Samson AL300 - Manuals - manualsarea.com

Page 6 - Table of Contents

Table of Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 QuickStart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 QuickStart . . . . . . . . . . . . . . . ....

Page 7 - Introduction

1 Introduction Welcome to Samson AirLine Synth—the next generation of wireless systems! Wireless microphone and instrument systems were originally developed to eliminate cables, providing unparalleled freedom of movement. AirLine Synth takes this concept to a new level with transmitters so small, li...

Page 8 - QuickStart

If you’ve had some prior experience using wireless systems, these QuickStart instructions will get you up and running with your AirLine UHF wireless system in a matter of minutes! Detailed instructions for setting up and using your AirLine Synth system can be found on page 15 of this manual, and the...

Page 10 - Guided Tour - AR300 Receiver / Front Panel

1. Antennas (A and B) - The antenna mountings allow full rotation for optimum placement. In normal operation, both Antenna A (the antenna on the left) and Antenna B (the antenna on the right) should be placed in a vertical position. Both antennas can be folded inward for convenience when transportin...

Page 12 - Guided Tour - AR300 Receiver / Rear Panel

A: Antenna socket - D hole knockout for mounting the antennas to the rear panel using the optional rear antenna kit. B: DC input - Connect the supplied power adapter here, using the strain relief as shown in the illustration below. WARNING: Do not substitute any other kind of power adapter; doing so...

Page 13 - Guided Tour - AL300 Transmitter

1: LCD Display – This three digit Liquid Crystal Display indicates the Absolute Channel number that the transmitter is set to. 2: 15 dB Pad - Move this switch in the direction of the arrow to reduce the output of the AL300 by 15 dB when your microphone is putting out too hot a signal. See the “Setti...

Page 15 - Setting Up and Using Your AirLine Synth sys-

The basic procedure for setting up and using your AirLine Synth system takes only a few minutes: 1. Remove all packing materials (save them in case of need for future service) and check to make sure that the supplied power adapter is the correct voltage for your country. If not, contact your distrib...

Page 16 - Setting Up and Using Your AirLine Synth system

6. Make the physical cable connection between the AR300 output jack and an audio input of your amplifier or mixer. Leave your amplifier or mixer off at this time. 7. Turn the Level knob on the AR300 completely counterclockwise, then slide its Power switch in the direction of the arrow to turn it on....

Page 20 - Specifications

SYSTEM SPECIFICATIONS Channels 319 channels 25kHz Step Operating Frequency N Band 639.025MHz-6476.975MHz (USA) U Band 798.025MHz-806MHz (Export) Frequency Type F3E Modulation Type FM Noise Reduction Type Compander Distance 100 meters line of sight Audio Frequency Response 50Hz - 15KHz (+/- 3dB) Dyna...