Royal Sovereign NB-1900N - Manuals

Page 2 - TABLE OF CONTENTS; TOPIC PAGE

TABLE OF CONTENTS TOPIC PAGE INTRODUCTION MAJOR PARTS CHARACTERISTICS OF NB-1900N SAFETY PRECAUTIONS SET UP CONTROL PANEL SETTINGS HOT LAMINATING COLD LAMINATING COLOR FOIL LAMINATING MOUNTING BOARD LAMINATING CLEAN ROLLERS AND REMOVE JAMMED FILMS IMPORTANT SAFETY CONCERNS MAINTENANCE ASSEMBLY PARTS...

Page 4 - SAFETY PRECAUTIONS

NB-1900N 4 Failure to comply with any of the following safety procedures could result in serious injury. Keep this information for future reference. 1.To prevent the possibility of fire or injury, do not allow articles of clothing (neckties, scarves, or paperclips etc.) inside the machine. 2. Do not...

Page 5 - FUNCTION OF BUTTONS; Cold film laminating

Place laminator on a sturdy, flat work surface. Allow ample clearence behind laminator for laminated document or photograph to exit completely without bending. Connect laminator to an electrical outlet that matches laminator's rated voltage and power requirements.If an extension cord is required, us...

Page 6 - INSTRUCTION OF BUTTONS AND LED

COLD 1. Press power button to turn laminator on or off. 2. When you press power button, "FUNC 2" LED is blinking. At this time, function buttons become available. 3. To choose film thickness, press or and you will see the LED read-out. 4. For cold laminating, press then green LED will light ...

Page 7 - HOT LAMINATING

1. Press the power button. 2. Choose setting by or 3. When red LED stops blinking and buzzer rings, you're ready to laminate. (It takes 4~5 minutes depending on setting function.) 4. Put document to be laminated, into a laminating pouch. Leave a minimum border of about 3mm(1/8"), to provide a pr...

Page 8 - Press the power button to turn laminator on.; COLD LAMINATING; ) Beware of dust while inserting document.; Finished laminated pouch will exit through rear of machine.

COLD 1. Press the power button to turn laminator on. 2. Press 3. It is ready when green LED blinking stops and buzzer rings. 4. Insert document into Royal Sovereign cold laminating pouch as follows. NB-1900N 8 COLD LAMINATING If it has recently been used for hot lamination, allow the rollers to be c...

Page 9 - COLOR FOIL LAMINATING

Your laminator has ability to add color by using color foil to documents copied or printed by laser printer using toner. 1. Press the power button to turn laminator on. 2. Find FOIL setting, using 3. Machine is ready when red LED stops blinking and the buzzer rings. 4. Position color foil where you ...

Page 10 - MOUNTING BOARD LAMINATING

**You can laminate photographs or pictures on a mounting board, less than 2mm (1/12") thick without any tension adjustment.** 1. Press the power button to turn the machine on. 2. Set FOIL setting with 3. When the LED light stops blinking and buzzer rings, the laminator is ready. 4. Place materia...

Page 11 - * Do not turn the unit on until the rollers are completely dry.

Be careful not to allow to damage temperature sensor, as damaged sensor could cause serious harm. 1) If film adhesive apears on the laminated pouch surface, Insert a sheet of clean, thick paper (about 0.5mm(1/50") thickness) into the machine 2~3 times on "FUNC 4" setting. The paper will ...

Page 12 - Check that switch is on; Cause

1. Be sure that neckties, necklaces, long hair and loose clothing are kept away while the laminator is in operation.2. Prevent children from accessing the machine.3. Place the machine on a sturdy, flat work surface to prevent damage.4. Make certain that the machine is connected to an adequate power ...

Page 13 - SPECIFICATIONS; DESCRIPTION

NB-1900N 13 SPECIFICATIONS NB-1900N 680x225x127mm (26.8"x10"x5") 445mm (17.5") 2mm (1/12") 75~125(micron) Four Roller (no carrier) 4~5 min Hot roller 8 SETTINGS DC FAN AC motor 520mm (20.5") per min. 11Kg (24 lbs.) AC 100V 50/60Hz, AC 120V 60Hz , AC 220-240V 50/60Hz 1000 W DE...

Page 14 - CORPORATE HEADQUARTERS; Royal Sovereign International Inc.

www.royalsovereign.com RS Holland B.V. Industrieweg 6K, 4104AR, Culemborg, The NetherlandsTEL : +31 (0)345 473 097FAX : +31 (0)345 519 811E-mail : [email protected] RS International Australia PTY. LTD. 30 Prime Drive, Seven Hills, NSW 2147, AustraliaTEL : +61) 2-9674-2127FAX : +61) 2-9674-2027...