Vermont Casting VCS4017 - Manuals

B. SAFE USE OF LP (PROPANE) GAS C. SAFE USE OF NATURAL GAS Always store your spare Propane Gas Cylinders in an outdoor area that is well-ventilated, shady, cool andremoved from any heat source. Always store those cylinders in an upright position. Never store a sparecylinder in the vicinity of this G...

D. PREVENTION OF BURNS E. ELECTRICAL SAFETY Page v Always promptly shut off the gas supply and immediately extinguish all flames if you smell gas. Always seekassistance from your gas supplier or local Fire Department if the gas smell persists, because of the danger offire or explosion. Always confir...

FUELS WARNING: WARNING: Never use Natural Gas in a Grill that has been configured to burn Propane Gas, and never use Propane Gas in a Grill that has been configured to use Natural Gas, to avoid possible bodily injury. Alwaysconsult the Rating Label on the back of your Grill to confirm which fuel mus...

DANGER: ADDITIONAL WARNINGS: a) Do not store a spare LP - Gas Cylinder under or near this applianceb) Never fill the cylinder beyond 80% full; andc) If the information in a) and b) is not followed exactly, a fire causing death or serious injury may occur. WARNING: Always confirm that the openings in...

Page 4 Fig. 5 Gas Hookup Hooking Up to the LP (Propane) Gas Supply FOR YOUR SAFETY LP (PROPANE) GAS SUPPLY CONNECTION WARNING: CAUTION: 1. 2. 1. 2. 3. Always conduct a leak test before lighting the Grill, to prevent a possible fire or explosion (see page 5). For connection of an LP gas grill to a fi...

NATURAL GAS SUPPLY CONNECTION TO CONNECT: TO DISCONNECT: TESTING FOR GAS LEAKS WARNINGS: 1. 2.3. 1. (for LP and Natural Gas) Before attempting to operate this Grill:1.2.3. 4. 5.6. Page 5 Push back the Sleeve on the Socket as shown below(see Fig. 6a).Insert Plug and release the Sleeve (see Fig. 6b).P...

CONTROL FUNCTIONS PROPANE TANK VALVE WARNING: BURNER CONTROL VALVES ACTIVATING THE IGNITER ELECTRONIC IGNITION SYSTEM PIEZO IGNITION SYSTEM Never open the Tank Valve unless the Grill is being prepared for use, to prevent the pooling of propane vapor.Always open the Valve immediately before lighting ...

LIGHTING THE MAIN BURNERS WARNING: WARNING: IF THE SELECTED BURNER DOES NOT LIGHT, 1. Never stand with your head directly over the Grill when preparing to light the main burners, to prevent possiblebodily injury. 2. 3. 4. 5. immediately turn the burner control knob to the OFF position, to prevent ga...

Page 8 Operation TURNING THE BURNERS OFF FLARE-UPS MATCH LIGHTING THE MAIN BURNERS: WARNING: 1.2.3. “Flare-ups” sometimes occur when food drippings fall onto the hot sear plates or burners and ignite. Someflaring is normal and desirable, as it helps impart the unique flavors associated with grilled ...

Page 10 Operation ROTISSERIE SETUP WARNING: (if equipped) The Rotisserie burner is intended to be used for rotisserie cooking only. Never use the main burners while using the Rotisserie burner, as that could result in igniting the drippings, or overheating your Grill, which could result in damage of...

Fig. 13 Control knob Igniter LIGHTING THE SIDE BURNER WARNING: NOTE: SHUTTING THE BURNER OFF (if equipped) Never stand with your head directly over the Grill when preparing to light the side burner, to prevent possible bodily injury. 1. 2. Observe the flame pattern. Soft blue flames are normal ; har...

Page 22 Troubleshooting Guide PROBLEM Burner will notlight Unit won’t heatup (LP) Unit won’t stay lit POTENTIAL CAUSE Gas supply turned off Out of propane Blockage in the gas system Misalignment of the gas valve to theventuri tubes of the burner. Improper attachment of the propanehose and regulator ...

50004062 11/06 Rev.0 En Page 1 Tools Required: knife or scissors, Phillips or Robertson (square head) screwdriver.. VCS4007 / VCS4017 / VCS4027 / VCS4037VCS5007 / VCS5017 / 27 37 ASSEMBLY PROCEDURES VCS50 / VCS50 Model VCS4007 Shown Step 1: Unpack Carton and Verify Contents CAUTION: Use a sharp cutt...