Weber Built In LP Side Burner - Manuals

5 MOUNTING THE SIDE BURNER Connect the corrugated gas line to the side burner valve located on the back right hand side of side burner. TEST CONNECTIONS All connections and joints must be thoroughly tested for leaks in accordance with local codes and all listed procedures in the latest edition of AN...

6 TYPICAL BULK PROPANE GAS SUPPLY INSTALLATION We recommend that this installation be done by a LICENSED professional.General Specifi cations for PipingNote - Contact your local municipality for building codes regulating outdoor gas grill installations. In absence of Local Codes, you must conform to...

7 TYPICAL 20 LP PROPANE GAS SUPPLY INSTALLATION We strongly recommend that you use the Summit ® Built-In Tank Cabinet (#21280) for installations using a 20 lb LP cylinder, mounted remotely in an “island” structure.The Summit ® Built-In Tank Cabinet is a CSA listed accessory for installing a remote m...

8 3). The minimum size of the ventilation hole (s) should not be less than 1/4 inch. d). The remote LP cylinder enclosure should be constructed with non- combustible materials. The remote LP cylinder enclosure should isolate the LP cylinder from the burner compartment, so that it provides shielding ...

10 To Connect the hose to the cylinder: 3) Remove the plastic dust cover from the valve. 4) Screw the regulator coupling onto the tank valve, clockwise, or to the right. Hand-tighten only. Note: This connection tightens clockwise and will not allow gas to fl ow unless the connection is tight. The co...

11 Check: 3) “T” Connection-to-Hose connections. 4) The hose-to-Regulator connection. WARNING: If there is a leak at connections (2,3, or 4), turn OFF the gas. DO NOT OPERATE THE GRILL. Contact Customer Service 1-800-446-1071. When leak checks are complete, turn gas supply OFF at the source and rins...

12 LIGHTING THE SIDE BURNER. 1) Open the side burner lid. 2) Check that the side burner valve is turned OFF. (Push knob in and turn clockwise to ensure that it in the off position.) WARNING: The burner control knob must be in the OFF position before turning on the liquid propane cylinder valve. If i...

13 CROSSOVER ® IGNITION SYSTEM OPERATIONS If the Crossover ® ignition system fails to ignite the LEFT burner in a burner set, light the LEFT burner with a match. If the LEFT burner lights with a match, then check the Crossover ® ignition system. • Check that both ignition wires(1,2) are attached pro...

14 SIDE BURNER MAINTENANCE WARNING: All gas controls and supply valves should be in the OFF position. Make sure wire is connected between the igniter and electrode. Spark should be a white/blue color, not yellow. 1) Igniter Wire 2) Burner (3) Side Burner Grate Side Burner Cap Side Burner Ring & ...

15 ATTENTION: This product has been safety tested and is only certifi ed for use in a specifi c country. Refer to country designation located on outer carton. These parts may be gas carrying or gas burning components. Please contact Weber-Stephen Products Co., Customer Service Department for genuine...