Page 2 - Index
Page 2 Index 1. Welcome 3 Your State Regulatory Authority 3 2. Important Safety Information 4 Before Installation 5 Product Use 6 Ducted or Recirculating? 6 Maintenance and Service 6 Electrical Cord 6 3. Description 7 Rangehood 7 4. Operation 8 Remote Control and Buttons 8 Speed Control 8 5. Cleanin...
Page 3 - Welcome; Your State Regulatory Authority
Page 3 1. Welcome Thank you for purchasing your new Schweigen rangehood. To get the maximum output from this unit, please read through this guide before use. The guide contains important information on the use and maintenance of the unit, as well as important safety notes. This will ensure your pers...
Page 4 - Important Safety Information; WARNING
Page 4 2. Important Safety Information WARNING Please read this section thoroughly before attempting to operate the appliance. Inspect your product upon receipt. Any damage or defects MUST be reported within 48 hours, or no claim will be recognised. DO NOT INSTALL THIS APPLIANCE IF YOU FIND IT DAMAG...
Page 5 - Before Installation
Page 5 2. Important Safety Information Before Installation 1. We recommend this appliance be installed or repaired by a qualified Schweigen Home Appliances technician. 2. Please see our website www.schweigen.com.au for recommended installers. 3. It is dangerous to modify any part of this appliance. ...
Page 6 - Product Use; Ducted or Recirculating?
Page 6 2. Important Safety Information Product Use This product is designed for household use and should not be used for commercial applications. After use, always ensure that all controls are in the “OFF” position. When frying with a gas flame, take particular care not to allow the oil or grease in...
Page 7 - Description; Rangehood; Important
Page 7 3. Description Rangehood 1. For use with Isodrive ® motor system 2. Male plug (main power 240V) 3. 2x main 200mm outlet 4. 3 x 150mm Outlets (optional only)* (Square to round outlet adaptor YT202.1000.04 are ordered separately) 5. Remote 6. Reducer (For Isodrive ® 650 only) 7. Light 8. Filter...
Page 8 - Operation; NOTE
Page 8 Schweigen silent rangehoods are recognised for their silent operation. Although this holds true for all of our rangehoods with external motors, one must note that the rangehoods are silent when they are used for regular cooking on the lower fan setting. Therefore, you will only hear the movem...
Page 9 - Cleaning & Maintenance; Surfaces; Warning
Page 9 5. Cleaning & Maintenance Surfaces Wash with warm soapy water and a soft sponge. Never use abrasive detergent, scouring pads, steel wool or solvents on any part of this appliance, Always make sure to dry the appliance after cleaning and never leave wet, as this will cause irreparable dama...
Page 10 - Cleaning the Interior; OK
Page 10 5. Cleaning & Maintenance Cleaning the Interior Clean the interior of the rangehood with a damp cloth and a neutral detergent or denatured alcohol. NOTE: Do not use denatured alcohol on the exterior of the rangehood. Do not clean the electric parts or the motor with liquids or solvents C...
Page 11 - Replacing the Lights
Page 11 5. Cleaning & Maintenance Replacing the Lights Danger Always switch off and disconnect power before replacing the lights. Failure to do so may cause serious injury. Please be aware that the light bulb may retain heat for a short period of time after being switched off. Step 2 Gently turn...
Page 12 - Installation; Rangehood Size vs Cooktop Size
Page 12 6. Installation Rangehood Size vs Cooktop Size In addition to the size, the height of the rangehood above the cooktop is important to obtain the best performance. INADEQUATE Rangehood smaller than cooking zone ADEQUATE Rangehood same size as cooking zone OPTIMAL Rangehood larger than cooking...
Page 13 - In addition to the information in this manual,
Page 13 6. Installation MINIMUM 1200mm Optimal 1500mm MAXIMUM 1800mm 900mm * Important: In addition to the information in this manual, please check all relevant state requirememnts for minimum– maximum heights, as well as regulations regarding the expelling of air. Schweigen is not liable if your ra...
Page 14 - DANGER
Page 14 6. Installation DANGER Always switch off and disconnect the power supply before installing the rangehood. Failure to do so may cause serious injury. WARNING Please remove filters before installation. Failure to do so may damage the clips. Ceiling Cassette Installation Guide • To install the ...
Page 16 - Single Isodrive
Page 16 6. Installation Single Isodrive ® Motor Installation 1. Isodrive ® Motor 2. Roof Seal Kit (Dektite) (Not supplied)* 3. Support Straps (Not supplied)* 4. Attach Flexi Duct to Bell-Mouth Adaptor using ring clamp. Please DO NOT rip the ducting. 5. Isodrive ® Motor Power Lead (Male Plug) 6. Rang...
Page 17 - Twin Isodrive
Page 17 8 9 6. Installation Twin Isodrive ® Motor Installation 1. Isodrive ® Motors 2. Roof Seal Kit (Dektite) (Not supplied)* 3. Support Straps (Not supplied)* 4. Attach Flexi Duct to Bell-Mouth Adaptor using ring clamp. Please DO NOT rip the ducting. 5. Isodrive ® Motor Power Lead (Male Plug) 6. R...
Page 18 - Ducting
Page 18 6. Installation Ducting Please DO NOT crush or kink the ducting. 1. Crushed or kinked ducting creates sharp corners that creates turbulence. This reduces the size and efficiency of the ducting, lowers extraction and may cause excessive noise. 2. Sweeping curves and taut ducting reduces resis...
Page 19 - Condensation Information; Cooking with Induction Cooktops
_n_. _RH Section_ Page 19 7. Condensation Information Cooking with Induction Cooktops Cooking with an induction or similar cooktop, may produce condensation on the rangehood. Unlike basic electric or gas cooking, induction cooktops heat food and liquid instantly, which in turn, produces vapours rapi...
Page 20 - Troubleshooting; IMPORTANT
_n_. _LH Section_ Page 20 8. Troubleshooting Before you contact the technical service department, make sure that the product is plugged in and power is supplied. • Do not take any action that will damage the product. Check electric c onnection. V oltage o f the electric ne tw ork should be be tw een...
Page 21 - Faulty Installation
_n_. _RH Section_ Page 21 8. Troubleshooting Faulty Installation It is not the responsibility of Schweigen to rectify any incorrect installations. A service call out fee will be charged for any Schweigen technician that attends a call, whereby it is established that the fault is due to an incorrect ...
Page 22 - Specifications; Technical Specifications; Dimensions
_n_. _LH Section_ Page 22 9. Specifications Technical Specifications Model UM4220-12S Feeding Voltage 220-240V 50Hz Lamp Power – Halogen (W) 6 x 35W (Supplied) Lamp Power – LED (W) 6 x 3.5W (Optional) Dimensions 1156 655 700 1200 179 66 179 655 700
Page 23 - Disclaimer
_n_. _RH Section_ Page 23 10. Disclaimer Disclaimer Under our policy of continuous product development, product specifications may change without notice. Prospective purchasers should therefore check with the retailer to ensure this publication correctly describes the products being offered for sale...