Page 2 - Installation instructions; Safety and operating instructions; DIRECTIVES
Installation instructions 2 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE; IT MUST ALW AYS BE KEPT INTACT TOGETHER W ITH THE DISHW ASHER FOR FUTIRE REFERENCE. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. THEY CON...
Page 3 - THE APPLIANCE MUST BE PROVIDED WITH AN EARTH CONNECTION
Installation instructions 3 THE APPLIANCE MUST BE PROVIDED WITH AN EARTH CONNECTION IN ACCORDANCE W ITH THE ELECTRICAL SAFET Y REGULATIONS IN FORCE. THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR DAMAGE TO PERSONS OR PROPERT Y RESULTING FROM THE FAILURE TO EARTH THE APPLIANCE OR FROM A DEFECTIVE E...
Page 4 - DO NOT ATTEMPT
Installation instructions 4 IF THE APPLIANCE IS PROVIDED W ITH A PLUGLESS SUPPLY CORD, A CIRCUIT BREAKER PROVIDING A FULL DISCONNECTION IN OVERVOLTAGE PROTECTION CLASS III MUST BE INSTALLED IN AN EASILY ACCESSIBLE POSITION ON THE SUPPLY LINE. THE DISHW ASHER MUST ALW AYS BE CONNECTED TO THE W ATER S...
Page 5 - MODELS WITH “AQUAST OP” DEVICE; MODELS WITH INTERNAL LIGHTING
Installation instructions 5 CARRIED OUT BY UNAUT HORISED PERSONS WILL INVALIDATE T HE WARRANTY, AS WELL AS POSING A POTENTIAL HAZ ARD TO THE USER. IN THE EVENT OF A FAULT, DISCONNECT THE DISHW ASHER FROM THE ELECTRICAL POW ER SUPPLY AND SHUT OFF THE W ATER TAP. IF THE SUPPLY CORD IS DAMAGED, IT MUST...
Page 7 - TECHNICAL DATA; TECHNIC AL D ATA; 5 Standard place settings; Water supply pressure; See rating plate
Installation instructions 7 TECHNICAL DATA TECHNIC AL D ATA Width 597 599 mm Depth measured flush w ith the outer edge of the control panel Free standing: 600 mm Semi-integrated: 570 mm Height (depending on models) Free standing: from 850 mm to 890 mm from 890 mm to 930 mm Semi-integrated: from 82...
Page 9 - Water supply connection; CONNECTING TO THE WATER SUPPLY; supplied with the dishwasher.; not exceeding; . Supplying the appliance with hot water cuts down the washing time
Installation instructions 9 2.1 Water supply connection Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supply check that the water is clear and free of impurities, to prevent damage to the appliance. The dishwa...
Page 10 - DRAIN CONNECTION; The free end should be positioned at a height of between; Class of protection against moisture: IPX0
Installation instructions 10 DRAIN CONNECTION Insert the dishwasher’s drain hose into a drain pipe having a diameter of at least 4 cm , or alternatively, place it inside the kitchen sink using the plastic support provided, taking care not to crush or excessively bend the hose. It is important to pre...
Page 11 - User instructions; Description of the controls; Upper panel; OPTION BUTTONS/LIGHTS
User instructions 11 3. Description of the controls 3.1 Upper panel All the dishwasher controls are grouped on the upper panel. Switching on, programming, switching off etc. are only possible when the door is open. 1 ON/OFF BUTTON 2 OPTION BUTTONS/LIGHTS 3 SELECTED PROGRAM BUTTONS/LIGHTS 4 START/PAU...
Page 12 - The front panel; The front panel includes the; DISPLAY; which provides all information; FRONT DISPLAY
User instructions 12 3.2 The front panel The front panel includes the DISPLAY which provides all information concerning the programmed functions. 8 FRONT DISPLAY 9 DOOR HANDLE N.B.: symbols and styling are guideline and may vary depending on the model or version of the dishwasher purchased. Informat...
Page 13 - End
User instructions 13 Information shown on front display End of cycle message End Estimated wash cycle duration and time remaining 01: 55 Delayed start information Start in "X" hours Error message Error 01 ……11 Softener setting h.3 Program phase icons. They indicate the program status when a ...
