TP-Link TL-SG1016 - Manuals

Page 2 - COPYRIGHT & TRADEMARKS

I COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any for...

Page 3 - FCC STATEMENT

II FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference in a residential installation. This equipment generates, us...

Page 5 - Over view of the Product

1 Chapter 1 Introduction of the Product This chapter describes the features of the TL-SG1016/ TL-SG1024 16/24-port Gigabit Ethernet Switch. 1.1 Over view of the Product The TL-SG1016/TL-SG1024 16/24-port Gigabit Ethernet Switch provides you with a high-performance, low-cost, easy-to-use, seamless an...

Page 6 - Chapter 2; Mounting the Switch on a Desk

2 detect and correct problems on the network. 1.2 Features ¾ Complies with IEEE802.3, IEEE802.3u, IEEE802.3ab standards ¾ 16/24 10/100/1000Mbps Auto-Sense RJ45 ports supporting Auto-MDI/MDIX ¾ All ports Support Full/Half Duplex transfer mode for 10/100Mbps and Full Duplex transfer mode for 1000Mbps ...

Page 7 - Mounting the Switch in a Rack

3 2.2 Mounting the Switch in a Rack The dimension of TL-SG1016/TL-SG1024 is designed according to the standard 19 rack-mountable steel case of Electronic Industries Association. Turn off all the equipment connected to the Switch before mounting it in the rack, then rivet the two "L" brackets...

Page 8 - Chapter 3

4 2.3 Power On TL-SG1016/TL-SG1024 16/24-port Gigabit Ethernet Switch is powered by AC power supply. Powering on the Switch, it will automatically initialize and its LED indicators should respond as follows: 1 ） All of the Link/Act and 1000Mbps LED indicators will fl ash momentarily for one second, ...

Page 10 - Appendix A: Specifications; General

6 Appendix A: Specifications General Standards IEEE802.3 10Base-T IEEE802.3u 100Base-TX IEEE802.3ab 1000Base-T Topology Star Protocol CSMA/CD Ethernet: 10Mbps (Half Duplex), 20Mbps (Full Duplex) Fast Ethernet: 100Mbps (Half Duplex), 200Mbps (Full Duplex) Data Transfer Rate Gigabit Ethernet: 2000Mbps...

Page 11 - Environmental and Physical

7 LED indicators Power, Link/Act, 1000Mbps Transfer Method Store-and-Forward MAC Address Learning Automatically learning, automatically aging 10Base-T: 14881pps/Port 100Base-Tx: 148810pps/Port Frame Filter Rate 1000Base-T: 1488095pps/Port 10Base-T: 14881pps/Port 100Base-Tx: 148810pps/Port Frame Forw...

Page 12 - Appendix B: Troubleshooting; The Power LED is not lit; Appendix C: Contact Information

8 Appendix B: Troubleshooting 1. The Power LED is not lit ¾ Make sure the AC power cord connected the Switch with power source properly. ¾ Make sure the power source is ON. 2. The Link/Act LED is not lit when a device is connected to the corresponding port ¾ Make sure that the cable connectors are f...