Page 3 - COPYRIGHT & TRADEMARKS
COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form ...
Page 4 - FCC STATEMENT
FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. Thi...
Page 5 - Cautions
2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. CE Mark Warning This is a class A pro...
Page 6 - CONTENT
CONTENT Package Contents ...................................................... 1 Chapter 1. Introduction of the Product .......................... 2 1.1 Overview of the Product ...................................... 2 1.2 Convention ............................................................ 3 1.3...
Page 8 - Chapter 1. Introduction of the Product; Overview of the Product
2 Chapter 1. Introduction of the Product Thank you for choosing the TL-SF1008P 8-Port 10/100Mbps Desktop PoE Switch. 1.1 Overview of the Product The TL-SF1008P 8-Port 10/100Mbps Desktop PoE Switch provides the seamless network connection, which integrates 100Mbps Fast Ethernet and 10Mbps Ethernet ne...
Page 10 - Chapter 2. Installation; Mounting the Switch on a Desk
4 Chapter 2. Installation During the installation procedure, please only use the accessories equipped with the Switch. 2.1 Mounting the Switch on a Desk To install the Switch, please follow the steps: 1) Place the Switch on a flat desk. 2) Remove the adhesive backing papers from the rubber cushions....
Page 11 - On; Chapter 3. Identifying External Components; Panel
5 2.2 Power On The TL-SF1008P Switch can be used with DC power supply. Powering on the Switch, it will automatically initialize and its LED indicators will respond as follows: 1) Firstly, the Power LED indicator will light up. 2) Then, the 100Mbps and Link/Act LED indicators will flash momentarily f...
Page 15 - Appendix A: Specifications
9 Appendix A: Specifications General Standard IEEE802.3,IEEE802.3u,IEEE802.3x,IEEE802.3af Protocol CSMA/CD Ethernet: 10Mbps (Half Duplex) 20Mbps (Full Duplex) Data Transfer Rate Fast Ethernet: 100Mbps (Half Duplex) 200Mbps (Full Duplex) 10Base-T: UTP category 3, 4, 5 cable (maximum 100m) EIA/TIA-568...