Samson MDR 1064 - Manuals - manualsarea.com

Page 3 - Table of Contents; Mono/Stereo Input Channel Section

Table of Contents Introduction 2 MDR1064 Features 3 Front and Rear Panel Layout 4 Front and Rear Panel Controls 5 Controls and Functions Mono/Stereo Input Channel Section 6–7 Master Section 8–9 MDR1064 Input and Output Connections 10–11 Operating the MDR1064 12–14 System Set-ups 15–16 MDR1064 Wiring...

Page 4 - Introduction

2 Congratulations on your purchase of the Samson MDR1064 mixer! The MDR1064 is a ten-channel mixer, with sixlow noise microphone pre-amps. The six Mic/line inputs and two stereo inputs each feature a 3-band equalizerplus two Aux sends. The MDR1064’s master section includes two stereo Aux returns and...

Page 6 - Front and Rear Panel Layout

Page 7 - Front and Rear Panel Controls

5 Front and Rear Panel Controls FRONT PANEL 1 MIC IN – Input connector for Low-Noise Microphone pre- amp. 2 LINE IN –Input connector for Line level inputs. 3 INSERT – 1/-4-inch TRS (TIP/RING/SLEEVE) connector providing send and recieve channel patch point for out-board effects. 4 GAIN – Used to set ...

Page 8 - Controls and Functions; MONO/STEREO INPUT CHANNEL SECTION

6 Controls and Functions MONO/STEREO INPUT CHANNEL SECTION The following section details each part of the MDR1064’s MONO INPUT CHANNELS including the GAIN con-trol, LOW CUT switch, 3-BAND EQ, AUX sends, PEAK LED, PAN and LEVEL controls. The input channels onethrough six on the MDR1064 feature high q...

Page 10 - Auxiliar y Returns; MASTER SECTION

8 MAIN LEVEL The master MAIN control is the overall volume control for the left and right mix bus. These line level signalsare output from the MAIN MIX jacks. PHONES / CR The PHONES / CR control is used to set the level sent to thecontrol room outputs, and also to the headphone jack. 2 TRACK INPUT A...

Page 11 - POWER LED

AUX RET 2 The AUX RETURN 2 adjusts the level of the signal present at the AUX 2 RET jacks. This signal is summed,or mixed in to the main L/R MIX bus. TO AUX 1 This routes the signal that is present on the AUX 2 RETURNjacks to AUX 1 so that the effects can be heard in the monitormix. POWER LED The Po...

Page 12 - CHANNEL 1 – 6 MIC and LINE INPUTS; Microphone Input - Mono Input Channels; MDR1064 Input and Output Connections; MASTER SECTION INPUT AND OUTPUT JACKS

CHANNEL 1 – 6 MIC and LINE INPUTS The MDR1064’s channel 1 through 6 mono inputs each have a 1/4-inch connector for line level signals and XLRconnectors for the MIC signals. Channels 7/8 and 9/10 stereo inputs each have 1/4-inch connectors for line levelinputs. By using the GAIN control on channels 1...

Page 22 - Notes

Page 24 - Samson Technologies Corp.

Samson Technologies Corp. 575 Underhill Blvd. P.O. Box 9031 Syosset, NY 11791-9031 Phone: 1-800-3-SAMSON (1-800-372-6766) Fax: 516-364-3888 www.samsontech.com