U-Line U-CO298-00 - Manual

2 u-line.com Ice Makers Feature: High ice production and storage. ADA15IM, BI2115 and BI98 models produce up to 25 pounds of ice per day and store 25 pounds. BI95 and SP18 models produce up to 23 pounds of ice per day and store 12 pounds. Combo® Models produce up to 18 pounds of ice per day and stor...

u-line.com 3 Air Flow NOTICE The unit requires proper air flow to perform at its highest efficiency. Do not block the front grille or internal fans at any time, or the unit will not perform as expected. Do not install the unit behind a door. Initial Startup All U-Line controls are preset at the fact...

4 u-line.com Adjusting Air Temperature Combo Models NOTICE • Adjust the set point temperature in single increments, and wait 24 hours for the temperature to stabilize before rechecking. • Factory recommended set-point is MID setting on dial control. To adjust the set point temperature: Adjust the te...

u-line.com 5 Ice Maker Operation When the ice bucket is full, the ice making mechanism will shut off. However, the refrigeration system will continue to cool and maintain the ice supply. Frost-free ice maker units have lower ice production than manual defrost units. NOTICE Do not place cans or bottl...

6 u-line.com Leveling NOTICE Unit must be level, for proper door and ice maker (if equipped) operation. For Models with adjustable leveling feet: 1. Use a level to check the levelness of the unit from front to back and from side to side. Place the level along top edge and side edge as shown (1). 2. ...

u-line.com 7 Removing and Installing Grille WARNING ! Disconnect electric power to the unit before removing the grille. WARNING ! DO NOT touch the condenser fins (4). The condenser fins are SHARP and can be easily damaged. Removing the grille. 1. Disconnect power to the unit. 2. Remove control knob ...

8 u-line.com Door Alignment and Adjustment Align and adjust the door if it is not level, or is not sealing properly. If the door is not sealed the unit may not cool properly, or excessive frost may form in the interior. NOTICE Properly aligned, the door’s gasket should be firmly in contact with the ...

u-line.com 11 Reversing Black or White Doors • The hinge hardware will be removed and reinstalled on the opposite side of the cabinet. • The top hinge hardware will be reinstalled on the bottom of the opposite side of the cabinet. • The bottom hinge hardware will be reinstalled on the top of the opp...

12 u-line.com Remove preexisting bottom hinge. 1. Remove the preexisting bottom hinge (three screws) (2). Reinstall hinge to top opposite. 1. Install the hinge just removed from the bottom to the TOP opposite side of the cabinet (three screws) (2). Reinstall Hole Plugs. 1. Install plastic screw plug...

u-line.com 15 . Exterior Cleaning Vinyl Clad (Black or White) Models: • Clean surfaces with a mild detergent and warm water solution. Do not use solvent-based or abrasive cleaners. Use a soft sponge and rinse with clean water. Wipe with a soft, clean towel to prevent water spotting. • Clean any glas...

16 u-line.com Condenser Cleaning Interval - Every Six Months To maintain operational efficiency, keep the front grille free of dust and lint, and clean the condenser every three months. Depending on environmental conditions, more or less frequent cleaning may be necessary. WARNING ! Disconnect elect...

u-line.com 17 Before Calling for Service If you think your U-Line product is malfunctioning, read the OPERATION section of this guide to clearly understand the function of the control. If the problem persists, read the NORMAL OPERATING SOUNDS and TROUBLESHOOTING GUIDE section of this guide to help y...

® USE AND CARE GUIDE ©2013 U-Line Corporation Publication Number 30264 5/2013 Rev.F The American Built-In Undercounter Leader Since 1962 U-LINE.COM BUILDING ON THREE GENERATIONS OF INNOVATION For over five decades and through three generations, U-Line continues to be the leader in innovation, qualit...