Stanton DJLab 1.1 - Manuals

Page 2 - IMPORTANT SAFETY PRECAUTIONS

2 IMPORTANT SAFETY PRECAUTIONS 1. Read Instructions – All the safety and operating instructions should be read before this product is operated. 2. Retain Instructions – The safety and operating instructions should be retained for future reference. 3. Heed Warnings – All warnings on the appliance and...

Page 4 - M.212 CONTROL OVERVIEW TOP PANEL

M.212 CONTROL OVERVIEW TOP PANEL 4 1. Channel Gain - Adjusts the pre-fader volume for cleaner sound. Reduce the channel gain if you notice the level indicators flashing red. 2. Mic Input Gain - Adjusts microphone input level. 3. Mic EQ - The mic channel includes a two-band EQ with a range of +10dB t...

Page 5 - M.212 CONTROL OVERVIEW REAR PANEL

M.212 CONTROL OVERVIEW REAR PANEL 5 16. Power Switch - Turns unit off and on. 17. Power Connector - Plug in the included power supply here. 18. Fader Start Control Jacks - Connect these jacks to the Fader input jacks of the CD player using the 3.5mm stereo mini cord. 19. Master Output - Unbalanced R...

Page 6 - Tu r n t a b l e; M.212 QUICK SETUP DIAGRAM

Review this setup diagram. Make sure all faders are at "zero" and all devices are off. First, connect all input sources and processors. Next, connect your microphone and monitor headphones. Finally, connect the stereo outputs to the power amplifier(s) and/or audio receivers such as tape deck...

Page 7 - M.212 SPECIFICATIONS

Input / output impedance & sensitivity: (Master 0dBV output, load=100Kohm, Max. gain, EQ flat) Line 10K ohm /-14dBV (200mV) +/-2dB Phono 47K ohm /-50dBV (3.16mV) +/-2dB Mic 2.2K ohm /-60dBV (1mV) +/-2dB Master 1K ohm Phones 33 ohm / 0dBV (1V) ±2dB Max. output (THD=1%, Maximum gain, EQ flat) Mast...

Page 8 - ASSEMBLY

Thank you for purchasing the T.52 turntable from Stanton. The T.52 is built upon Stanton’s heritage of designing audiophile products for the most discriminating listener. Before assembling the T.52 please check to make sure the following items are included with the main unit in the carton. AC cord R...

Page 9 - CO NNEC TIONS; T.52 TONEARM AND CARTRIDGE SETTING

1. Rotate the power dial clockwise to turn on the power, the speed indicator and the strobe-illuminator will light up. 2. Place a record on the slip mat, when playing a 45rpm record with a large center hole, place the 45-rpm adaptor on the center spindle. 3. Set the rotation speed (33/45) to match t...

Page 10 - CONTROL OVERVIEW

1. Start/Stop - Press this button to start or stop the platter. 2. Strobe dots - The dots around the edge of the platter are used in conjunction with the light located inside the motor ON/OFF switch. While the platter is in rotation, the dots help to indicate the speed of rotation. The speed is lowe...

Page 11 - WARRANTY & RETURN POLICY

Warranty Through Stanton’s authorized dealers around the World, Stanton, or one of Stanton’s authorized distributors outside the U.S., will, without charge, repair or replace, at the sole discretion of the entity responsible for making the repair or providing the replacement, any Stanton merchandise...