Siemens WM14Y591GB - Manuals

5 Safety instructions m Warning! Danger of death from electric shock! Danger of death if live parts are touched. – Never pull out the mains plug by tugging the power cord. – Insert/pull out the mains plug with dry hands only. m Warning! Risk to children! – Do not leave children unsupervised near the...

7 Protection of the environment Packaging/Old appliance Hints and tips Ø Utilise the maximum amount of washing for the particular programme. Ø Wash normally soiled washing without Pre-wash. Ø Energy saving mode: The display panel light goes out after several minutes, Start/Reload Ü flashes. To activ...

8 The main points in brief 1 @ @ @ Insert mains plug. Turn the tap on. Open the washing machine door. To switch on, press the # button. Select the programme, e.g. Cotton . 2 @ @ Sort the washing. Insert the washing. Do not exceed maximum load. 3 @ @ Open the detergent drawer. Dose detergent accordin...

9 Getting to know your appliance 'HWHUJHQWGUDZHU FODFN 2SHUDWLQJ HOHPHQWV 'LVSOD\ HOHPHQWV 'UXPOLJKW GHSHQGLQJ RQPRGHO 'RRU 6HUYLFHIODS 2SHQLQJ DQGFORVLQJWKHGRRU 6HUYLFHIODS

10 Detergent drawer Dispenser I Detergent for prewash Dispenser i Softener, starch. Do not exceed the maximum load. Dispenser II Detergent for main wash, water softener, bleach, stain remover Insert A for dosing liquid detergent (not for all models) For models with insert for liquid detergent: The d...

11 Operating elements/Display elements L M V K N O P Q R S T U ² All buttons are sensitive, they only need to be touched gently. i Press the main switch # button. Switch on and off the appliance. j Programme selector can be rotated in either direction. Programme overview refer to ~ Page 22 Programme...

12 Operating the appliance Before each washing ² – Install and connect washing machine properly . Refer to ~ Page 42 – Before the 1st wash, wash once without any washing. ~ Page 52 1. Preparing the washing Sorting the washing according to: Ø Type of fabric/fibre. Ø Colour. Ø Soiling. Ø Follow manufa...

14 4. Select the programme.You can use the displayed programme or select another programme. Programme overview, refer to ~ Page 22 5. Insert laundry The load screen for the selected programme (e.g. for Cotton) is indicated on the display panel. The load screen is indicated when the door is opened or...

15 3 = 60 % 4 = 75 % 5 = 100 % – Soiling,– Water hardness ( depending on model can be determined using enclosed water hardness strip or is available from your water utility company). – Manufacturer’s instructions. ² – When dosing all detergents, cleaning aids, cleaning products and cleaning agents, ...

17 Other settings can be selected depending on the model, e.g. Rinse Hold $ button: When selected, the button indicator lamp is lit and a corresponding symbol is indicated on the display panel:Button Less Ironing – { Button Prewash – ! Button Extra Rinse – « + Ë , Ì , Í (Rinse cycles) Button Rinse H...

18 Washing Programme sequence While the programme is running, the programme progress is indicated on the display panel via corresponding symbols and a progress bar. The bar progresses in the course of the wash cycles. The combined symbol Æ indicates the following programme states: ¿ Pre-wash ¼ Wash ...

20 Ø End of programme by Rinse Hold $ . Programme stops in the last rinse cycle. – Select Start /Reload Ü . The programme continues with the drain and spin cycles (if required change spin speed). – If only the drain cycle, but not the spin cycle, is required, select and start the Empty programme. En...

21 After washing 1. Open washing machine door and remove washing. ² – Do not leave any items of washing in the drum. In the next wash they may shrink or discolour something else. – Remove any foreign objects from the drum and the rubber seal – risk of rust. – Leave detergent drawer and door open so ...

26 Programme settings Depending on the programme, you can use the programme settings to adjust the washing process even more efficiently to your items of washing. Programme settings: ² – are active without acknowledgement. – not retained after appliance is switched off. – can be selected or deselect...

28 Consumption values Programme Load Energy consumption ** Water ** Programme duration ** Cotton 20 °C 8 kg 0,25 kWh 57 l 2 ^ h Cotton 40 °C 8 kg 1,09 kWh 57 l 2 _ h Cotton 60 °C 8 kg 1,43 kWh 57 l 2 _ h Cotton 90 °C 8 kg 2,40 kWh 69 l 2 ^ h Easy-Care 40 °C 4 kg 0,65 kWh 46 l 2 h Mixed Fabrics 4 kg ...

29 Appliance settings The Basic Settings 3 sec. buttons (Spin + and Finished in +) can be used to change the set values of the appliance settings, e.g. the volume of the button signals.Simultaneously hold down Basic Settings 3sec. buttons for approx. 3 seconds: Ø The access menu for changing the app...

30 Sensors – Your washing machine is so intelligent Load adjust Depending on the type of textile and load, the load adjust optimally adjusts the water consumption in each programme. Aqua-Sensor depending on model During the rinse cycle the Aqua sensor checks the degree of turbidity (turbidity is cau...

31 Cleaning and maintenance Care and maintenance m Warning! Danger of death from electric shock! Danger of death if live parts are touched. Switch off the appliance. Pull out the mains plug! m Caution!Fire and explosion hazard! If solvent cleaning agents, e.g. petroleum ether, are used in the washin...

