US Stove Company 22AF - Manuals

US Stove Company 22AF – Manual in PDF format online.

Manuals:

Manual

Manual US Stove Company 22AF

Summary

Page 2 - TOOLS AND MATERIALS NEEDED; TOOLS

2 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• TOOLS AND MATERIALS NEEDED TOOLS Pencil6 Foot Folding Rule or TapeTin SnipsDrill, Hand or ElectricDrill Bit (For Sheet Metal Screws) 1/8" Dia.Screw Driver (Blade-Type)GlovesSabre Saw5/16" Nut Driver or5/16" Socket with Rachet MATERIALS 6" P...

Page 3 - CAUTION; Your Furnace has the following labels. Read and obey all labels.; REFER TO MARKINGS ON THE APPLIANCE FOR ADDITIONAL INFORMATION.; WARM-AIR SUPPLY-DUCT SYSTEM MUST BE CONSTRUCTED ONLY OF METAL

3 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• CAUTION Your Furnace has the following labels. Read and obey all labels. REFER TO MARKINGS ON THE APPLIANCE FOR ADDITIONAL INFORMATION. CAUTION! INSPECT FLUE PIPES, FLUE PIPE JOINTS AND FLUE PIPE SEALSREGULARLY TO ENSURE THAT SMOKE AND FLUE GASES ARE NOTDR...

Page 4 - RULES FOR SAFE INSTALLATION AND OPERATION

4 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• Read these rules and the instructions carefully. Failure to follow them will cause a hazard that could result indeath, serious bodily injury, and/or property damage. Check your local codes. This installation must comply with their rulings. Do not install t...

Page 5 - HOW THE FURNACE FUNCTIONS

5 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• Your Ashley Furnace is designed to be a supplemental or central heating source for yourhome. This solid fuel furnace may be installed inconjunction with a properly operating central fur-nace that is listed or certified in accordance withnationally recogniz...

Page 6 - MODEL 22AF DIMENSIONS

6 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• MODEL 22AF DIMENSIONS FIG. 1

Page 7 - LOCATING THE FURNACE

7 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• 1. 2. 3. 4. FIG. 3 The furnace should be located in the same roomas the central system and as close as possible,but no closer than 9". There should be no wallbetween the furnace and the warm air outlet ductthat is connected directly to the warm air out...

Page 8 - CHIMNEY CONNECTION

8 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• LISTED FACTORY BUILT CHIMNEYCarefully follow chimney manufacturer's instructions. Use only a Listed Residential Type or Building HeatingAppliance Chimney. If your chimney starts at the ceiling (Fig. 5), you will need enough 6" pipe to reach the ceiling...

Page 9 - RULES FOR CONNECTOR PIPE INSTALLATION

9 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• RULES FOR CONNECTOR PIPE INSTALLATION FIG. 6 The crimped end of the chimney connectorfits inside the furnace flue collar. Installadditional chimney connector and elbowwith the CRIMPED END TOWARD THEFURNACE. This will allow any condensa-tion in the flue to ...

Page 14 - MODEL 22AF WIRING DIAGRAM -

14 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• MODEL 22AF WIRING DIAGRAM - FIG. 11 WIRE COLOR CODEG- GREEN- GROUNDB- BLACK- POWER SUPPLYW- WHITE- POWER SUPPLYR1- WHITE- FAN CONTROLR2- BLACK- FAN CONTROLM1- BLACK- BLOWER MOTORM2- WHITE- BLOWER MOTOR Fig. 11 LOADFANLINE LOADLIMITLINE BREAK OFF JUMPER FO...

Page 15 - INSTALLATION

15 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• Please see all methods of Installation in Appendix at the rear of this booklet. This is a furnace, not a free standing stove. You mustdirect heated air from 12" outlet away from the furnace,or it will not function properly. 1. This installation must b...

Page 16 - POWER FAILURE INSTRUCTIONS:; Operation after loss of power

16 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• POWER FAILURE INSTRUCTIONS: Operation after loss of power Remove filter if provided.Do not expect to keep home at normal temperatures.Do not load fuel above bottom of feed door.Set Fuel door and Ash door spin draft maximum closedper the factory installed ...

