Page 3 - OFF; This appliance has been approved for; PLEASE REVIEW THE FOLLOWING CAREFULLY
10002789/0 -3- DBT33/DBT36/DBT39 This gas replace should be installed by a qualied installer in accordance with local building codes and with current CAN /CGA-B149 (. 1 or .2) Installation codes for Gas Burning Fireplaces and Equipment. FOR U.S.A Installations follow local codes and/or the current...
Page 4 - Appliance Dimensions
DBT33/DBT36/DBT39 -4- 10002789/0 A PPLIANCE D IMENSIONS Appliance Dimensions Ref. DBT33 DBT36 DBT39 A 838 mm (33") 914 mm (36") 991 mm (39") B 733 mm (28.87") 870 mm (34.25") 870 mm (34.25") C 416 mm (16.37") 533 mm (21") 533 mm (21") D 787 mm (31") 838 mm (33...
Page 7 - EMOTE; Installation
10002789/0 -7- DBT33/DBT36/DBT39 G AS L INE I NSTALLATION When purging the gas lines, the front glass must be removed. The gas pipeline can be brought in through the rear of the replace as well as the bottom. Knockouts are provided on the bottom behind the valve to allow for the gas pipe installati...
Page 8 - LP; SIT Top Convertible Pilot
DBT33/DBT36/DBT39 -8- 10002789/0 C ONVERTING T HE A PPLIANCE F ROM LP TO N ATURAL G AS OR N ATURAL G AS TO LP. The DBT33 is convertible between Natural Gas an LP gas (and vice-versa) with the use of a conversion kit purchased seperately, see your dealer for the correct part number. The DBT36 & 3...
Page 9 - Location of Vent Termination; ENERAL
10002789/0 -9- DBT33/DBT36/DBT39 A = clearance above grade, veranda, porch, deck, or bal- cony [* 12 inches (305mm) minimum] B = clearance to window or door that may be opened [12" (306mm)]. C = clearance to permanently closed window [minimum 12 inches (305mm) recommended to prevent condensation...
Page 11 - DV C; Crimped End Pipes
10002789/0 -11- DBT33/DBT36/DBT39 H OW T O U SE T HE V ENT G RAPH The vent chart should be read in conjunction with the follow- ing vent installation instructions to determin the relationship of the vertical and horizontal dimensions of the vent system1. Determine the height of the centre of the hor...
Page 13 - COMBUSTIBLE WALLS
10002789/0 -13- DBT33/DBT36/DBT39 V ERTICAL S IDEWALL I NSTALLATIONS STEP 1 Locate vent opening on the wall. It may be necessary to rst position the replace and measure to obtain hole location. Depending on whether the wall is combustible or non-combus- tible, cut opening to size. (Fig. 22) (For c...
Page 15 - ERTICAL
10002789/0 -15- DBT33/DBT36/DBT39 DO NOT BACK FILL AROUND SNORKEL. A CLEARANCE OF AT LEAST 4” MUST BE MAINTAINED BETWEEN THE SNORKEL AND THE SOIL If the foundation is recessed, use recess brackets (not supplied) for securing lower portion of the snorkel. Fasten brackets to wall rst and then secure ...
Page 16 - Fitting The Restrictor Plate
DBT33/DBT36/DBT39 -16- 10002789/0 • 7DVCS must be used to support offsets. (Fig. 36)This application will require that you rst determine the roof pitch and use the appropriate starter kit. (See Venting Components List) • The minimum height of the vent above the highest point of penetration through ...
Page 20 - Burner and Burner Compartment; Brass Trim
DBT33/DBT36/DBT39 -20- 10002789/0 G ENERAL O PERATING I NSTRUCTIONS G LASS I NFORMATION Only glass approved by CFM Majestic Inc. should be used on this replace. • The use of any non-approved replacement glass will void all product warranties. • Care must be taken to avoid breakage of the glass.• Un...
Page 21 - Log Identication Chart; Location
10002789/0 -21- DBT33/DBT36/DBT39 I NSTALLATION OF L OGS & L AVA R OCK Refer to the log identication chart to identify specic log numbers. 1. Remove the front glass / frame assembly.2. Remove the logs from their packaging. The logs are fragile and should be handled with care. Keep the packagin...
Page 23 - TO TURN OFF GAS TO FIREPLACE; LIGHTING AND OPERATING INSTRUCTIONS
10002789/0 -23- DBT33/DBT36/DBT39 LIGHTING INSTRUCTIONS 3. Open control access panel. 4. Push in gas control knob slightly and turn clock- wise to "OFF". Do not force. 5. Close control access panel. 10. Push the control knob all the way in and hold. Immediately light the pilot by repeatedly ...
Page 24 - TROUBLE SHOOTING THE GAS CONTROL SYSTEM; HONEYWELL MILLIVOLT VALVE
DBT33/DBT36/DBT39 -24- 10002789/0 TROUBLE SHOOTING THE GAS CONTROL SYSTEM HONEYWELL MILLIVOLT VALVE
Page 25 - SIT NOVA 820 MILLIVOLT VALVE; SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
10002789/0 -25- DBT33/DBT36/DBT39 TROUBLE SHOOTING THE GAS CONTROL SYSTEM SIT NOVA 820 MILLIVOLT VALVE Note: Before trouble shooting the gas control system, be sure external gas shut off is in the "On" position. WARNING: BEFORE DOING ANY GAS CONTROL SERVICE WORK, REMOVE GLASS FRONT. SYMPTOM ...
Page 26 - Items marked ‘*’ are not shown in the following parts pictorial page.
DBT33/DBT36/DBT39 -26- 10002789/0 R EPLACEMENT P ARTS L IST Items marked ‘*’ are not shown in the following parts pictorial page. Ref. Description DBT33 DBT36 DBT39 1 Log Set (complete) 10000470 10000023 10000024 1a Log - Front left BA2 BB6 BC5 1b Log - Front right BA3 BB7 BC6 1c Log - rear BA4 BB8 ...
Page 30 - Method A; Maintenance
DBT33/DBT36/DBT39 -30- 10002789/0 W IRING I NSTRUCTIONS The replace, when installed, must be electri- cally connected and grounded in accordance with local codes or, in the absence of local codes, with the current CSA C22.1 Canadian Electric Code. For U.S.A. installations follow the local codes and...
Page 32 - Model Function/s Controlled
DBT33/DBT36/DBT39 -32- 10002789/0 D ECORATIVE B AY W INDOWS Bay window kits are available for the DBT33, DBT36 & DBT39 model appliances. When tting the Bay Window Kits the original front frame/glass assembly MUST remain in place. The Bay Window kit is tted over the existing front glass. Instal...
Page 34 - LIMITED WARRANTY & EXTENDED LIFE TIME PROTECTION; For Gas Appliance Products*
DBT33/DBT36/DBT39 -34- 10002789/0 410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 • 905-670-7885 www.vermontcastings.com CFM Majestic, Inc. © Copyright CFM Majestic, Inc. BASIC WARRANTY: The CFM Majestic, Inc.™ (hereinafter referred to collectively as the "Company") warrants that yo...