Stanton DJLab 2.1 - Manuals

Review this setup diagram. Make sure all faders are at "zero" and all devices are off. First, connect all input sources and processors. Next, connect your microphone and monitor headphones. Finally, connect the stereo outputs to the power amplifier(s) and/or audio receivers such as tape deck...

Input / output impedance & sensitivity: (Master 0dBV output, load=100Kohm, Max. gain, EQ flat) Line 10K ohm /-14dBV (200mV) +/-2dB Phono 47K ohm /-50dBV (3.16mV) +/-2dB Mic 2.2K ohm /-60dBV (1mV) +/-2dB Master 1K ohm Phones 33 ohm / 0dBV (1V) ±2dB Max. output (THD=1%, Maximum gain, EQ flat) Mast...

1. Rotate the power dial clockwise to turn on the power, the speed indicator and the strobe-illuminator will light up. 2. Place a record on the slip mat, when playing a 45rpm record with a large center hole, place the 45-rpm adaptor on the center spindle. 3. Set the rotation speed (33/45) to match t...

1. Start/Stop - Press this button to start or stop the platter. 2. Strobe dots - The dots around the edge of the platter are used in conjunction with the light located inside the motor ON/OFF switch. While the platter is in rotation, the dots help to indicate the speed of rotation. The speed is lowe...

GENERAL Model: T.62 Dimensions 452 (W) x 370 (D) x 87 (H) mm s g K 3 . 6 t h g i e W Power supply AC 100V, 50/60Hz (For Japan) ) n a w i a T r o F ( z H 0 6 , V 0 1 1 C A ) o c i x e M , a d a n a C , . A . S . U r o F ( z H 0 6 , V 0 2 1 C A ) a n it n e g r A , e li h C , s e t a ri m E b a r A d ...