Wells 8740 - Manuals

Wells 8740 – Manual in PDF format online.

Manuals:

Manual

Manual Wells 8740

Summary

Page 2 - WARRANTY STATEMENT; xi

608 p/n 7646 7 874 0 Tea B rewer Owners M anual NOTE: For your protection, please note that equipment in this shipment was carefully inspected and packaged by skilled personnel before leaving the factory. Upon acceptance of this shipment, the transportation company assumes full responsibility for it...

Page 3 - TABLE OF CONTENTS

This manual applies to the following Wells Bloomfield product: 8740 3 - 5 Gallon Tea Brewer MODEL DIMENSIONS VOLTS WATTS AMPS 1ø POWER SUPPLY CORD 8740 3 - 5 Gallon Iced Tea Brewer 34-1/4" high 11-1/4" wide 19-27/32" deep 120 1515 13 NEMA 5-15P TABLE OF CONTENTS SPECIFICATIONS Thank You ...

Page 4 - FEATURES AND OPERATING CONTROLS; Fig. 1 Model 8740 Features and Operating Controls

FEATURES AND OPERATING CONTROLS 2 Fig. 1 Model 8740 Features and Operating Controls 608 p/n 7646 7 874 0 Tea B rewer Owners M anual

Page 5 - PRECAUTIONS AND GENERAL INFORMATION; WARNING Electric Shock Hazard; AGENCY LISTING INFORMATION; AGENCY LISTING INFORMATION

PRECAUTIONS AND GENERAL INFORMATION 3 WARNING: Electric Shock Hazard All servicing requiring access to non-insulated components must be performed by qualified service personnel. Do not open any access panels which require the use of tools. Failure to heed this warn-ing can result in electrical shock...

Page 6 - INSTALLATION; READ THIS CAREFULLY BEFORE STARTING THE INSTALLATION; POTABLE WATER, COLD; line. Flush water line before connecting to Brewer.; EQUIPMENT DAMAGE; Water supply inlet line

INSTALLATION 4 READ THIS CAREFULLY BEFORE STARTING THE INSTALLATION Unpack the unit. Inspect all components for completeness and condition. Ensure that all packing materials have been removed from the unit. Verify that the Spray Head Gasket and Spray Disk are properly installed. PLUMBER’S INSTALLATI...

Page 7 - WARNING; SHOCK HAZARD; ELECTRICIAN’S INSTALLATION INSTRUCTIONS; ON; Fig. 3 Plug Configuration

INSTALLATION (continued) 5 WARNING SHOCK HAZARD Brewer must be properly grounded to prevent possible shock hazard. DO NOT assume a plumbing line will provide such a ground. Electrical shock will cause death or serious injury. IMPORTANT: Supply power must match nameplate for voltage and phase. Connec...

Page 8 - OPERATION; Fig. 4 Brewer Operation Diagram; NOT COVERED BY

OPERATION Fig. 4 Brewer Operation Diagram A. START-UP For initial start-up, or if the brewer has not been used for an extended period of time: ♦ Be sure spray disk and brew gasket are properly installed in the brew head. ♦ Be sure the water supply is properly connected and the water supply valve is ...

Page 9 - WATER HEATER; Fig. 6 Water Flow Diagram

OPERATION (continued) WATER HEATER Water temperature is sensed by a thermobulb inserted into the water tank. This temperature signal is fed to the mechanical thermostat. The temperature setpoint is adjustable. Heating element is energized by the thermostat. Excessive temperature will trip the hi-lim...

Page 10 - BREWING TEA; EMPTY; BURN HAZARD; Fig. 7 Tea Brew Chamber

BREWING TEA 8 A. PREPARATION Place one (1) genuine Bloomfield paper filter into the brew chamber. Add an amount of fresh tea leaves to the brew chamber appropriate to the brew volume. NOTE: the brewer can brew any volume between 3 and 5 gallons, and is factory set for a 3 gallons brew volume. If oth...

