Page 2 - User instructions; Safety and operating instructions; FOR INDOOR USE IN A HOUSEHOLD
User instructions 2 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE; IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER FOR FUTIRE REFERENCE. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. THEY CONTAIN IMPORT...
Page 3 - DO NOT INSTALL THE APPLIANCE IN A PLACE SUBJECT TO FREEZING.
User instructions 3 DURING THE INSTALLATION THE APPLIANCE MUST BE DISCONNECTED FROM THE NETWORK.. DO NOT INSTALL THE APPLIANCE IN A PLACE SUBJECT TO FREEZING. IF THE APPLIANCE IS INSTALLED ON A CARPETED OR COVERED FLOOR, ENSURE THAT THE OPENINGS ON ITS UNDERSIDE ARE NOT OBSTRUCTED. DO NOT INSTALL TH...
Page 4 - DO NOT ATTEMPT
User instructions 4 THE APPLIANCE MUST BE CONNECTED TO THE WATER SUPPLY BY NEW HOSES; OLD HOSES MUST NEVER BE REUSED. IMMEDIATELY AFTER INSTALLING THE DISHWASHER, PERFORM A QUICK TEST OF THE APPLIANCE. IF THE DISHWASHER FAILS TO OPERATE CORRECTLY, DISCONNECT IT FROM THE ELECTRICAL POWER SUPPLY AND C...
Page 5 - CLEANING AND REGULAR MAINTENANCE OF THE APPLIANCE BY
User instructions 5 THE DISHWASHER MEETS ALL THE REQUIREMENTS SET OUT BY THE REGULATIONS IN FORCE CONCERNING SAFETY AND ELECTRICAL EQUIPMENT. ANY TECHNICAL CHECKS SHOULD BE CONDUCTED EXCLUSIVELY BY TRAINED AND AUTHORISED TECHNICIANS: REPAIRS CARRIED OUT BY UNAUTHORISED PERSONS WILL INVALIDATE THE WA...
Page 6 - THE SYMBOL OF A CROSSED OUT WHEELIE BIN; TECHNICAL DATA
User instructions 6 IN ACCORDANCE TO ART. 26 OF THE LEGISLATIVE DECREE 14 MARCH 2014, NR. 49 “IMPLEMENTATION OF THE DIRECTIVE 2012/19/EU ON WASTE OF ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE)”. THE SYMBOL OF A CROSSED OUT WHEELIE BIN ON THE DEVICE OR PACKAGE SHOWS THAT THE PRODUCT MUST BE COLLECTED ...
Page 7 - Building-in a dishwasher underneath a hob is
User instructions 7 2. Installation and hook-up Remove the polystyrene basket retainers. Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit th...
Page 8 - Water supply connection; Preventing the risk of clogging or damage:
User instructions 8 2.1 Water supply connection Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supply check that the water is clear and free of impurities, to prevent damage to the appliance. The dishwasher mus...
Page 9 - DRAIN CONNECTION
User instructions 9 DRAIN CONNECTION Insert the dishwasher’s drain hose into a drain pipe having a diameter of at least 4 cm , or alternatively, place it inside the kitchen sink using the plastic support provided, taking care not to crush or excessively bend the hose. It is important to prevent the ...
Page 10 - Electrical connection and precautions; BRACKET
User instructions 10 2.2 Electrical connection and precautions CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR. THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SAME TYPE...
Page 11 - Description of the controls; Upper panel; Press this button to switch the dishwasher on/off.
User instructions 11 3. Description of the controls 3.1 Upper panel All the dishwasher controls are grouped on the upper panel. Switch-on, programming, switch-off, etc. procedures are only possible when the door is open. The panel shown is only a guideline example: the form of the lights and buttons...
Page 12 - SETTING THE WASHING PROGRAM AND SWITCHING ON
User instructions 12 SETTING THE WASHING PROGRAM AND SWITCHING ON After identifying the most suitable program with the aid of the programs table: Press the ON/OFF button (1) and wait for the PROGRAM INDICATOR LIGHT (2) to illuminate; Keep pressing the PROGRAM SELECTION button (3) until the indic...
