Samson SAMDR1064 - Manuals

5 Front and Rear Panel Controls FRONT PANEL 1 MIC IN – Input connector for Low-Noise Microphone pre- amp. 2 LINE IN –Input connector for Line level inputs. 3 INSERT – 1/-4-inch TRS (TIP/RING/SLEEVE) connector providing send and recieve channel patch point for out-board effects. 4 GAIN – Used to set ...

6 Controls and Functions MONO/STEREO INPUT CHANNEL SECTION The following section details each part of the MDR1064’s MONO INPUT CHANNELS including the GAIN con-trol, LOW CUT switch, 3-BAND EQ, AUX sends, PEAK LED, PAN and LEVEL controls. The input channels onethrough six on the MDR1064 feature high q...

8 MAIN LEVEL The master MAIN control is the overall volume control for the left and right mix bus. These line level signalsare output from the MAIN MIX jacks. PHONES / CR The PHONES / CR control is used to set the level sent to thecontrol room outputs, and also to the headphone jack. 2 TRACK INPUT A...

AUX RET 2 The AUX RETURN 2 adjusts the level of the signal present at the AUX 2 RET jacks. This signal is summed,or mixed in to the main L/R MIX bus. TO AUX 1 This routes the signal that is present on the AUX 2 RETURNjacks to AUX 1 so that the effects can be heard in the monitormix. POWER LED The Po...

CHANNEL 1 – 6 MIC and LINE INPUTS The MDR1064’s channel 1 through 6 mono inputs each have a 1/4-inch connector for line level signals and XLRconnectors for the MIC signals. Channels 7/8 and 9/10 stereo inputs each have 1/4-inch connectors for line levelinputs. By using the GAIN control on channels 1...

Samson Technologies Corp. 575 Underhill Blvd. P.O. Box 9031 Syosset, NY 11791-9031 Phone: 1-800-3-SAMSON (1-800-372-6766) Fax: 516-364-3888 www.samsontech.com