Page 14 - PROGRAMS TABLE
User instructions 14 PROGRAMS TABLE PROGRAMME NUMBER & SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS DURATION CONSUMPTION MINUT ES (1) WAT ER LITRES POWER kWh (1) 1 RAPID 27’ Dishes with light dirt, washed immediately after use W ash at 38°C Rinse at 50°C 27 6,5 0,70 2 NORMAL ECO (*) Croc ke...
Page 15 - QUICK TIME PROGRAMS; (see relevant section for explanation of functioning modes)
User instructions 15 QUICK TIME PROGRAMS (ENERSAVE option non available) (see relevant section for explanation of functioning modes) PROGRAMME NUMBER E SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS DURATION CONSUMPTION MINUT ES (1) WATER LITRES POWER KWh (1) 6 SOAK + Pans and dishes awaiting com...
Page 16 - REFERENCES; for the; ENERGY LABEL; supplied with the dishwasher:
User instructions 16 NOTES AND REFERENCES Only run the soak program with partial loads. The options cannot be used with the soak program. The ENERSAVE option cannot be used with soak, ultraclean , or any programs which do not include the final drying stage. * Standard program under EN 50242 . If pre...
Page 17 - Wash programs; Before starting a wash program, check that:
User instructions 17 3.3 Wash programs Before starting a wash program, check that: The water supply tap is open. The softener container contains regenerating salt. The correct amount of detergent has been added to the dispenser. The baskets have been correctly loaded. The spray arms are ab...
Page 20 - TO SAVE ENERGY AND PROTECT THE ENVIRONMENT
User instructions 20 DELAYING THE PROGRAM The start of the wash program can be delayed to program the dishwasher to operate at the preferred time of day (e.g. overnight). Press the PROGRAM DELAY button to activate the option and show a 1 hour delay on the display. Keep pressing to select the delay r...
Page 21 - Do not pour detergent directly onto dishes.
User instructions 21 TO REDUCE DETERGENT CONSUMPTION AND PROTECT THE ENVIRONMENT The phosphates contained in dishwasher detergents are harmful to the environment. To avoid using excessive amounts of detergent save on electricity as well, observe the following recommendations: Sort your dishes, was...
Page 22 - Operating instructions; Adjust the water softening system; Using the water softening system; 0 washing cycles; container can hold approximately
User instructions 22 4. Operating instructions Once the dishwasher has been correctly installed, prepare for use as follows: Adjust the water softening system; Add the regenerating salt; Add the rinse aid and detergent. 4.1 Using the water softening system The amount of scale contained in the ...
Page 23 - ADJUSTING THE SOFTENER (only is fitted); (available for all programs except the soak program); PROGRAM DELAY
User instructions 23 Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. When necessary, refill the regenerating salt container before starting the washing program. In this way, the excess saline solution will be immediately removed ...
Page 24 - WATER HARDNESS TABLE (on some models only); Using the rinse aid and detergent dispensers; detergent
User instructions 24 WATER HARDNESS TABLE (on some models only) WATER HARDNESS SETTING German degrees (°dH) French degrees (°dF) 0 - 6 0 - 11 h.-0 NO SALT 7 - 10 12 - 18 h.-1 11 - 15 19 - 27 h.-2 16 - 21 28 - 37 h.-3 22 - 28 38 - 50 h.-4 29 - 35 51 - 62 h.-5 36 - 50 63 - 90 h.-6 Contact your local w...
Page 25 - ADDING THE RINSE AID; Rotate the container cap anticlockwise by 1⁄4 of a turn and remove it.; ADJUSTING THE RINSE AID DISPENSER SETTING
User instructions 25 ADDING THE RINSE AID The rinse aid helps the dishes dry faster and prevents the formation of scale deposits and staining; it is automatically added to the water during the final rinse cycle, from the container situated on the inner side of the door. To add rinse aid: Open the ...