Page 13 - ULTRA
User instructions 13 PROGRAMME NUMBER & SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS DURATIO N CONSUMPTION MINUTES (1) WATER LITRES POWER kWh (1) 1 RAPID 27’ Dishes with light dirt, washed immediately after use Wash at 38°C Rinse at 50°C 27 6,5 0,70 2 NORMAL ECO (*) Crockery and cutlery nor...
Page 14 - Notice for testing institutes; (see relevant section for explanation of functioning modes)
User instructions 14 Notice for testing institutes Testing institutes are provided with guidelines for comparative tests (e.g. according to AS/NZS 2007). request the guidelines by contacting us at the following e-mail address: [email protected] When making a request, please specify the model (MOD) a...
Page 15 - Washing programs
User instructions 15 3.2 Washing programs Before starting a washing program make sure that: The water supply tap is open . The softener container contains regenerating salt . The correct amount of detergent has been added to the dispenser . The baskets have been correctly loaded . The spra...
Page 17 - above
User instructions 17 “Flexi Tabs” Ideal for multi-function detergents, this option allows washing to be optimised, with full benefits from the combined-action tablets. When this option is activated, any salt and rinse aid in the relative containers will not be used. With short programs, because ther...
Page 18 - TO SAVE ON ENERGY! ... AND PROTECT THE ENVIRONMENT
User instructions 18 TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT Always use the dishwasher with a full load . Do not wash the dishes in running water. Use the washing program that is most appropriate for each type of load. Do not carry out any preliminary rinsing. If available, connec...
Page 19 - Operating instructions; Adjust the water softening system; Using the water softening system; 0 washing cycles
User instructions 19 4. Operating instructions Once the dishwasher has been correctly installed, prepare for use as follows: Adjust the water softening system; Add the regenerating salt; Add the rinse aid and detergent. 4.1 Using the water softening system The amount of scale contained in the ...
Page 20 - as it contains insoluble substances which, over
User instructions 20 Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. When necessary, refill the regenerating salt container before starting the washing program . In this way, the excess saline solution will be immediately removed...
Page 21 - WATER HARDNESS TABLE; WATER HARDNESS; Using the rinse aid and detergent dispensers; detergent
User instructions 21 WATER HARDNESS TABLE WATER HARDNESS SETTINGS German degrees (°dH) French degrees (°dH) 0 – 6 0 – 11 H0 All lights off (no salt) 7 – 10 12 – 18 H1 One light on 11 – 15 19 – 27 H2 Two lights on 16 – 21 28 – 37 H3 Three lights on 22 – 28 38 – 50 H4 Four lights on 29 - 50 51 – 90 H5...
Page 22 - ADDING THE RINSE AID
User instructions 22 ADDING THE RINSE AID The rinse aid helps the dishes dry faster and prevents the formation of scale deposits and staining; it is automatically added to the water during the final rinse cycle, from the container situated on the inner side of the door. To add rinse aid: Open the ...
Page 23 - ADJUSTING THE RINSE AID DISPENSER MODE; RINSE AID ADJUSTMENT TABLE; The amount of rinse aid must be
User instructions 23 ADJUSTING THE RINSE AID DISPENSER MODE Press and hold the PROGRAM SELECTION button (3), after about 15" the salt indicator flashes; keep still pressed until the RINSE AID DISPENSER MODE INDICATOR LIGHT (5) flashes and the SELECTED PROGRAM LIGHTS (2) indicate the current sett...
Page 24 - ADDING THE DETERGENT
User instructions 24 ADDING THE DETERGENT To open the detergent dispenser cover, lightly press button P . Add the detergent or tablet and close the cover by sliding it until it stops, indicated by a click. The dispenser will open automatically during the wash cycle. Only add the detergent (also in t...
Page 25 - General warnings and recommendations
User instructions 25 The introduction of detergent into the rinse aid dispenser, even in liquid form, will damage the dishwasher. 4.3 General warnings and recommendations Before using the dishwasher for the first time, it is advisable to read the following recommendations concerning dish types to be...
Page 26 - MAKE SURE that the items being washed are dishwasher-safe.
User instructions 26 WARNING! Make sure that the dishes are securely in place so that they cannot tip over or obstruct the rotation of the spray arms during the washing cycle. Do not place very small objects in the baskets as these could fall and obstruct the spray arms or the wash pump. Conta...
