Page 2 - Index
Page 2 Index 1. Welcome 3 Your State Regulatory Authority 3 2. Important Safety Information 4 Before Installation 5 Product Use 6 Ducted or Recirculating? 6 Maintenance and Service 6 Cleaning the Baffle Filters 6 Electrical Cord 6 3. Description 7 Rangehood 7 4. Operation 8 Push Button Control Panel...
Page 3 - Welcome; Your State Regulatory Authority
Page 3 1. Welcome Thank you for purchasing your new Schweigen rangehood. To get the maximum output from this unit, please read through this guide before use. The guide contains important information on the use and maintenance of the unit, as well as important safety notes. This will ensure your pers...
Page 4 - Important Safety Information; WARNING
Page 4 2. Important Safety Information WARNING Please read this section thoroughly before attempting to operate the appliance. Inspect your product upon receipt. Any damage or defects MUST be reported within 48 hours, or no claim will be recognised. DO NOT INSTALL THIS APPLIANCE IF YOU FIND IT DAMAG...
Page 5 - Before Installation
Page 5 2. Important Safety Information 18. It is forbidden to use the rangehood as an aspirator. 19. Never cook foodstuff directly over the flame or have the gas burners on under the rangehood without using cookware. Before Installation 1. We recommend this appliance be installed or repaired by a qu...
Page 6 - Product Use; Ducted or Recirculating?
Page 6 2. Important Safety Information Product Use This product is designed for household use and should not be used for commercial applications. After use, always ensure that all controls are in the “OFF” position. When frying with a gas flame, take particular care not to allow the oil or grease in...
Page 7 - Rangehood; Description
Page 7 Rangehood 1. Mounting Bracket 2. Upper Flue 3. Lower Flue 4. 2x 150mm ducting 5. Power Cord 6. 2x 150mm outlets 7. Rangehood Body 8. 2x Drip Trays 9. Lights 10. Baffle Filters NOTE: Filter and light quantity may vary from model to model. 3. Description 1 2 3 4 5 7 6 8 9 10
Page 8 - Operation; Push Button Control Panel
Page 8 4. Operation Push Button Control Panel Turn off the rangehood Low speed setting Medium speed setting High speed setting Turn on/off the light Speed Control This undermount is equipped with a 3 speed mechanical control. Speed control usage suggestions: • Low speed for simmering. • Medium speed...
Page 9 - Cleaning & Maintenance; Cleaning the Interior; OK; Warning
Page 9 5. Cleaning & Maintenance Cleaning the Interior Clean the interior of the rangehood with a damp cloth and a neutral detergent or denatured alcohol. NOTE: Do not use denatured alcohol on the exterior of the rangehood. Do not clean the electric parts or the motor with liquids or solvents Cl...
Page 10 - Baffles
Page 10 5. Cleaning & Maintenance Endure the baffles are cool before removing, to ensure no oil is spilt. To remove, push away from you until the near edge clears the slot. Then carefully pull down and back to remove. To replace, perform the same operation but in reverse. Baffles For this applia...
Page 11 - Danger
Page 11 5. Cleaning & Maintenance Danger Always switch off and disconnect the power cord before replacing any light bulbs. Failure to do so may cause serious injury. Please be aware that the light bulb will retain heat for a short period of time after being switched off. Replacing the Light Bulb...
Page 12 - Installation; Rangehood Size vs Cooktop Size; BBQ Installation
Page 12 6. Installation Rangehood Size vs Cooktop Size In addition to the size, the height of the rangehood above the cooktop is important to obtain the best performance. INADEQUATE Rangehood smaller than cooking zone ADEQUATE Rangehood same size as cooking zone OPTIMAL Rangehood larger than cooking...
Page 13 - Mounting Instructions – Outdoor/Alfresco; In addition to the information in this manual,
_n_. _RH Section_ Page 13 6. Installation Mounting Instructions – Outdoor/Alfresco When installing in an outdoor kitchen or alfresco area,the rangehood MUST NOT be installed where it is directly exposed to the elements . It is STRONGLY RECOMMENDED that the rangehood be installed centrally over the c...
Page 14 - Wall Mount Installation
_n_. _LH Section_ Page 14 6. Installation Wall Mount Installation There are two primary mounting points and several secondary mounting points to firmly fix the rangehood in place. Suitable fixing screws must be used to mount the appliance on a secure surface. Please ensure that the holes for the two...
Page 15 - DANGER
_n_. _RH Section_ Page 15 6. Installation DANGER Always switch off and disconnect the power supply before installing the rangehood. Failure to do so may cause serious injury. NOTE Please make sure that filters are removed and put in a safe place while installing rangehood to prevent damage. Step 1 S...
Page 16 - IMPORTANT
Page 16 6. Installation IMPORTANT Please ensure all plastic protection on the rangehood and filters is removed before use. Step 3 Place flue covers on the rangehood and extend to the length required. (Be careful not to scratch the top of the rangehood). PLEASE NOTE: Only a standard length of stainle...
Page 17 - Ducting
Page 17 6. Installation Ducting Please DO NOT crush or kink the ducting. 1. Crushed or kinked ducting creates sharp corners that creates turbulence. This reduces the size and efficiency of the ducting, lowers extraction and may cause excessive noise. 2. Sweeping curves and taut ducting reduces resis...
Page 18 - Ducting Advice
Page 18 6. Installation Ducting Advice Never reduce flue diameter right next to the rangehood outlet fitting. Avoid excessive reduction of the flue size, as this drastically reduces extraction capacity. Keep the curves or bends to a minimum. If they do exist, try to keep the angles as open as possib...
Page 19 - Roof Cowls / Roof Seal Kit
Page 19 6. Installation Roof Cowls / Roof Seal Kit 1 2 3 4 *NOTE: Motor system does not include the roof seal/roof cowls, ring clamp or support straps. For best result, please install ducting in a straight line and duct length no longer than 4 metres. Do not reduce the ducting diameter, this will re...
Page 20 - Troubleshooting
Page 20 7. Troubleshooting Troubleshooting If the product does not work: Before you contact the technical service department, make sure that the product is plugged in, the electric fuse (on selected models) is in correctly and electric wiring is connected. (Fuses can be purchased from your local ele...
Page 21 - Faulty Installation
Page 21 7. Troubleshooting Faulty Installation It is not the responsibility of Schweigen to rectify any incorrect installations. A service call out fee will be charged for any Schweigen technician that attends a call, whereby it is established that the fault is due to an incorrect installation or no...
Page 22 - Specifications; Technical Specifications; Dimensions
550 284 670 550 50 100 225 600 1200 40 55 135 1100 Page 22 8. Specifications Technical Specifications Model CL6272 Feeding Voltage 220–240V 50Hz Lamp Power — LED (W) 2 x 3.5W Dimensions
Page 23 - Disclaimer
Page 23 9. Disclaimer Disclaimer Under our policy of continuous product development, product specifications may change without notice. Prospective purchasers should therefore check with the retailer to ensure this publication correctly describes the products being offered for sale. All information s...