U-Line CLR1215 - Manuals

QUICK START GUIDE 2 u-line.com Safety and Warning NOTICE PLEASE READ all instructions before installing, operating, or servicing the appliance. Use this appliance for its intended purpose only and follow these general precautions with those listed throughout this guide: SAFETY ALERT DEFINITIONS Thro...

QUICK START GUIDE 3 u-line.com Water Hookup INDOOR MODELS PREPARE PLUMBING Please use the braided stainless steel water supply line which comes attached. The water line is fitted with a standard 1/4" (6.35 mm) compression fitting. WARNING ! Prior to installation, determine if this product contai...

QUICK START GUIDE 4 u-line.com 5. Route water supply line in cable clamp and secure with screw. OUTDOOR MODELS PREPARE PLUMBING The water valve in this unit uses a standard 1/4" (6.35 mm) compression fitting. WARNING ! Prior to installation, determine if this product contains a gravity style dra...

QUICK START GUIDE 5 u-line.com 3. Locate water valve in the front of the unit and thread water supply line through. NOTICE Route the water supply line through the unit so it does not come into contact with any internal components other than the solenoid valve. Normal operation creates some vibration...

QUICK START GUIDE 6 u-line.com NOTICE Drain can NOT be located directly below the unit. Unit has a solid base that will not allow the unit to drain below itself. There is a possibility that hose connections may have loosened during shipment. Verify all connections and fittings are free from leaks. G...

QUICK START GUIDE 7 u-line.com NOTICE The maximum lift for the P60 drain pump is 10 feet. This must be done as close to the rear of the unit as possible. Door Swing Units have a zero clearance for the door to open 90°, when installed adjacent to cabinets. Stainless Steel and black and white models r...

QUICK START GUIDE 8 u-line.com General Installation LEVELING INFORMATION 1. Use a level to confirm the unit is level. Level should be placed along top edge and side edge as shown. 2. If the unit is not level, adjust the feet on the corners of the unit as necessary. 3. Confirm the unit is level after...

QUICK START GUIDE 9 u-line.com Control Operation First Use All U-Line controls are preset at the factory. Initial startup requires no adjustments. NOTICE U-Line recommends discarding the ice produced during the first two to three hours of operation to avoid possible dirt or scale that may dislodge f...

QUICK START GUIDE 10 u-line.com The ice cube thickness is factory set for best overall performance. The factory setting “0” is designed to maintain an ice bridge of approximately 1/16" to 1/8" (1.6 mm to 3.2 mm) under normal conditions, resulting in a dimple of approximately 1/4" to 1/2&...

QUICK START GUIDE 11 u-line.com Warranty U-LINE CORPORATION LIMITED WARRANTY 1. U-Line Corporation (“U-Line”) warrants each U-Line product to be free from defects in materials and workmanship for a period of one year (two years on Modular 3000 Series) from the date of purchase. U-Line further warran...