Trane 1500 CFM - Manuals

UV-SVN03D-EN 7 Table G1: VUVE general data Unit Location and Clearances Locate the unit in an indoor area. The ambient temperature surrounding the unit must not be less than 45°F. Do not locate the unit in areas subject to freezing. Attention should be given to service clearance and technician safet...

UV-SVN03D-EN 13 Dimensions Crossover Piping FLUSH FLUSH 1 1/2" 1 1/4" 3" 24" 19 3/8" 3 5/8"5 3/8" RETURN 7/8" I.D. FIELD CONN. W/ SHUT OFF VALVE 7/8" I.D. FIELD CONN. W/ SHUT OFF VALVE RETURN TOP VIEW SIDE VIEW TOP VIEW SIDE VIEW 16 5/8" DEPTH UNIT 21 1/4"...

14 UV-SVN03D-EN Grout WeepHoles RubberSeals Unit OutsideWall Floor WeepHoles Caulking OutsideWall Interior Wallw/ sheetrock Water dam slopedtoward exterior RubberSeals Unit Interior Wallw/ sheetrock Water dam slopedtoward exterior Flanged wallbox Wall Box Installation The following instructions are ...

UV-SVN03D-EN 15 General Installation Checks The checklist below is a summary of the steps required to successfully in-stall a unit. This checklist is intended to acquaint the installing personnel with procedures required in the installation process. It does not replace the de-tailed instructions cal...

16 UV-SVN03D-EN A B C D E F C B Installation Figure 3: Mounting hole location A B C D E F 075 Standard Unit (no Falseback) 1.31 13.50 2.75 66.39 10.38 45.64 Standard falseback 1.00 2.13 26.00 67.00 10.00 47.00 29" stepdown falseback 1.00 2.13 24.44 67.00 10.00 47.00 28" stepdown falseback 1....

UV-SVN03D-EN 17 Unit Mounting Note: All wall intake boxes should be installed prior to mounting the unit ventilator. Refer to Page 14 for wall box installation instructions. The 1/2” mounting or anchoring holes are located on the back of the unit on each end. See Figure 3 . 1 Note: All mounting fast...

18 UV-SVN03D-EN Piping Installation Before installation of piping package, the shipping bracket holding the pip-ing in place, must be removed. Proper installation of piping is neces-sary to provide efficient coil operation and to prevent damage during opera-tion. Follow standard piping practices and...

UV-SVN03D-EN 19 Split System Units The following refrigerant piping and interconnecting wiring instructions apply to unit ventilators with direct ex-pansion type cooling coils used in con-junction with air-cooled condensing units. Reference must also be made to the condensing unit installation and w...

20 UV-SVN03D-EN Modulating Water Valves (Option) The actuator on the valve is a 24V, 3-point floating valve. The actuator can be easily removed from the valve body by pressing in on the locking tab and rotating the actuator 45° counter-clockwise (See Figure 6a) . The 2-way valves are bi-directional ...

UV-SVN03D-EN 21 Manually Opening Valve The manual opener can be manipulat-ed only when in the up position. The A port can be manually opened by firmly pushing the white manual lever down to the midway position and pushing the lever in. In this position, both A and B ports are open. This “manual open...

22 UV-SVN03D-EN Soldering procedures are as follows: 1 Remove actuator as stated earlier. 2 Place valves on the pipe. Rotate valve stem so the shaft slot points at the notch in the side of the body (90° to flow direction). This pro-tects the plug inside the valve by removing it from the seat, Figure...

UV-SVN03D-EN 23 WARNING Hazardous Voltage! Disconnect all electric power, in-cluding remote disconnects be-fore servicing. Follow proper lockout/tagout procedures to en-sure the power can not be inad-vertently energized. Failure to disconnect power before servic-ing could result in death or seri-ous...

UV-SVN03D-EN 27 WARNING Hazardous Service Procedures! The maintenance and trouble-shooting procedures recommend-ed in this section of the manual could result in exposure to electri-cal, mechanical or other potential safety hazards. Always refer to the safety warnings provided throughout this manual ...

28 UV-SVN03D-EN WARNING Hazardous Service Procedures! The maintenance and trouble-shooting procedures recommend-ed in this section of the manual could result in exposure to electri-cal, mechanical or other potential safety hazards. Always refer to the safety warnings provided throughout this manual ...

UV-SVN03D-EN 29 WARNING Hazardous Service Procedures! The maintenance and trouble-shooting procedures recommend-ed in this section of the manual could result in exposure to electri-cal, mechanical or other potential safety hazards. Always refer to the safety warnings provided throughout this manual ...

30 UV-SVN03D-EN Warranty Information Standard Warranty The standard unit ventilator warranty is Trane’s parts-only warranty, running 12-months from startup, not to exceed 18-months from shipment. Extended Warranty The optional extended warranty is a second through fifth year warranty. The time start...

38 UV-SVN03D-EN Unit Wiring Tracer ZN520 120V/1 PH - 3-Speed, 4-Pipe Hot Water/Chilled Water