U-Line U-2175RFB-00 - Manuals

2 u-line.com Product Features Combo® Model Features: Built-in or Freestanding. Provides custom look when built-in with no additional venting clearance needed on sides, top or rear. Do not obstruct the grille. Ice making and refrigeration in one unit. Provides both ice production and refrigeration in...

u-line.com 3 Control Systems A portion of models covered in this guide use an electronic touch control while others use a manual control system. See the table below to identify your model and equipped control system. Users with models using manual control should reference “Product Operation Manual C...

4 u-line.com Checking Product Temperature To check the actual product temperature in the unit. 1. Partially fill a plastic (nonbreakable) bottle with water. 2. Insert an accurate thermometer. 3. Tighten the bottle cap securely. 4. Place the bottle in the desired area for 24 hours. 5. Avoid opening t...

u-line.com 5 Electronic Control Quick Guide Task Touch Touch Display Comment Turn ON/OFF Hold 10 seconds Release when °F flashes. or Adjust Temperature or Touch and release or Touch to change temperature. °F flashes after first touch, set-point saved after 5 seconds of inactivity and °F stops flashi...

6 u-line.com Air Flow NOTICE The unit requires proper air flow to perform at its highest efficiency. Do not block the front grille or internal fans at any time, or the unit will not perform as expected. Do not install the unit behind a door. CO29FF Initial Startup All U-Line controls are preset at t...

8 u-line.com Drawers The drawers should only be removed for servicing by a trained and certified repair personal. Top Storage Bin Grasp the bin handle and slide backward to access the contents below. The bin may be completely removed for cleaning once it is slid forward, making sure it clears the gu...

u-line.com 9 Ice Maker Operation When the ice bucket is full, the ice making mechanism will shut off. However, the refrigeration system will continue to cool and maintain the ice supply. Frost-free ice maker units have lower ice production than manual defrost units. NOTICE Do not place cans or bottl...

10 u-line.com Leveling NOTICE Unit must be level, for proper door and ice maker (if equipped) operation. For Models with adjustable leveling feet: 1. Use a level to check the levelness of the unit from front to back and from side to side. Place the level along top edge and side edge as shown (1). 2....

u-line.com 11 Removing and Installing Grille WARNING ! Disconnect electric power to the unit before removing the grille. WARNING ! DO NOT touch the condenser fins (4). The condenser fins are SHARP and can be easily damaged. Removing the grille. 1. Disconnect power to the unit. 2. Remove control knob...

u-line.com 13 Door Reversability Location of the unit may make it desirable to mount the door on the opposite side of the cabinet. Many doors are reversible. See table below. Reversing Black or White Doors • The hinge hardware will be removed and reinstalled on the opposite side of the cabinet. • Th...

14 u-line.com Prepare door for reinstallation. 1. Remove plastic hole plug from top of door handle and reinstall on opposite side. 2. With bottom of door facing up, remove pivot plate (5) (two screws). 3. Flip over and install pivot plate on opposite side of door. Ensure notch in plate faces center....

u-line.com 15 Door Alignment and Adjustment Align and adjust the door if it is not level, or is not sealing properly. If the door is not sealed the unit may not cool properly, or excessive frost may form in the interior. NOTICE Properly aligned, the door’s gasket should be firmly in contact with the...

u-line.com 17 Checking Drawer Alignment The unit’s drawers are aligned at the factory before shipment. However, their alignment could have been disturbed during shipment or during overlay panel installation. Check each drawer to confirm that it is aligned: • Side-to-Side — When viewed from the top, ...

18 u-line.com Minor Adjustment: Note: The mounting holes on the slide are slightly larger than the screws’ diameter. 1. Loosen one slide’s mounting screws. 2. Level the slide. 3. Retighten the screws. 4. Repeat procedure for the other slide. Severe Adjustment: Note: The slides have extra mounting ho...

u-line.com 19 To defrost: 1. Disconnect power to the unit. 2. For combo models remove all products from the interior. 3. Remove ice bucket and discard ice. 4. Place towel or other absorbent material on bottom of ice bin. For combo models, also place in bottom of unit. 5. Fill the ice bucket half ful...

20 u-line.com Condensor Cleaning Interval - Every Three Months To maintain operational efficiency, keep the front grille free of dust and lint, and clean the condenser every three months. Depending on environmental conditions, more or less frequent cleaning may be necessary. WARNING ! Disconnect ele...

u-line.com 21 Before Calling for Service If you think your U-Line product is malfunctioning, read the OPERATION section of this guide to clearly understand the function of the control. If the problem persists, read the NORMAL OPERATING SOUNDS and TROUBLESHOOTING GUIDE section of this guide to help y...

® USE AND CARE GUIDE ©2013 U-Line Corporation Publication Number 30265 4/2013 Rev.F The American Built-In Undercounter Leader Since 1962 U-LINE.COM BUILDING ON THREE GENERATIONS OF INNOVATION For over five decades and through three generations, U-Line continues to be the leader in innovation, qualit...