TOA C-CV854D-3 CE - Manuals

Page 2 - TABLE OF CONTENTS; SAFETY PRECAUTIONS

2 TABLE OF CONTENTS 1. SAFETY PRECAUTIONS ............................................................................... 3 2. GENERAL DESCRIPTION ............................................................................. 5 3. HANDLING PRECAUTIONS ....................................................

Page 3 - regarded as very important precautions are included.; Safety Symbol and Message Conventions; WARNING; may result in fire or electric shock.

3 1. SAFETY PRECAUTIONS • Before installation or use, be sure to carefully read all the instructions in this section for correct and safe operation. • Make sure to observe the instructions in this manual as the conventions of safety symbols and messages regarded as very important precautions are inc...

Page 4 - CAUTION; Note

4 Indicates a potentially hazardous situation which, if mishandled, couldresult in moderate or minor personal injury, and/or property damage. CAUTION • Leave the installation of the unit to your TOA dealer because the installation requires expert experience and skills. The unit may fall off if incor...

Page 5 - HANDLING PRECAUTIONS; camera's plastic or other parts may be deformed or discolored.; GENERAL DESCRIPTION

5 The TOA C-CV854D-3 are Vandal Resistant Day/Night Camera equipped with a Day/Night function. Itfunctions as a color camera in the daytime and as a high-sensitivity monochrome camera in darkness, makingit ideal for installation in locations that require around-the-clock monitoring. Noise reduction ...

Page 6 - [ Bottom view with a dome cover attached ]

6 LOCK [ Side view with a dome cover attached ] [ Bottom view with a dome cover attached ] [ Side view with an inner cover detached ] [ Bottom view with an inner cover detached ] 4 5 6 7 8 9 10 11 12 1 2 3 (1) Camera power input cable (Red, Black) (24 V AC or 12 V DC) (2) Heater power input cable (W...

Page 7 - Notes; The dome cover is connected to the case by a safety wire.; Make a cable entry hole as shown below in the ceiling or wall.

7 LO CK LO CK L-type wrench Dome cover Case 5. INSTALLATION Notes · Do not remove the protective sheet attached to the dome cover until installation work is completed. Damage to the dome cover could result if the protective sheet is removed during installation. · A safety wire for connecting between...

Page 9 - and lead it out from the camera pipe receptacle thread hole.

9 Fixing screw Pipe receptacle thread cover Cord bush Cord bush 2. Push in the cord bush attached to the camera unit from the back to pull out from the case. Run the cable and lead it out from the camera pipe receptacle thread hole. Push the cord bush. 5.2.2. Open wiring from the camera’s side Note ...

Page 11 - If the Video output is not terminated at 75

11 Heater power input The camera power input 24 V AC or 12 V DC Video output Video input Monitor : BNC plug Use the external power supply unit of the following rating when the camera is operated on 12 V DC. 12 V DC, over 1.0 A 24 V AC Red : Black : 6. CONNECTION Note: If the Video output is not term...

Page 12 - · When adjusting the lens, do not touch the galvanometer.; Switch on the camera power after completing camera connections.

12 After angle adjustment completion, tighten both rotation lock screws. 5. Adjust the angle of view with the Zoom ring and adjust the focus with the Focus ring for the best possible picture reproduction. After lens adjustment completion, tighten both the Zoom ring fixing screw and the Focus ring fi...

Page 13 - ABOUT THE MODE SETTING SWITCH; Set to this position during normal use.

13 Mode Setting Switch (Factory-preset setting) 1 : Focus adjustment switch2 : Backlight compensation switch3 : Flickerless switch4 : ATW/AWB selection switch5 : Mode selection switch ON OFF 1 2 3 4 5 FOCUS ADJUST BLC SHUTTER ATW D / N AWB COLOR ON OFF 1 2 3 4 5 ON OFF 1 2 3 4 5 ON OFF 1 2 3 4 5 ON ...

Page 17 - Cautions when Detaching/Attaching an Inner Cover; DETACHING AN INNER COVER; down the sections indicated by arrows tightly.

After detaching the dome cover from the case, do not lift the camera unit by the inner cover.If lifted, the inner cover can be unhooked, and the camera could fall off, possibly resulting in personal injuries orcausing damage to the camera. Cautions when Detaching/Attaching an Inner Cover 133-21-625-...