Whirlpool WRF767SDHV - Manuals

I N S T A L L A T I O N I N S T R U C T I O N S 5 LED Lighting The LED lights do not ever need to be replaced. MicroEdge ® Glo Shelves (on some models) Industry-exclusive MicroEdge ® Glo shelves make every snack stand out in your refrigerator. By moving LED lighting to a new spot under the shelves, ...

6 I N S T A L L A T I O N I N S T R U C T I O N S Location Requirements IMPORTANT: This refrigerator is designed for indoor, household use only. To ensure proper ventilation for your refrigerator, allow for a ¹⁄₂ " (1.25 cm) of space on each side and at the top. Allow for a 1" (2.54 cm) spac...

I N S T A L L A T I O N I N S T R U C T I O N S 7 Remove and Replace Refrigerator Doors NOTE: Measure the width of your door opening, to see whether or not you need to remove the refrigerator doors to move the refrigerator into your home. If door removal is necessary, see the following instructions....

8 I N S T A L L A T I O N I N S T R U C T I O N S Remove Right-Hand Refrigerator Door 1. Unplug refrigerator or disconnect power. 2. Keep the refrigerator doors closed until you are ready to lift them free from the cabinet. NOTE: Provide additional support for the refrigerator door while the hinges ...

I N S T A L L A T I O N I N S T R U C T I O N S 9 Style 2 - Firmly pull up on the clasp. Then, pull the tubing out of the fitting. NOTE: The water dispenser tubing remains attached to the left-hand refrigerator door. 3. Disconnect the wiring plug located on top of the door hinge. ■ Grasp each side o...

10 I N S T A L L A T I O N I N S T R U C T I O N S Remove and Replace Freezer Drawer Front Depending on the width of your door opening, it may be necessary to remove the freezer drawer front to move the refrigerator into your home. IMPORTANT: ■ If the refrigerator was previously installed and you ar...

I N S T A L L A T I O N I N S T R U C T I O N S 11 Electrical Requirements Before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection. Recommended Grounding Method A 115 volt, 60 Hz, AC only 15- or 20-amp fused, grounded electric...

12 I N S T A L L A T I O N I N S T R U C T I O N S Connect the Water Supply Read all directions before you begin. IMPORTANT: ■ Plumbing shall be installed in accordance with the International Plumbing Code and any local codes and ordinances. ■ The gray water tubing on the back of the refrigerator (w...

I N S T A L L A T I O N I N S T R U C T I O N S 13 3. Turn on water supply to refrigerator and check for leaks. Correct any leaks. Style 2 1. Unplug refrigerator or disconnect power. 2. Remove and discard the short, black plastic part from the end of the water line inlet. 3. Thread the nut onto the ...

14 I N S T A L L A T I O N I N S T R U C T I O N S 4. While holding the handle, insert the short end of the hex key into the upper hole and slightly rotate the hex key until it is engaged in the setscrew. 5. Using a clockwise motion tighten the setscrew just until it begins to contact the shoulder s...

I N S T A L L A T I O N I N S T R U C T I O N S 15 Refrigerator Leveling, Door Closing and Alignment The base grille covers the adjustable brake feet and roller assemblies located at the bottom of the refrigerator below the freezer drawer. Before making any adjustments, remove the base grille and mo...

16 F I L T E R S A N D A C C E S S O R I E S To Steady the Refrigerator: ■ Open the freezer drawer. Using a ¹⁄₄ " hex driver, turn both brake feet clockwise the same amount until the brake feet are snug against the floor. Check again. If not satisfied, continue to adjust the brake feet by half t...

F I L T E R S A N D A C C E S S O R I E S 17 ■ RESET the water filter status tracking feature. After you replace the disposable filter with a new filter, closing the filter compartment door will automatically reset the filter status tracking feature. See “Using the Control(s).” NOTE: “REPLACE FILTER...

18 F I L T E R S A N D A C C E S S O R I E S Models without notches: ■ Place the indicator somewhere it is easily visible - either inside the refrigerator, or elsewhere in your kitchen or home. Replacing the Air Filter The disposable air filter should be replaced every 6 months, when the status indi...

F I L T E R S A N D A C C E S S O R I E S 19 Installing the Status Indicator The produce preserver comes with a status indicator, which should be activated and installed at the same time the pouches are installed. 1. Place the indicator face-down on a firm, flat surface. 2. Apply pressure to the bub...

20 R E F R I G E R A T O R U S E Opening and Closing Doors There are two refrigerator compartment doors. The doors can be opened and closed either separately or together. There is a vertically-hinged seal on the left refrigerator door. ■ When the left-hand refrigerator door is opened, the hinged sea...