32 Cleaning the detergent drawer If it contains detergent or fabric softener residue: 1. Pull out, depress insert, take out drawer all the way. 2. Take out insert: using your finger, press insert upwards. 3. Clean detergent dispenser and insert with water and a brush and dry. 4. Attach insert and lo...

33 4. Take the drainage hose out of the holder. Remove the sealing cap, drain water into a suitable receptacle.Press on sealing cap and insert drainage hose into the holder. Note: Residual water may run out. 5. Carefully unscrew the pump cover. Clean the interior, pump cover thread and pump housing ...

34 Filter blocked in water inlet hose First, release water pressure in the supply hose: 1. Turn off the tap! 2. Select any programme (except Spin/Drain). 3. Select Start /Reload Ü . Leave programme for approx. 40 seconds. 4. Press the # button. Appliance is switched off. Pull out the mains plug! 5. ...

35 Emergency release The programme continues running when the power supply is restored. If the washing is still to be removed, the door can be opened as described below: m Warning! Danger of scalding! Wash liquor and washing may be hot. If touched, there is a risk of scalding. If required, leave to ...

36 Information on the display panel Display Cause/Remedy CLOSE DOOR – Washing may be caught. Please open and close washing machine door again and select Start /Reload Ü . – If required, shut washing machine door or remove washing and shut again. – If required, switch appliance off and on again; set ...

39 Customer service If you cannot rectify the fault yourself, Faults, what to do? ~ Page 37 , please contact our customer service. We will always finds a suitable solution to avoid unnecessary visits by technicians.Please give customer service the product number (E-Nr.) and the production number (FD...

40 Installing the appliance Standard accessories Also required for connection of the water drainage hose to a siphon: 1 hose clip Ø 24–40 mm (DIY store) is also required for connection to a siphon. Connecting the water ~ Page 49 Useful tools: Ø Spirit level for alignment. Ø Socket wrenchsize 13: for...

41 Hose and cable lengths ² If the hose holders are used, the possible hose lengths are reduced! Available from dealer/customer service: Ø Extension for Aqua-Stop or cold water inlet hose (approx. 2.50 m).Order no. WMZ2380, WZ10130, CZ11350, Z7070X0 Ø Longer supply hose (approx. 2.20 m), for standar...

42 Installation ² Humidity in the drum is caused by the final inspection. Secure installation m Warning! Risk of injury! – The washing machine is heavy – caution: take care when lifting it. – If the washing machine is raised by protruding components (e.g. washing machine door), the components may br...

43 m Warning! Risk of injury! – The washing machine is heavy – caution: take care when lifting it. – If the washing machine is raised by protruding components (e.g. washing machine door), the components may break off and cause injuries. Do not lift the washing machine by its projecting parts. m Caut...

44 Installing the appliance on a base or on a wooden joist ceiling m Warning! Washing machine may be damaged!! The washing machine may wander during the spin cycle and topple/fall off the base. Always secure the washing machine feet with fixing brackets. Holding brackets: order no. WMZ 2200, WX 9756...

47 Connecting the water m Warning! Danger of death from electric shock! Danger of death if live parts are touched. Do not immerse Aqua-Stop safety device in water (contains an electric valve). ² – To prevent leakage or water damage, follow the instructions in this chapter! – Operate the washing mach...

48 on the appliance: for Standard and Aqua-Secure models 2. Carefully turn on the tap and check that the connection points are not leaking. ² Screw connection is under water pipe pressure. Water drainage hose ² – Do not kink or protract the the water supply hose. – Height difference between the plac...

49 Drainage into a siphon m Warning! Water damage possible! If the drainage hose slips off the siphon connection due to high water pressure when draining the washing machine, leaking water may cause damage. Connection point must be secured with hose clip, Ø 24–40 mm (specialist outlet). Connecting D...

50 Alignment 1. Loosen lock nut in a clockwise direction with a wrench. 2. Check alignment of the washing machine with a spirit level and, if required, correct. Adjust the height by rotating the foot. ² All four feet must be firmly on the floor.The washing machine must not wobble! 3. Tighten the loc...

51 Electrical connection Electrical safety m Warning! Danger of death from electric shock! Danger of death if live parts are touched. – Never pull out the mains plug by tugging the power cord. – Insert/pull out the mains plug with dry hands only. – Never pull out the mains plug during operation. – C...

52 Before the 1st washing The washing machine was inspected thoroughly before leaving the factory. To remove any water left over from testing procedures, the first washing cycle should be carried out without laundry in the machine. ² The washing machine must have been installed and connected properl...

53 Transportation, e.g. if moving house Preparatory work 1. Turn off the tap. 2. Release the water pressure in the supply hose. Maintenance – Filter in the water inlet hose ~ Page 34 3. Drain any residual detergent solution. Maintenance – Drain pump blocked ~ Page 32 4. Isolate the washing machine f...

54 Index A Alignment, 50 Aqua-Sensor, 30 B Basic Settings 3 sec., 11, 29Button ecoPerfect ¦ , 11, 16, 26 Extra Rinse, 11, 17, 27Finish in, 11, 16, 26Less Ironing, 11, 17, 26Prewash, 11, 17, 27 Rinse Hold, 11, 17, 27speedPerfect G , 11, 16, 26Spin, 11, 16, 26Start/Reload, 11Temperature, 11, 16, 26 C ...