TP-Link TL-SG1008 - Manuals

Page 2 - U s e r ’ s G u i d e; Gigabit Ethernet Switch

U s e r ’ s G u i d e T L - S G 1 0 0 8 8 - p o r t Gigabit Ethernet Switch T L - S G 1 0 1 6 16-port Gigabit Ethernet Switch T L - S G 1 0 2 4 24-port Gigabit Ethernet Switch T L - S G 1 0 4 8 48-port Gigabit Ethernet Switch

Page 3 - COPYRIGHT & TRADEMARKS; FCC STATEMENT; CE Mark Warning

COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form ...

Page 4 - SAFETY NOTICES; Cautions

radio interference, in which case the user may be required to take adequate measures. SAFETY NOTICES Cautions Do not use this product near water, for example, in a wet basement or near a swimming pool. Avoid using this product during an electrical storm. There may be a remote risk of electric shock ...

Page 5 - CONTENTS; Chapter 1; Overview of; Chapter 2

CONTENTS Package Contents .................................................................. 1 Chapter 1 Introduction of the Product.............................. 2 1.1 Overview of the Product ...............................................................2 1.2 Features ................................

Page 6 - Gigabit Ethernet Switch User Guide; Package Contents

TL-SG1008/TL-SG1016/TL-SG1024/TL-SG1048 Gigabit Ethernet Switch User Guide 1 Package Contents The following contents should be found in your box: ¾ One Gigabit Ethernet Switch ¾ One power cord ¾ This User's Guide ¾ Rubber footpads for Desk-mount ¾ Rack-mount kit for installing the switch in a 19-inc...

Page 7 - Chapter 1 Introduction of the Product; of

TL-SG1008/TL-SG1016/TL-SG1024/TL-SG1048 Gigabit Ethernet Switch User Guide 2 Chapter 1 Introduction of the Product This chapter describes the features of the Gigabit Ethernet Switch. 1.1 Overview of the Product The Gigabit Ethernet Switch provides you with a high-performance, low-cost, easy-to-use, ...

Page 9 - Mounting the Switch on a Desk; Note; Mounting the Switch in a Rack

TL-SG1008/TL-SG1016/TL-SG1024/TL-SG1048 Gigabit Ethernet Switch User Guide 4 Chapter 2 Installation 2.1 Mounting the Switch on a Desk Before placing the Switch on a desk, attach four rubber footpads to the flutes on the Switch bottom, then lay the Switch on the desktop, where can be able to withstan...

Page 10 - On

TL-SG1008/TL-SG1016/TL-SG1024/TL-SG1048 Gigabit Ethernet Switch User Guide 5 Figure 2-1 Rivet the “L” brackets onto the Switch Figure 2-2 Fasten the Switch in the rack 2.3 Power On The Gigabit Ethernet Switch is powered by AC power supply. Powering on the Switch, it will automatically initialize and...

Page 12 - Chapter 3 Identifying External Components; Panel

TL-SG1008/TL-SG1016/TL-SG1024/TL-SG1048 Gigabit Ethernet Switch User Guide 7 Chapter 3 Identifying External Components This Chapter describes the front panel, rear panel and LED indicators of the Switch. TL-SG1008, TL-SG1016, TL-SG1024 and TL-SG1048 are different in the number of LED indicators and ...

Page 14 - Appendix A: Specifications

TL-SG1008/TL-SG1016/TL-SG1024/TL-SG1048 Gigabit Ethernet Switch User Guide 9 Appendix A: Specifications General Standards IEEE802.3 10Base-T IEEE802.3u 100Base-TX IEEE802.3ab 1000Base-T Topology Star Protocol CSMA/CD Data Transfer Rate Ethernet: 10Mbps (Half Duplex), 20Mbps (Full Duplex) Fast Ethern...

Page 15 - Appendix B: Troubleshooting; The Power LED is not lit; The Link/Act LED is not lit when a device is connected to the

TL-SG1008/TL-SG1016/TL-SG1024/TL-SG1048 Gigabit Ethernet Switch User Guide 10 Appendix B: Troubleshooting 1. The Power LED is not lit ¾ Make sure the AC power cord connected the Switch with power source properly. ¾ Make sure the power source is ON. 2. The Link/Act LED is not lit when a device is con...