4: Operation first, and then mow the bottom. Whenmowing ditches, watch out for cans,bottles, or other debris. BLADE BRAKE CONTROL TEST When the Operator Presence Control is released during operation of themower, the engine does not stop, but theblades should stop within three (3) sec-onds...

17 Carefully read this Section on mowerand engine maintenance and service.Performing the required maintenance ac-c o r d i n g t o s c h e d u l e w i l l e n s u r e t h eproper performance and long life of yourmachine. NOTE: All references to left, right, frontand rear of the machine are determine...

18 Section 5: Maintenance ENGINE CLEANING • Stop engine, wait for parts to stop moving, disconnect spark plug wire,and allow engine to cool before in-specting or cleaning engine. • Daily or more often, before running en-gine, remove grass and chaff from recoilfinger guard or rotating screen to preve...

19 ENGINE STORAGE If engine will be unused for 30 days ormore, prepare it for storage by followingthe recommended procedures found inthe Engine Owner’s Manual. MOWER SERVICE The following maintenance/repair proce-dures can be performed by either theowner or an authorized service dealer.See an author...

21 Section 5: Maintenance WARNING Before inspecting, cleaning or servicing the unit, shut off engine, wait for all parts to come to a complete stop, disconnect spark plug wire and move wire away from spark plug. Remove ignitionkey on electric start models. Failure to follow these instructions can re...

22 Section 5: Maintenance WARNING Before inspecting, cleaning or servicing the unit, shut off engine, wait for all parts to come to a complete stop, disconnect spark plug wire and move wire away from spark plug. Remove ignitionkey on electric start models. Failure to follow these instructions can re...

24 Section 5: Maintenance WARNING Before inspecting, cleaning or servicing the unit, shut off engine, wait for all parts to come to a complete stop, disconnect spark plug wire and move wire away from spark plug. Remove ignitionkey on electric start models. Failure to follow these instructions can re...

25 Section 5: Maintenance WARNING Before inspecting, cleaning or servicing the unit, shut off engine, wait for all parts to come to a complete stop, disconnect spark plug wire and move wire away from spark plug. Remove ignitionkey on electric start models. Failure to follow these instructions can re...

26 Section 5: Maintenance WARNING Before inspecting, cleaning or servicing the unit, shut off engine, wait for all parts to come to a complete stop, disconnect spark plug wire and move wire away from spark plug. Remove ignitionkey on electric start models. Failure to follow these instructions can re...

27 Section 5: Maintenance WARNING Before inspecting, cleaning or servicing the unit, shut off engine, wait for all parts to come to a complete stop, disconnect spark plug wire and move wire away from spark plug. Remove ignitionkey on electric start models. Failure to follow these instructions can re...

28 Engine does not turn over. Engine turns over but will not start. Engine starts only after repeated tries. Engine runs roughly. Engine stalls in a few seconds. Engine runs but unit does not move. Wheel drive always engaged. Engine stalls when hot. Engine overheats. Engine does not shut off. Blade ...

MANUFACTURER’S LIMITED WARRANTY FOR: For TWO YEARS from the date of retail purchase within the United States of America, its possessions a n d t e r r i t o r i e s , W h i t e O u t d o o r P r o d u c t s C o m p a n y w i l l , a t i t s option, repair or replace, for the original purchaser, free...