Page 2 - xi
Unless otherwise specified, all commercial cooking equip-ment manufactured by WELLS MFG. CO. is warranted against defects in materials and workmanship for a period of one year from the date of original installation or 18 months from the date of shipment from our factory, whichever comes first, and i...
Page 3 - MODELS; VOLTS; SPECIFICATIONS; -1HD) are built with the optional thermometer, and are electrically
WARRANTY xi SPECIFICATIONS 1 FEATURES & OPERATING CONTROLS 2 PRECAUTIONS & GENERAL INFORMATION 3 AGENCY LISTING INFORMATION 3 INSTALLATION 4 OPERATION 6 CLEANING INSTRUCTIONS 8 TROUBLESHOOTING SUGGESTIONS 9 MAINTENANCE INSTRUCTIONS 10 PARTS & SERVICE 11 CUSTOMER SERVICE DATA 11 Thank You...
Page 5 - PRECAUTIONS AND GENERAL INFORMATION; Hot Surface; Installation Instructions; AGENCY LISTING INFORMATION
This appliance is intended for use in commercial establishments only. This appliance is intended to prepare food for human consumption. No other use is recommended or authorized by the manufacturer or its agents. Operators of this appliance must be familiar with the appliance use, limitations and as...
Page 6 - UNPACKING & INSPECTION; Carefully read all instructions in this manual and the; SETUP; INSTALLATION
NOTE: DO NOT discard the carton or other packing materials until you have inspected the appliance for hidden damage and tested it for proper operation. Refer to SHIPPING DAMAGE CLAIM PROCEDURE on the inside front cover of this manual. WARNING: Risk of personal injury Installation procedures must be ...
Page 7 - ELECTRICAL
INSTALLATION (continued) 5 ELECTRICAL Refer to electrical specifications on page 1. Circuit must meet or ex-ceed the amperage and wattage requirements listed. 120 Volt units require a properly grounded NEMA 5-15R receptacle: 208/240 Volt units require a properly grounded NEMA 6-15R receptacle: WARNI...
Page 8 - OPERATING CHART FOR DRAWER WARMERS
HEATING OPTIONS 1. Moist heat with Humitrol Rack: a. MOIST operation prevents food from drying out as heat is applied to the warming chamber. b. To set for MOIST operation, remove the Humitrol Rack from bottom of drawer insert pan and carefully pour approximately 2 quarts of water (½” depth) into th...
Page 9 - NOT
OPERATION 1. Determine the type of food to be warmed. 2. Refer to the chart on page 6 to determine the type of heat required. 3. Set the air vent control for the type of heat, and rotate the thermostat knob to the temperature setting desired. 4. Allow warmer to pre-heat for approximately 30 minutes ...
Page 10 - CLEANING INSTRUCTIONS
CLEANING INSTRUCTIONS 8 PRECAUTIONS: Turn control knob to OFF. Allow drawers to cool before proceeding. Remove drawer pans and Humitrol racks. FREQUENCY: Minimum -Daily TOOLS: Warm water and mild detergent Clean cloth or sponge 1. Remove drawers from warmer: a. Pull warmer drawer out until fully ext...
Page 11 - TROUBLESHOOTING SUGGESTIONS; SYMPTOM
TROUBLESHOOTING SUGGESTIONS 9 SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY No lights or heat (all drawers) Warmer unplugged Plug warmer into appropriate receptacle Circuit breaker off or tripped Reset circuit breaker Internal damage Contact an Authorized Wells Service Agency for repairs. No heat (one dra...
Page 12 - ADJUSTMENTS AND LUBRICATION; Check slides on cabinet and drawers for cleanliness.
MAINTENANCE INSTRUCTIONS (continued) 10 ADJUSTMENTS AND LUBRICATION PRECAUTIONS: Turn control knob to OFF. Unplug warmer Allow drawers to cool before proceeding. Remove drawer pans and Humitrol racks FREQUENCY: Minimum - monthly. Every 2 weeks recommended. TOOLS: Screwdrivers, Phillips (+) and flat ...
Page 13 - CUSTOMER SERVICE DATA; VOLTAGE: (check one) 120 208 240
DESCRIPTION PART NO. HUMITROL RACK 20624 PAN, STAINLESS (ALL EXCEPT RWN) 21488 PAN, STAINLESS (RWN ONLY) 22228 LEG KIT, 4" PLASTIC (SET OF 4) 20314 LEG KIT, 4" METAL (SET OF 4) 20563 LEG KIT, 6" METAL (SET OF 4) 21607 CASTER KIT 10" HIGH (SET OF 4) 21034 CASTER KIT 3-1/2" HIGH (S...
Page 14 - Wells Manufacturing proudly supports CFESA
WELLS MANUFACTURING COMPANY DIVISION OF CARRIER REFRIGERATION 2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439 Customer Service (775) 345-0444 Ext.502 fax: (775) 345-0569 www.wellsbloomfield.com Wells Manufacturing proudly supports CFESA Commercial Food Equipment Service Association