Page 26 - ADDING THE DETERGENT; . Add the detergent and close the cap
User instructions 26 ADDING THE DETERGENT To open the detergent dispenser cap, lightly press the button P . Add the detergent and close the cap carefully. During the washing cycle, the dispenser will be opened automatically. When a program with hot prewash is selected (see program table), extra de...
Page 27 - General warnings and recommendations
User instructions 27 The introduction of detergent into the rinse aid dispenser, even in liquid form, will damage the dishwasher. 4.3 General warnings and recommendations Before using the dishwasher for the first time, it is advisable to read the following recommendations concerning dish types to be...
Page 29 - Using the baskets; The dishwasher has a capacity of; LOWER BASKET
User instructions 29 4.4 Using the baskets The dishwasher has a capacity of 15 place-settings , including serving dishes. LOWER BASKET The lower basket receives the full force of the lower spray arm, and should therefore be used for the “toughest” items with a heavier degree of soiling. All types an...
Page 30 - glass holder
User instructions 30 Supports for cups and long objects (ladles, spoons, etc.), in the rear; can be tipped to the vertical position when not in use. Glass holder. Support for long- stem glasses. When lifted out of the stowed position (0) it snaps into three different positions (1-2-3). 2-position fo...
Page 31 - rotates into place above point; LOADING THE LOWER BASKET
User instructions 31 To lie completely flat, lift the end and turn it towards you so that the retainer F rotates into place above point S . LOADING THE LOWER BASKET Carefully load flat plates, soup plates, dessert and serving dishes, positioning them vertically. Pots, pans and their covers must be l...
Page 32 - FLEXI DUO TOP RACK (on some models only)
User instructions 32 FLEXI DUO TOP RACK (on some models only) This comprises two independent sliding, pull-out tray racks for easier loading/unloading of cutlery. Various loading systems and configurations are possible. For example, tea cups can be loaded with the right-hand rack set in the low posi...
Page 34 - UPPER BASKET
User instructions 34 UPPER BASKET It is recommended to load the upper basket with small- or medium-sized items such as glasses, small plates, tea or coffee cups, shallow bowls and light objects made from heat resistant plastic. If the upper basket is used in the lowermost position, it can also be lo...
Page 37 - Cleaning and maintenance; ORBIT AL
User instructions 37 5. Cleaning and maintenance Before carrying out any work, always unplug the appliance from the electrical supply or switch off the all-pole disconnection device. 5.1 General warnings and recommendations Avoid the use of acidic or abrasive detergents. Clean the outer surfaces and...
Page 38 - CLEANING THE FILTER UNIT; It is advisable to periodically inspect the centre filter
User instructions 38 CLEANING THE FILTER UNIT It is advisable to periodically inspect the centre filter C and, if necessary, to clean it. To remove the filter, grip the tabs, turn them anticlockwise and lift upwards; push the centre filter D from the underside to remove it from the micro- filter...
Page 39 - Plug the power cord back into the socket.
User instructions 39 BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE: Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the water to run from the water supply tap for a few minutes. Plug the power cord back into the socket. Reconnect the water ...
Page 40 - there is rinse aid inside the special container
User instructions 40 If the dishes fail to dry or remain dull, check that: there is rinse aid inside the special container; the rinse aid dispenser setting is correct; the detergent used is of good quality and has not lost its effectiveness (for example, through incorrect storage, with the box...
Page 41 - - Check the position of the door lock catch; If necessary; , raise it by adjusting the plastic screw; If it has triggered; close the door with force until it resets open and close the door.
User instructions 41 Only for models with this type of lock. If the door does not close: 1 - Check the position of the door lock catch (D) 2 - If necessary , raise it by adjusting the plastic screw (V) next to the catch. 3 - Check the condition of the lock hook; if it has not triggered (reference N ...
Page 43 - TABLE OF MALFUNCTIONS DETECTED BY THE AUTODIAGNOSIS SYSTEM
User instructions 43 6. Troubleshooting The dishwasher has an autodiagnosis system capable of detecting and indicating a preset series of possible malfunctions. TABLE OF MALFUNCTIONS DETECTED BY THE AUTODIAGNOSIS SYSTEM FAULT DESCRIPTION Error 01 Anti-flooding system tripped (where installed). Error...