Page 11 - INSIDE

CLEANING INSTRUCTIONS PROCEDURE: Clean Tea Brewer PRECAUTIONS: Disconnect brewer from electric power. Allow brewer to cool. FREQUENCY: Daily TOOLS: Mild Detergent, Clean Soft Cloth or Sponge Bristle Brush, Bottle Brush 1. Disconnect brewer from electric power. Allow brewer to cool before cleaning. 2...

Page 12 - TROUBLESHOOTING SUGGESTIONS; SUGGESTED REMEDY

TROUBLESHOOTING SUGGESTIONS SUGGESTED REMEDY Check power supply cord Check / reset circuit breaker Press switch to ON Set for desired temperature Allow to cool hi-limit will self-reset Examine wiring & connectors, controller, power board and heating element Repair/replace as needed Adjust timer ...

Page 13 - SERVICING INSTRUCTIONS; ACCESS PLUGS

SERVICING INSTRUCTIONS CAUTION: SHOCK HAZARD Opening access panels on this brew may expose uninsulated electrical components. Disconnect brewer from electrical power before removing any panel. NOTE ; Time and temperature controls may be accessed without removing cabinet panels by removing the approp...

Page 14 - TEMPERATURE ADJUSTMENT; Table 1 Boiling Temperature by Altitude; Optimum brewing

SERVICING INSTRUCTIONS (continued) 12 TEMPERATURE ADJUSTMENT Energize brewer and allow unit to heat. When the READY TO BREW light first glows, read the temperature. Thermostat may be adjusted by removing the right button plug. Carefully check the water temperature at the outlet of the brew chamber. ...

Page 15 - SOLENOID TIMER ADJUSTMENT; REPLACE THERMOSTAT; REPLACE HEATING ELEMENT; Fig. 11 Adjust Solenoid Timer

SERVICING INSTRUCTIONS (continued) IMPORTANT: Water pressure must be between 20 p.s.i and 90 p.s.i. flowing pressure. If water pressure exceeds this value, or if water pressure varies greatly, a pressure regulator must be installed in the water supply line. IMPORTANT: Before setting assembly into ta...

Page 17 - PROCEDURE: Delime the Water Tank

SERVICING INSTRUCTIONS (continued) 15 CAUTION: CHEMICAL BURN HAZARD Deliming chemicals are caustic. Wear appropriate protective gloves and goggles during this procedure. Never siphon deliming chemicals or solutions by mouth. This operation should only be performed by qualified and experienced servic...

Page 18 - EXPLODED VIEW & PARTS LIST

EXPLODED VIEW & PARTS LIST 16 608 p/n 7646 7 874 0 Tea B rewer Owners M anual 42 1 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 2 18 19 20 21 22 24 23 25 26 27 28 29 31 32 33 34 35 36 37 38 39 40 41 43 44 BLOOMFIELD 29 Model 8740

Page 20 - SERVICE KITS; Inlet

SERVICE KITS 18 SERVICE KITS SOLENOID REPAIR KITS 83282 Solenoid, Complete, Dual 85218 Inlet Fitting Kit (includes cap, inlet fitting, washer and screen) 85219 Inlet Strainer 608 p/n 7646 7 874 0 Tea B rewer Owners M anual

Page 21 - WIRING DIAGRAM

WIRING DIAGRAM 19 608 p/n 7646 7 874 0 Tea B rewer Owners M anual

Page 22 - Genuine Parts; Wells Bloomfield proudly supports CFESA; WELLS BLOOMFIELD, LLC

Genuine Parts Protect - YOU - All - Ways SERVICE TRAINING - QUALITY SERVICE SERVICE TRAINING - QUALITY SERVICE CUSTOMER SATISFACTION CUSTOMER SATISFACTION Wells Bloomfield proudly supports CFESA Commercial Food Equipment Service Association Commercial Food Equipment Service Association PRINTED IN UN...