Siemens ME45 - Manuals

Level 2 Service Guide Introduction This chapter serves as a guideline to help the respective service personnel in the repairing of S45/ME45 mobile phones up to Level 2. The repair for S45 and ME45 are identical unless otherwise noted, therefore the description herein is confined to S45 only. S45/ME4...

S45/ME45 Technical Information Features System/Standards D U A L B A N D E G S M 9 0 0 / G S M 1 8 0 0G S M P H A S E 2 / P H A S E 2 + & G P R S Speech Codec Triple Rate (HR/FR/EFR) Display High resolution graphical display with 7 lines x 16 characters (101 x 80 pixels) with extreme high contra...

Dictaphone Exciting gamesAvailable colour variants: Sapphire Blue, Diamond Silver (vary country by country)High speed data transfer, speedy internet access using GPRSBuilt-in dictionary Technical Data • GSM Phase 2+ specification • Dual band EGSM specification : 880MHz ~ 960MHz GSM 1800 specificatio...

• 850 mAh Li-Ion battery (standard) L36880-N4501-A100 • Car cradle standard L36880-N4501-A102 • Car cradle with antenna cap L36880-N4501-A103 • Belt Clip L36880-N4501-A105 • Plug-In power Sup Euro S45 L36280-Z4-C351 • Plug-In power Sup UK S45 L36280-Z4-C352 • Desktop Charger L36880-N4501-A101 • Car ...

General Information Due to different requirements of the markets, the S45/ME45 has different variants, which broadly classified under International version and Asian version. Marketing name for international version is S45 and ME45, whereas Asian version for S45 is 6618 and for ME45 is 3618. The Asi...

S45 Exploded Diagram Upper Case Shell S45 Silver L36158-A56-A1 Dark Blue L36158-A56-A2 Cushion (Display) S45 L36158-A56-C32 Keypad S45 Silver L36158-A56-B600 Dark Blue L36158-A56-B601 Display Module S45 L36851-Z1508-A80 RF Control Board S45 L36880-A4500-B10 6618 L36880-A4500-B33 Vibra-Alert Unit L36...

FIGURE 2 S45 EXPLODED DIAGRAM. ME45 Exploded Diagram Upper Case Shell ME45Grey-Beige L36158-A55-A11 Grey-Black L36158-A55-A7 Cushion (Display) ME45L36158-A55-C32 PCB for KeypadL36880-Q4595-A2 RF Control BoardME45 L36880-Q4600-B103618 L36880-Q4600-B33 Vibra-Alert UnitL36453-Z5-C109 Lower Case Shell M...

Figure 2.1 ME45 EXPLODED DIAGRAM Please take note that the number(s) used here IS NOT the part number, DO NOT used it in your spare parts purchase order. A l w a y s r e f e r t o t h e S E R V I C E P A R T P R I C E L I S T f o r s p a r e p a r t s o r d e r i n g . Mechanical Concept Note: All p...

The displays will be shipped as complete modules from the suppliers. The design consists of the LCD-cell with a Tape Chip Carrier foil (TCP) and the lightguide. The LEDs for the backlight will be placed on the K45 PCB. The display controllers will be driven with a supply voltage of VDD = 2.65V. For ...

Power Supply and Integrated Charging Overview of HW Structure All the important functions for the power supply of the phone are carried out by the supply ASIC. The POWER-pin of the I/O-Connector is for charging the battery with an external power supply. For accessories which provide a variable charg...

voltage collapses so much that the mobile phone switches off again. In this case trickle charging starts again with a now raised threshhold voltage of 3.75V instead of 3.2V, at maximum for 20 minutes. • A phone with a fully charged Li-Ion battery cannot be supplied in the standby or talk modus in th...

Deep Discharge In case of a deeply discharged battery, the phone can not be turned on and the normal charging process can not be started. In this case, charging the battery is divided into two different steps, which have to be run subsequently: a) Trickle charge Trickle charge mode is automatically ...

Dis-assembling the S45/ME45 A case opener is needed to disengage the latch of the S45/ME45 casing. This case opener is exactly the same as the P35 Series. PHOTO 2.2 S4/ME45 CASE OPENER The part number for this mandatory tool is F30032-P46-A1 Refer to ANNEX B of Chapter 3 for Service Equipment List. ...

Photo 2.4. Battery compartment Photo 2.5 Battery Removing Remove the Battery from the right handside for the compartment as shown in PHOTO 2.5. Photo 2.6 Backview The above photo shows the backview of the battery compartment STEP 3: Photo 2.7 Opening Opening the housing with the case opener and care...

Photo 2.8 Lower case removng Remove the lower casing as shown in PHOTO 2.8 STEP 5: Photo 2.9 RF board removing Remove the RF board from the upper casing as illustrated in PHOTO 2.9

STEP 2: Photo 2.17 LCD latches Fasten the display to the RF board and by snapping the side latches as shown in PHOTO 2.17. In order to position the display exactly, the synthetic projection on the lower side of the display frame must be fitted into the hole in the screen lid. The catches must fully ...

STEP 6: Photo 2.23 Top assembly Photo 2.24 Bottom assembly Secure the upper and the lowercase shell by snapping the upper part (PHOTO 2.23) and next the lower part (PHOTO 2.24). P r e c a u t i o n m u s t b e t a k e n s e r i o u s l y t o m a k e s u r e a l l c o m p o n e n t s h a v e b e e n ...

STEP 8: Photo 2.27 Battery placement Photo 2.28 Battery compartment Insert the battery by sliding it sideway first (PHOTO 2.27) and secure the battery into the compartment as illustrated in (PHOTO 2.28). STEP 9: Photo 2.29 Battery cover closing Close the battery cover by sliding the lid into the low...

Yes The mobile equipment is uniquely identified by the International Mobile Equipment Identity, IMEI, which consists of 15 digits. Type approval granted to a type of mobile is allocated 6 digits. The final assembly code is used to identify the final assembly plant and is assigned with 2 digits. 6 di...

Language Groups There are over 20 languages for the S45/ME45 in total. These languages are divided into groups as follows Language groups K45 Languages Tegic Languages LG 1 International English, German, French, Turkish, Dutch, Italian, Arab English, German, French, Turkish, Dutch, Italian LG 2 Nord...