Vector VEC013DB - Manuals - manualsarea.com

Page 2 - SAFETY INFORMATION; is available in case of accident or emergency.

1 SAFETY INFORMATION WARNINGS: 1. When working with lead-acid batteries, always make sure immediate assistance is available in case of accident or emergency. 2. Always use protective eyewear when using this product: contact with battery acid may cause blindness and/or severe burns, be aware of first...

Page 3 - SAVE THESE INSTRUCTIONS

2 3. Never insert anything other than the supplied power/recharging cords or recommended appliance power/recharging cords into the 12 volt DC charging/power socket on this unit. Do not use any accessory that is not recommendedor provided by the manufacturer. 4. Do not use this unit to operate applia...

Page 4 - INTRODUCTION; Jump start any engine system with a standard 12 volt DC battery:

INTRODUCTION Congratulations on selecting the Durabilt Jump-Start System. This compact jump-starter is unique in the amount of energy it can supply for its size. The internal batteryis a high-density sealed, lead-acid battery that stores and delivers energycomparable to full sized ordinary jump-star...

Page 5 - Clamp Holder Tabs; ADDITIONAL FEATURES; Automatic taper charge for AC recharge

4 FIGURE 1A (Front Panel View) FIGURE 1B (Rear View) 1. 12 Volt DC Accessory Socket for DC appliances (with overload protection)2. Battery Level Status Pushbutton3. LED Charging/Battery Level Indicators4. ON/OFF Power Switch5. Recharging Port6. Area Light7. Area Light ON/OFF Switch 8. Negative (Blac...

Page 6 - JUMP STARTING INSTRUCTIONS; working on a vehicle’s battery system.

5 JUMP STARTING INSTRUCTIONS Connect – Red clamp first, then black clamp. Disconnect – Black clamp first, then red clamp. 1. Turn OFF vehicle ignition and all accessories (radio, A/C, lights, cell phone, etc.). Place vehicle in “Park” and set the emergency brake. 2. Make sure jump-start system’s ON/...

Page 7 - unit from direct sunlight, direct heat and moisture.

6 6. Always disconnect the engine or frame jumper clamp first; followed by the battery jumper clamp. 7. Never allow red and black clamps to touch each other or another common metal conductor; this could cause damage to the unit and/or create sparking/explosion hazard. 8. There is a risk of explosive...

Page 8 - • Keep out of children’s reach.

7 WARNING: • Always use protective eyewear when using this product: contact with battery acid may cause blindness and/or severe burns. • Keep out of children’s reach. FIRST AID:SKIN: If battery acid comes in contact with skin, rinse immediately with running water, then wash thoroughly with soap and ...

Page 9 - STARTER OUTLET” into recharging port on the front panel of the unit.; CAUTION: DO NOT USE THIS UNIT TO OPERATE APPLIANCES THAT; • Do not expose battery to fire or intense heat as it may explode

12 V OLT DC C HARGING 1. Insert the plug that is marked “TO VEHICLE ACCESSORY OUTLET” of the DC/DC charging adapter into the 12 volt DC accessory receptacle on the vehicle or boat. 2. Insert the plug at the other end of this charging adapter marked “TO JUMP STARTER OUTLET” into recharging port on th...

Page 10 - CAUTION: THIS PLUG USES AN 8 AMP FUSE. FOR CONTINUED; EPLACE; counterclockwise and lifting off.; SPECIFICATIONS

9 Battery Disposal: This unit contains a maintenance-free, non-spillable, sealed lead-acid battery. This battery is fully recyclable and should beaccepted at any location that accepts common automotive starterbatteries. Examples of places that accept these batteries are:County or municipal recycling...

Page 11 - YEAR LIMITED WARRANTY PROGRAM; improper polarity power sources.; TO REQUEST WARRANTY SERVICE FOR THIS PRODUCT:; Contact Durabilt Technical Support by telephone,

2 YEAR LIMITED WARRANTY PROGRAM This limited warranty program is the only one that applies to this product, and it sets forth all the responsibilities of Durabilt, regarding this product. There is no other warranty, other than those described herein.This Durabilt product is warranted, to the origina...