Schweigen GA-900SPPAK - Manuals

Schweigen GA-900SPPAK Range Hood – User Manual in PDF format online.

Manuals:

User Manual

User Manual Schweigen GA-900SPPAK

Summary

Page 2 - WELCOME; place so you can refer to it at any time.; must be reported within 48 hours

Page 2 WELCOME Thank you for purchasing this Schweigen IN appliance.To achieve the optimal performance from your appliance, and to avoid the risk of accident or damage, it is essential to read this manual before installation and first time use.This guide contains important information on the use and...

Page 3 - TABLE OF CONTENTS

Page 3 TABLE OF CONTENTS Important safety information ................................................................................................................ 4 Description ..........................................................................................................................

Page 4 - IMPORTANT SAFETY INFORMATION

Page 4 IMPORTANT SAFETY INFORMATION Please read the instructions carefully. Only then will you be able to operate your appliance safely and correctly. Retain the instruction manual for future use or for subsequent owners. Check the appliance for damage after unpacking it. Do not connect or install t...

Page 6 - INADEQUATE; MATCH THE RANGEHOOD SIZE TO YOUR COOKTOP

IMPORTANT SAFETY INFORMATION Page 6 Rangehood smaller than cooking zone INADEQUATE Rangehood same size as cooking zone ADEQUATE Rangehood larger than cooking zone OPTIMAL MATCH THE RANGEHOOD SIZE TO YOUR COOKTOP It is important to make sure the rangehood is the correct size, the larger the surface a...

Page 7 - DESCRIPTION

Page 7 KLS-9GLASS and KLS-9GLASSBLKS 1. Female plug, to be connected to Isodrive motor system only 2. Male Plug, to be connected to main power 240V3. Single 200mm Outlet4. Computer board*5. Reducer6. Filter7. Cabinet door protection strip8. Light9. Rangehood mounting brackets10. Instruction and scre...

Page 8 - INSTALLATION; motor to the rangehood should; SYSTEM OVERVIEW; DO NOT crush or kink the ducting.

Page 8 INSTALLATION DANGERAll electrical wiring from the motor to the rangehood should be kept inside the roof space. SYSTEM OVERVIEW 1. Isodrive Motor2. Roof Seal Kit (Dektite)*3. Support Straps*4. Attach Flexi Duct to Bell-Mouth Adaptor using cable tie or ring clamp. Please DO NOT rip the ducting....

Page 9 - MOUNTING LAWS AND REGULATIONS

Page 9 INSTALLATION MOUNTING LAWS AND REGULATIONS • The location of rangehood installation must have permanent openings for ventilation.• Regulations concerning the expelling of air must be fulfilled.• It is STRONGLY RECOMMENDED that the rangehood be installed centrally over the cooktop, this will g...

Page 10 - OVERHEAD CABINET RANGEHOOD INSTALLATION POSITION; GOOD; BETTER; BEST

Page 10 INSTALLATION OVERHEAD CABINET RANGEHOOD INSTALLATION POSITION It is important to consider the benchtop and overhead cabinetry depth before installing the rangehood.The information below is to be used as a guide only, drawings are not to scale and do not account for all circumstances. The coo...

Page 11 - Installation for KLS-9GLASS and KLS-9GLASSBLKS; Fix the rangehood mounting supports (A) to the

Page 11 INSTALLATION Installation for KLS-9GLASS and KLS-9GLASSBLKS IMPORTANTPlease read the installation guide thoroughly prior to installation. These models have a different method of installation compared to standard undermounts. Step 1 Fix the rangehood mounting supports (A) to the sides of the ...

Page 15 - protection on the rangehood and

Page 15 INSTALLATION Step 6 Re-attach the fascia by securing it with 4 x locking screws (E). Step 7 Re-install the filter. E IMPORTANTPlease ensure all plastic protection on the rangehood and filters are removed before use.

Page 16 - ISODRIVE MOTOR SETUP

INSTALLATION Page 16 For technical support, please contact 1300 829 066. ISODRIVE MOTOR SETUP NOTEPlease refer to the Isodrive motor installation guide for more details on flexi ducting and Isodrive motor installation. FLEXIBLE DUCTING INSTALLATION IMPORTANT: Please do not crush or kink the flexi du...

