Vermont Casting 1695CE - Manuals

5 Vermont Castings Intrepid Multi-Fuel 2000970 Masonry Chimneys An inspection of the chimney must confirm that it has a lining. Do not use an unlined chimney. The chimney should have no cracks, loose mortar, other signs of deterioration, or blockage. Repair any defects before using the chimney with y...

6 Vermont Castings Intrepid Multi-Fuel 2000970 the stove and chimney. Using connectors and chim-neys from the same manufacturer makes the assembly and installation straightforward. NOTE: For installations using double-wall con-nectors, minimum clearances must conform to the listed clearances in the ...

7 Vermont Castings Intrepid Multi-Fuel 2000970 Fireplace Chimney Installations - Through a Fireplace If your fireplace height is at least 635 mm (25”), you may install an Intrepid Multi-fuel with standard legs through the fireplace opening using a 90° Tee kit avail-able from your local dealer. This po...

8 Vermont Castings Intrepid Multi-Fuel 2000970 Hearths This appliance must be installed on to hearth that meets the requirements of Part J of the Building Regu-lations 2000 (Combustion Appliances and Fuel Storage Systems). This can be achieved by ensuring that the hearth is constructed and sized in ...

9 Vermont Castings Intrepid Multi-Fuel 2000970 Costructional Hearth Dimensions as below At least 300 mm At least 150 mm or to a suitable heat resistant wall At least 150 mm Hearth Surface Free of Com- bustible Material Perimeter should be clearly marked e.g. edge of superimposed hearth Perimeter sho...

10 Vermont Castings Intrepid Multi-Fuel 2000970 Connecting Flue Pipe - Clearances Single wall connecting fluepipes can reach extremely high temperatures; therefore, clearances from the con-necting fluepipe (chimney connector) must comply with the requirements of Part J of Building Regulations 2000 (Co...

11 Vermont Castings Intrepid Multi-Fuel 2000970 Clean the Griddle Before Use At the factory we coat the griddle with vegetable oil to prevent rusting while the stove is in transit and storage. Remove the oil with a dry rag or paper towel before you use the stove. Set Up the Stove Remove the griddle,...

12 Vermont Castings Intrepid Multi-Fuel 2000970 ST516 Attach griddle handle 11/17/00 djt ST516 Fig. 16 Attaching the griddle handle. ST517 Intrepid II Thermostat positions 11/17/00 djt High Heat Low Heat ST517 Fig. 18 The thermostat handle may be positioned anywhere between the two extremes for diff...

13 Vermont Castings Intrepid Multi-Fuel 2000970 ST519 Intrepid II damper 11/20/00 djt Open (Updraft Mode) Closed (Bypass Mode) ST519 Fig. 19 The damper is either open or closed. There are no intermediate positions. Side View The damper has no intermediate positions. When closing the damper, push firm...

14 Vermont Castings Intrepid Multi-Fuel 2000970 Use the Air Control Settings that Work Best for You No single air control setting will fit every situation. Set-tings will differ depending on the quality of the fuel, the amount of heat desired, and how long you wish the fire to burn. The control settin...

15 Vermont Castings Intrepid Multi-Fuel 2000970 Once the draft is established, open the front door and light the rest of the fuel from the bottom. Do not light the main bed of fuel until the chimney begins drawing, and repeat the procedure as often as necessary if the initial attempt is unsuccessful...

16 Vermont Castings Intrepid Multi-Fuel 2000970 Draft Management A stove is part of a system, which includes the chimney, the operator, the fuel, and the home. The other parts of the system will affect how well the stove works. When there is a good match between all the parts, the system works well....

17 Vermont Castings Intrepid Multi-Fuel 2000970 - so use whatever combination of installation features and operational steps will encourage good draft and minimize creosote production.Because letting the smoke cool off and slow down is one of the keys to creosote production, it makes sense to line a...

18 Vermont Castings Intrepid Multi-Fuel 2000970 Place the gasket in its channel; make sure that its outer edge fits against the cast iron surround ridge. 3. Install the glass. Lay the glass on the inner gasket with the coated side down (toward the outside of the door). Tighten the screws snugly, but ...

19 Vermont Castings Intrepid Multi-Fuel 2000970 How to Adjust the Door Latch Over time, the gasketing around the doors will com-press, and the latch may need adjustment. To adjust the latch, loosen the small locking nut, extend the striker screw one turn while keeping the striker screw from turning....

20 Vermont Castings Intrepid Multi-Fuel 2000970 7. For doors, replace the doors and close them on a piece of waxed paper to keep the cement from migrating onto the stove front, or tap other parts with the rubber mallet (or hammer/block of wood). 8. Clean excess cement from around the channel. Let th...

21 Vermont Castings Intrepid Multi-Fuel 2000970 Stove Serial No. __________________________ Dealer _________________________________ ________________________________________ ________________________________________ Phone __________________________________ Date Purchased __________________________ In...

22 Vermont Castings Intrepid Multi-Fuel 2000970 1 2 3 4 5 6 7 8 9 10 12 13 20 21 22 23 24 9 25 26 29 30 28 27 25 50 51 52 53 54 16 11 12 9 55 0970 Intrepid Multi-fuel 1695 8/02 35 49 45 45 46 56 56 14 57 0970 CFM Corporation reserves the right to make changes in design, materials, specifications, pri...

24 Vermont Castings Intrepid Multi-Fuel 2000970 Intrepid Multi-Fuel Heater Model 1695CE (continued) Shell Enamel Parts - Intrepid Multi-Fuel Model 1695CE Part Name Classic Green Red Top 1308657 2318657 2328657 Bottom 1306764 2316764 2326764 Left Side 1308656 2318656 2328656 Front 1308647 2318647 232...

27 Vermont Castings Intrepid Multi-Fuel 2000970 Exclusions & Limitations 1. This warranty is transferable; however, proof of original retail pur- chase is required. 2. This warranty does not cover misuse of the stove. Misuse includes overfiring which will result if the stove is used in such a man...

2695 Meadowvale Blvd. • Mississauga, Ontario, Canada L5N 8A3 800-668-5323 • www.cfmcorp.com CFM Corporation