Wayne Dalton 346919 - Manuals

Page 2 - Parts Breakdown

2 Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com A. FLAgANgLES: A1. Fully Adjustable (F.A.) Flagangles...

Page 3 - Important Safety Instructions; WARNINg; Tools Required

Important Safety Instructions DEFINITION OF kEy WORDS uSED IN THIS MANuAL: WARNINg WARNINg INDICATES A POTENTIALLy HAzARDOuS SITuATION WHICH; IF NOT AvOIDED, COuLD RESuLT IN SEvERE OR FATAL INJuRy. CAuTION: PROPERTY DAMAGE OR INJURY CAN RESULT FROM FAILURE TO FOLLOW INSTRUCTIONS. IMPORTANT: REQUIRED...

Page 4 - Door Section Identification; Removing an Existing Door; A POWERFuL SPRINg RELEASINg ITS ENERgy SuDDENLy CAN CAuSE SEvERE; Preparing the Opening

5/16” x 1 5/8” Hex head lag screws (as required) (4) 1/4”-20 x 5/8” Carriage bolts 1/4”-20 x 9/16” Track bolts (as required) 1/4”-14 x 5/8” Self tapping screws (as required) (2) 3/8”-16 x 3/4” Truss head bolts 3/8”-16 x 1-1/2” Hex bolts (2) 3/8”- 16 Hex nuts 1/4”- 20 Flanged hex nuts (as required) 1...

Page 6 - InstallatIon; quick Install Flag Angles; Fully Adjustable Jamb Brackets

InstallatIon Before installing your door, be certain that you have read and followed all of the instruc- tions covered in the pre-installation section of this manual. Failure to do so may result in an improperly installed door. NOTE: Reference TDS 160 for general garage door terminology at www.dasma...

Page 7 - Pull Handles; Bottom Corner Brackets; FAILuRE TO ENSuRE TIgHT FIT OF CABLE LOOP OvER MILFORD PIN COuLD

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com hole onto the center stile. Drill 1/16” pilot holes at ...

Page 10 - Adjusting Top Fixtures; End Bearing Brackets

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com Top section Top section Nail Door width + 3-3/8” to 3-1...

Page 11 - Center Bracket Bushing Assembly; Torsion Spring Assembly; Torsion Spring Attachment

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com Left end bearing bracket Top section (3) 5/16” x 1-5/8”...

Page 12 - Counterbalance Lift Cables; Winding Springs

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com Center bracket bushing assembly Stationary spring cone ...

Page 13 - Rear Back Hangs

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com Torsion shaft Winding cone Spring Approved winding rods...

Page 15 - Door Arm Hookup; Inside Lock; Pull Down Rope; DO NOT INSTALL PuLL DOWN ROPE ON DOORS WITH OPERATORS. CHILDREN; optional Installation

Door Arm Hookup Tools: Needle nose pliers Align hole in the door arm with holes in drawbar operator bracket tabs, as shown. Insert 5/16” x 1-1/4” clevis pin, making sure hole in clevis pin is outside of second tab of drawbar operator bracket. Insert hairpin cotter into clevis pin hole and spread hai...

Page 16 - TACHED TO THE SPRINgS ARE uNDER ExTREME TENSION, AND IF HANDLED; Maintenance

Cleaning Your Garage Door IMPORTANT: DO NOT USE A PRESSURE WASHER ON YOUR GARAGE DOOR! While factory-applied finishes on garage doors are durable, it is desirable to clean them on a routine basis. Some discoloration of the finish may occur when a door has been exposed to dirt-laden atmosphere for a ...

Page 17 - SCREWS ON THE COuNTERBALANCE (END OR CENTER BEARINg BRACkETS)

WARNINg WARNINg NEvER REMOvE, ADJuST, OR LOOSEN THE BOLTS, SCREWS AND/OR LAg SCREWS ON THE COuNTERBALANCE (END OR CENTER BEARINg BRACkETS) SySTEM OR BOTTOM BRACkETS OF THE DOOR. THESE BRACkETS ARE CON- NECTED TO THE SPRINg(S) AND ARE uNDER ExTREME TENSION. TO AvOID POSSIBLE SEvERE OR FATAL INJuRy, H...

Page 18 - Lifetime Limited Warranty; for as long as you own the door; warranty

Lifetime Limited Warranty Model 6100 Subject to the terms and conditions contained in this Lifetime Limited Warranty, Wayne-Dalton (“Manufacturer”) warrants the steel sections of the door, which is described at the top of this page, for as long as you own the door against: i) The door becoming inope...

Page 20 - Please Do Not Return This Product To The Store; thank you for your purchase.; Find a Dealer; section online at

after InstallatIon Is coMPlete, fasten thIs Manual near the garage door. Please Do Not Return This Product To The Store thank you for your purchase. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local yellow pages business listings or go to the Find a ...