R E F R I G E R A T O R U S E 21 When Temperature mode is activated, press TEMP to toggle between Fridge and Freezer. The display will show the temperature set point of the selected compartment, and temperature adjusting information will appear on the display screen. Recommended Refrigerator Tempera...

22 R E F R I G E R A T O R U S E Fast Ice The Fast Ice feature assists with temporary periods of heavy ice use by increasing ice production. ■ To turn on the Fast Ice feature, press FAST ICE. When the feature is on, the Fast Ice icon will appear on the display. The Fast Ice feature will remain on fo...

R E F R I G E R A T O R U S E 23 Water and Ice Dispensers IMPORTANT: ■ Allow 3 hours for the refrigerator to cool down and chill water. ■ Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced. ■ The dispensing system will not operate when either the refrig...

24 R E F R I G E R A T O R U S E To Dispense Ice: 1. Select the desired type of ice. To switch between cubed ice and crushed ice, press ICE/WATER. 2. Press a sturdy glass against the dispenser paddle. Hold the glass close to the dispenser opening so ice does not fall outside of the glass. IMPORTANT:...

R E F R I G E R A T O R U S E 25 Style 1 - Ice Maker in the Refrigerator (on some models) The ice maker is located on the left-hand side of the refrigerator compartment ceiling. Ice cubes are ejected into the ice storage bin, located on the left-hand refrigerator door. Turn the Ice Maker On/Off 1. P...

26 R E F R I G E R A T O R F E A T U R E S Refrigerator Shelves The shelves in your refrigerator are adjustable to meet your individual storage needs. Storing similar food items together in your refrigerator and adjusting the shelves to fit different heights of items will make finding the exact item...

R E F R I G E R A T O R F E A T U R E S 27 To remove the crisper(s) cover: 1. Remove crisper drawers. 2. Holding the glass insert firmly with one hand, press up in center of glass insert until it rises above the plastic frame. Gently slide the glass insert forward to remove. 3. Lift the cover frame ...

28 R E F R I G E R A T O R F E A T U R E S Drawer Removal and Replacement To remove the drawer: 1. Push the drawer completely closed. 2. Lift up the front of the drawer and pull it straight out. To replace the drawer: 1. Push the metal glide rails to the rear of the refrigerator. 2. Place the drawer...

R E F R I G E R A T O R C A R E 29 Cleaning Both the refrigerator and freezer sections defrost automatically. However, clean both sections about once a month to avoid buildup of odors. Wipe up spills immediately. Exterior Cleaning Please see the exterior cleaning information specific to your model. ...

30 R E F R I G E R A T O R C A R E Condenser Cleaning There is no need for routine condenser cleaning in normal home operating environments. If the environment is particularly greasy or dusty, or there is significant pet traffic in the home, the condenser should be cleaned every 2 to 3 months to ens...

TR O U B L E S H O O T I N G 31 First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer to the warranty page in this manual and scan the code with your mobile device, or visit www.whirlpool.com/product_help . In Can...

32 TR O U B L E S H O O T I N G Noise To listen to normal refrigerator sounds, go to the Product Help/FAQ section of the brand website and search for “normal sounds.” The motor seems to run too much High efficiency compressor and fans Larger, more efficient refrigerators run longer at lower, more en...

TR O U B L E S H O O T I N G 33 Temperature and Moisture Popping Contraction/expansion of inside walls, especially during initial cool-down This is normal. Hissing/Dripping Flow of refrigerant, or flow of oil in the compressor This is normal. Vibration The refrigerator may not be steady Adjust the l...

34 TR O U B L E S H O O T I N G Ice and Water There is interior moisture buildup NOTE: Some moisture buildup is normal. The room is humid. A humid environment contributes to moisture buildup. The door(s) are opened often or not closed completely. Allows humid air to enter the refrigerator. Minimize ...

36 TR O U B L E S H O O T I N G Doors To view an animation showing how to adjust and align the doors, refer to the Product Help/FAQ section of the brand website and search for “door closing and door alignment.” The ice dispenser jams while dispensing crushed ice Crushed ice is blocking the ice deliv...

TROUBLESHOOTING 37 The doors are difficult to open The door gaskets are dirty or sticky. Clean gaskets and contact surfaces with mild soap and warm water. Rinse and dry with soft cloth. The doors appear to be uneven The doors need to be aligned, or the refrigerator needs to be leveled. See “Refriger...

38 P E R F O R M A N C E D A T A S H E E T Water Filtration System Model P9WB2L/P9RFWB2L Capacity 200 Gallons (757 Liters) This system has been tested according to NSF/ANSI Standards 42, 53, 401, and CSA B483.1 for the reduction of the substances listed below. The concentration of the indicated subs...