Ultra 93900 - Manuals - manualsarea.com

Page 2 - Package Contents; UltraATA 133 PCI adapter; Layout; Hardware Installation

2 Package Contents • UltraATA 133 PCI adapter • Driver diskette • 40-pin/80-wire Ultra ATA cable • This quick installation guide Layout IDE1 IDE2 Jumper On (do not remove) Pin1 Pin1 HDD Activity LED Figure 1. UltraATA 133 PCI RAID layout Hardware Installation General instructions for installing the ...

Page 3 - Device Connection

3 1. Turn OFF the power to your computer and any other connected peripheral devices. 2. Unplug the power cord from the back of the computer. 3. Remove your computer’s cover. 4. Remove the slot bracket from an available PCI slot. 5. To install the card, carefully align the card's bus connector with t...

Page 4 - Driver Installation; UltraATA 133 PCI drivers for the following operating

4 4. The Ultra ATA ribbon cable has two connectors. If you install only one drive, connect it to the end connector of the cable. On the other hand, if you install two drives, connect the master drive to the end connector of the cable and the slave drive in the middle connector. Figure 2. Connecting ...

Page 5 - Computer and click Properties. Select Device

5 Windows 98SE For New Windows 98SE Installation1. Install the board and follow Microsoft procedures to install Windows 98SE accordingly. 2. Once Windows has been installed, right click My Computer and click Properties. Select Device Manager tab. 3. Double click PCI Mass Storage Controller listed un...

Page 6 - Windows ME; Computer, then click Properties. Select Device; To Verify Windows 98SE/ME Installation; Image SiI 0680 ATA/133 Controller should be listed.

6 Windows ME For New Windows ME Installation1. Install the board and follow Microsoft procedures to install Windows ME accordingly. 2. Once Windows has been installed, right click My Computer, then click Properties. Select Device Manager tab. 3. Double click PCI Mass Storage Controller listed under ...

Page 7 - SiI 0680 ATA/133 Controller and restart your system.

7 3. Highlight Silicon Image SiI 0680 ATA/133 Controller and click Properties. A message This device is working properly is displayed in the dialog box, the driver has been correctly installed. If any error message is displayed, remove Silicon Image SiI 0680 ATA/133 Controller and restart your syste...

Page 8 - To Verify Windows NT 4.0 Installation; Controller from SCSI Adapters listing and click; Properties. A message This device is working properly

8 To Verify Windows NT 4.0 Installation 1. Double click My Computer/Control Panel/SCSI Adapters. 2. Highlight Silicon Image SiI 0680 ATA/133 Controller from SCSI Adapters listing and click Properties. A message This device is working properly is displayed in the dialog box, the driver has been corre...

Page 10 - Controller to display driver properties.; Bios Configuration

10 To Verify Windows 2000/XP/2003 Installation 1. Right click My Computer and click Manage. 2. Select Device Manager. 3. Double click SCSI and RAID Controllers, then double click Silicon Image SiI 0680 ATA/133 Controller to display driver properties. 4. A message This device is working properly is d...

Page 11 - Technical Support and Warranty; Q U E S T I O N S ? S I I G ’ s O n l i n e S u p p o r t h a s a n s w e r s !

11 Technical Support and Warranty Q U E S T I O N S ? S I I G ’ s O n l i n e S u p p o r t h a s a n s w e r s ! Simply visit our website at www.siig.com and click on Support. Our online support database is updated daily with new drivers and solutions. Answers to your questions could be just a few ...