Page 18 - ALTERNATIVE PARALLEL INSTALLATION WIRING DIAGRAM

18 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• ALTERNATIVE PARALLEL INSTALLATION WIRING DIAGRAM - FIG. 14 TO GAS/OIL/ELECTRIC TRANSFORMER HOTBLAST COMBINATION CONTROL LIMIT FAN JUMPER IN H H POWER SUPPLY GAS/OIL/ELECTRIC POWER SUPPLY JUNCTION BOX CENTRAL FURNACE BLOWER MOTOR WOOD FURNACE BLOWER MOTOR ...

Page 19 - OPERATING INSTRUCTIONS

19 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• CAUTION GASES THAT ARE DRIVEN BY FRESH COAL MUST BEBURNED OR THEY WILL ACCUMULATE AND EXPLODE.NEVER SMOTHER A FIRE WHEN ADDING FRESH COAL. CAUTION DO NOT OPERATE WITH THE FEED AND/OR ASH DOOROPEN. THIS FURNACE IS DESIGNED FOR THERMO-STATIC OPERATION. OPER...

Page 20 - SERVICE HINTS; CHIMNEY MAINTENANCE

20 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• Do not expect a furnace to draw. It is the chimney thatcreates the draft. Smoke spillage into the house or exces-sive build-up of water or creosote in the chimney wouldkeep it from functioning properly. Correct the problembefore using thisfurnace. Possibl...

Page 23 - APPENDIX; INSTALLATION A; NOTE: ANTI-BACKDRAFT FLAPPERS OR BAFFLE ARE REQUIRED

23 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• APPENDIX INSTALLATION A NOTE: ANTI-BACKDRAFT FLAPPERS OR BAFFLE ARE REQUIRED FOR THIS INSTALLATION.

Page 24 - INSTALLATION B

24 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• APPENDIX INSTALLATION B NOTE: ANTI-BACKDRAFT FLAPPERS OR BAFFLE ARE REQUIRED FOR THIS INSTALLATION.

Page 25 - INSTALLATION C

25 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• APPENDIX INSTALLATION C NOTE: ANTI-BACKDRAFT FLAPPERS OR BAFFLE ARE REQUIRED FOR THIS INSTALLATION.

Page 26 - INSTALLATION D

26 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• APPENDIX INSTALLATION D (U.S. ONLY) INSTALLATION E (U. S. ONLY)

Page 27 - INSTALLATION F

27 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• APPENDIX INSTALLATION F INSTALLATION G

Page 28 - TROUBLE SHOOTING TIPS FOR WARM AIR FURNACE

28 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• 1. Smoking when feed door is open. 2. Furnace does not heat. 3. Blower does not run. 4. No air from registers - fan running. 5. Air from registers is not hot. 6. Blower runs too long. 7. Blower does not run long enough. 8. Smoke and/or odor from registers...

Page 29 - NOTES

Page 31 - HEATING WITH WOOD

31 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• TYPE WEIGHT PER CORD EFFICIENCY SPLITS MILLIONS (LBS. CU. FT., DRY) RANKING BTU's/CORD Hickory 63 4500 1.0 Well 31.5 White Oak 48 4100 .9 Fair 28.6 Red Oak 46 3900 .8 Fair 27.4 Beech 45 3800 .7 Hard 26.8 Sugar Maple 44 3700 .6 Fair 26.2 Black Oak 43 3700 ...

Page 32 - KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE REFERENCE.; HOW TO ORDER REPAIR PARTS; UNITED STATES STOVE COMPANY; U S

32 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• THIS MANUAL WILL HELP YOU OBTAIN EFFICIENT, DEPENDABLESERVICE FROM YOUR HOTBLAST FURNACE, AND ENABLE YOUTO ORDER REPAIR PARTS CORRECTLY. KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE REFERENCE. WHEN WRITING, ALWAYS GIVE THE FULL MODEL NUMBERWHICH IS ON THE ...