Siemens ER59553EU - Manuals

9 Installation (for the installer) Picture 1 Picture 2 Installation must be made by a kitchen installation expert. Note: If you intend to have the gas hob welded into a stainless steel worktop, for safety reasons and in order to fully maintain the requirements of your Siemens warranty, we recommend ...

12 Gas connection (for the fitter) The gas supply system must comply with the local standards in the country in effect. Attach the elbow coupling to the appliance gas supply, using the seal provided. Your hob is pre-mounted with the connection ISO 7-1. In order to change the elbow coupling (see pict...

15 Caution Only switch on the circuit breaker or main switch once the appliance has been installed. The appliance must be installed in the furniture in accordance with these operating, installation and maintenance instructions. It is important to note that we shall accept no liability for damage whi...

16 Converting the burners to another type of gas (for the fitter) Changing the nozzles Nozzles for conversion to LPG are provided with this appliance or can be obtained from the after sales service (see list included). Prior to making the necessary adjustments, the hob must be disconnected from the ...

17 Nozzle table REGULATION OF MINIMUM FROM NG TO LPG 1. Light the burner and turn the knob to the minimum position. 2. Remove the knob from the tap 3. Introduce a small screwdriver in hole B (picture 6) and tighten the adjusting screw completely (taking care not to turn the shaft of the tap). Check ...

18 2. OPERATION This is your new hob 1 Control knobs 2 Auxiliary burner, 1.0 kW 3 Semi - Rapid burner, 1.75 kW 4 Rapid burner, 2,7 kW 5 Triple Crown Wok burner, 3.5 kW Gas tap This control is used to make the heat setting of the gas burner. "Small flame" = lowest setting "Large flame"...

20 3. WHAT TO LOOK OUT FOR A few tips on pots Always use the correct pan for the correct burner! Do not use small pots or pans on large burners. Please see the below table for the correct pot sizes. Recommended pan diameter Auxiliary burner 60 - 140 mm Semi-Rapid burner 150 - 200 mm Rapid burner 210...

22 4. CARE AND CLEANING How to care for your gas hob: Cleaning If cared for properly, your gas hob will continue to look good for a long time, and cleaning will also be easier. Use a sponge and soapy water (or a specialist cleaning product) to care for stainless steel components, but always wait unt...

23 Your burner and burner cap • You should only start to clean the burner cap once it has cooled to its normal temperature after use, i.e. when you can touch it with your bare hand. • The burner cap should be cleaned with hot water and a normal cleaning agent, using a soft sponge or cloth. • If the ...

26 After-sales service Our after-sales service is there for you if your hob should need to be repaired. You will find the address and telephone number of your nearest after-sales service centre in the phone book. The after-sales service centres listed will also be happy to advice you of a service po...

28 Service If you should contact our Customer Service, please state E- and FD-number of your gas hob. Siemens-Electrogeräte GmbH Carl-Wery-Str. 34 D-81739 München 10.2007