Page 27 - Using the baskets; The dishwasher has a capacity of
User instructions 27 4.4 Using the baskets The dishwasher has a capacity of 15 place-settings , including serving dishes. LOWER BASKET The lower basket receives the full force of the lower spray arm, and should therefore be used for the “toughest” items with a heavier degree of soiling. All types an...
Page 28 - glass holder
User instructions 28 Supports for cups and long objects (ladles, spoons, etc.), in the rear; can be tipped to the vertical position when not in use. Glass holder. Support for long- stem glasses. When lifted out of the stowed position (0) it snaps into three different positions (1-2-3). 2-position fo...
Page 29 - rotates into place above point
User instructions 29 To lie completely flat, lift the end and turn it towards you so that the retainer F rotates into place above point S . LOADING THE LOWER BASKET Carefully load flat plates, soup plates, dessert and serving dishes, positioning them vertically. Pots, pans and their covers must be l...
Page 30 - UPPER BASKET
User instructions 30 UPPER BASKET The upper basket should be loaded with small or medium-sized items such as glasses, small plates and saucers, tea or coffee cups, shallow bowls and light objects. If the upper basket is used in the lowermost position, it can also be loaded with serving dishes, provi...
Page 32 - TOP CUTLERY BASKET (on some models only)
User instructions 32 TOP CUTLERY BASKET (on some models only) The basket is designed to take cutlery, placed in the spaces provided, long utensils, positioned lengthwise and small items. The “drawer” extraction system makes the basket easier to load, but it can also be taken completely off its runne...
Page 33 - EXAMPLES OF LOADING FOR INTENSIVE DIRT
User instructions 33 EXAMPLES OF LOADING FOR INTENSIVE DIRT 13 Standard place setting TOP RACK (on some models only) If the bottom basket inserts are of the fold-down type, they should be laid flat for easier loading.
Page 34 - Shelves with expandable wings
User instructions 34 UPPER BASKET EQUIPMENT (depending on the model) Fold-down shelves For mugs, cups and long objects. The ends are designed to hold long stemmed glasses When not used they can be moved to a vertical position (until a click is heard). Shelves with expandable wings For small objects,...
Page 36 - ADJUSTING THE UPPER BASKET
User instructions 36 ADJUSTING THE UPPER BASKET The height of the top basket can be adjusted to allow large dishes or pans to be placed in the bottom basket. The sides of the basket must always be set at the same height . Raise the basket by pulling on the top edge (1) , to the first or second cat...
Page 37 - Cleaning and maintenance; ORBITAL
User instructions 37 5. Cleaning and maintenance Before carrying out any work, always unplug the appliance from the electrical supply or switch off the all-pole disconnection device. 5.1 General warnings and recommendations Avoid the use of acidic or abrasive detergents. Clean the outer surfaces and...
Page 38 - CLEANING THE FILTER UNIT
User instructions 38 CLEANING THE FILTER UNIT It is advisable to periodically inspect the centre filter C and, if necessary, to clean it. To remove the filter, grip the tabs, turn them anticlockwise and lift upwards; push the centre filter D from the underside to remove it from the micro- filter...
Page 39 - Plug the power cord
User instructions 39 BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE: Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the water to run from the water supply tap for a few minutes. Plug the power cord back into the socket. Reconnect the water ...
Page 40 - there is rinse aid inside the special container
User instructions 40 If the dishes fail to dry or remain dull, check that: there is rinse aid inside the special container; the rinse aid dispenser setting is correct; the detergent used is of good quality and has not lost its effectiveness (for example, through incorrect storage, with the box...
Page 41 - If the door does not close:
User instructions 41 If the door does not close: 1 - Check the position of the door lock catch (D) 2 - If necessary , raise it by adjusting the plastic screw (V) next to the catch. 3 - Check the condition of the lock hook; if it has not triggered (reference N ), the door opens and closes normally. I...
Page 44 - FAULT; Light off
User instructions 44 FAULT DESCRIPTION E7 Turbine flow-regulator malfunction (for the relevant models only) The appliance is not able to "measure" the amount of water loaded accurately. Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program it again and s...