Page 17 - Electrical Touch Keypad; OPERATION

Page 17 For models KLS-9GLASS and KLS-9GLASSBLKS.The rangehood has a 4-speed electronic keypad. Speed control usage suggestions:• Low speed for simmering.• Medium speed for light cooking.• High speeds for heavy frying or heavy cooking. Electrical Touch Keypad To obtain the best performance, switch t...

Page 18 - Electrical Tactile Keypad

Page 18 OPERATION Electrical Tactile Keypad To obtain the best performance, switch the rangehood on a few minutes prior to cooking and leave running for at least 10 minutes after you have finished cooking.The buttons have the following functions:A.- Timer: When this function is activated, the blue l...

Page 19 - CLEANING AND MAINTENANCE; Catch A; Figure 2; FILTERS

Page 19 CLEANING AND MAINTENANCE WARNINGAlways switch off and disconnect power to the rangehood before cleaning. The manufacturer is exonerated from all responsibility in the event of fire due to poor maintenance of the filters and rangehood.Cleaning and user maintenance shall not be carried out by ...

Page 20 - SURFACES

Page 20 CLEANING AND MAINTENANCE SURFACES The surface of the rangehood can be cleaned with warm soapy water and a soft sponge / cloth. • Never use abrasive detergents, scouring pads, steel wool or solvents on ANY part of this appliance. • Rinse with clean water and ensure that the appliance is compl...

Page 21 - NOTE: Never handle the glass of the lamp with; Type 3 — Halogen G4 HD, LED G4; Type 1 — LED Spot; heat for a short period of time after being switched off.

Page 21 CLEANING AND MAINTENANCE Halogen Bulb (G4) LED Bulb (G4) [Optional] 1 2 3 Your rangehood may have multiple light types, please refer to the pictures below for light replacement instructions. TYPE 3 (Halogen G4HD, LED G4): REPLACING THE HALOGEN OR LED BULB (MAX 20W, 12V) 1. Press on the indic...

Page 22 - NOTE: Always replace the lighting with

Page 22 CLEANING AND MAINTENANCE TYPE 4 (LED Strip TL): REPLACING THE STRIP LIGHTING 1. Open the Perimeter Aspiration (P.A.) filter panel and gently loosen the screws. 2. Remove the glass perimeter chassis by removing the screws (A). 3. Disconnect the LED strip light and electronic buttons including...

Page 23 - TROUBLESHOOTING; How to reduce the possibility of condensation

Page 23 TROUBLESHOOTING COOKING WITH INDUCTION COOKTOPS Cooking with an induction (or similar) cooktop, may produce condensation on the rangehood.Unlike basic electric or gas cooking, induction cooktops heat food and liquid instantly, which in turn, produces vapours rapidly. Because of the accelerat...

Page 24 - appliance by yourself. Always

CLEANING AND MAINTENANCE Page 24 Before you contact the technical service department, make sure that the product is plugged in and power is supplied.• Do not take any action that will damage the product. IMPORTANTNever attempt to repair this appliance by yourself. Always refer to a qualified Service...

Page 25 - Calling the Technical Assistance Service; FAULTY INSTALLATION

CLEANING AND MAINTENANCE Page 25 Calling the Technical Assistance Service HotlineIn the event that the failure is not due to the faults mentioned in Trouble Shooting, contact the Customer Service.In Australia, Customer Service 1300 829 066In New Zealand, Customer Service 0800 200 510 Lodging an onli...

Page 26 - TECHNICAL SPECIFICATIONS

Page 26 TECHNICAL SPECIFICATIONS Model: KLS-9GLASS, KLS-9GLASSBLKS Feeding Voltage: 220-240V 50HzMax Lamp Power: 1 x LED Strip 726mm long 3.36W 12V 4200k Model: GA-900S Feeding Voltage: 220-240V 50HzMax Lamp Power: 2 x GLED Square 55 x 55mm 2.1W 12V 4000k Model: GA-600S Feeding Voltage: 220-240V 50H...

Page 27 - DISCLAIMER

Page 27 Under our policy of continuous product development, product specifications may change without notice. Prospective purchasers should therefore check with the retailer to ensure this publication correctly describes the products being offered for sale. All information supplied is to be used for...