Robertshaw DIGIAL NDN-PROGRAMMABLE THERMOSTAT - Manuals

Page 2 - IMPORTANT SAFETY INFORMATION; Step 1: Replacing Existing Thermostat; Old Terminal; Heat transformer, hot side; TO VERIFY C TERMINAL. IF IT IS THE COMMON SIDE OF THE TRANSFORMER, CAP; Table 1; Figure 1

IMPORTANT SAFETY INFORMATION WARNING: • Always turn off power at main fuse or circuit breaker panel before installing, removing, cleaning, or servicing thermostat. • Read all the information in this manual before installing this thermostat. • This is a 24 VAC low-voltage thermostat. Do not install o...

Page 3 - NOTE: FOR NEW INSTALLATIONS, MOUNT THERMOSTAT ON; Figure 3; TM

Recycling Thermostat If this thermostat is replacing a thermostat that contains mercuryin a sealed tube, do not place your old thermostat in the garbage.Contact your local waste management authority for instructionsregarding proper disposal of the thermostat. If you have any ques-tions, call Roberts...

Page 4 - Wiring Diagrams; Figure 4; Figure 5

5. Place thermostat against the wall at desired location. Make sure wires will feed through opening (Figure 4) on base of thermostat. 6. Mark placement of mounting holes (Figure 4). Set base aside. 7. If mounting on drywall, tap plastic anchors into wall. NOTE: ENCLOSED PLASTIC ANCHORS DO NOT REQUIR...

Page 6 - Figure 6; TERM

15. Set the GAS/ELEC switch to either GAS for a gas/oil heating system or ELEC for an electric heating system (Figure 6). 16. Install two AA Energizer brand batteries or equivalent into battery compartment as shown (Figure 6). 17. Replace thermostat cover by snapping into place. 6 R E S E T N O N - ...

Page 7 - Step 3: Testing the Thermostat

7 Step 3: Testing the Thermostat WARNING: DO NOT SHORT (JUMPER) ACROSS TERMINALS OF GAS VALVE OR SYSTEM CONTROL TO TEST OPERATION. THIS WILLDAMAGE THE THERMOSTAT AND VOID YOUR WARRANTY. 1. Put the HEAT-OFF switch into the HEAT position. The display will read HEAT. 2. Press the button until the tempe...

Page 8 - System; Figure 7

4. Put the -ON-AUTO switch into the ON position. The blower fan should turn on. The display will show a and ON. 5. Put the -ON-AUTO switch into the AUTO position. The blower fan should turn off. Step 4: Customizing the Thermostat ◆ Settings System Off: The heating system is off. Heat: The thermostat...

Page 10 - Step 5: Troubleshooting; Symptom; Thermostat does not turn on system.; Installation; If problems with thermostat cannot be resolved, call:; Changing the Temperature

Step 5: Troubleshooting Symptom Remedy Thermostat does not turn on system. Check wiring (see Installation section). If problems with thermostat cannot be resolved, call: Technical Support: (800) 445-8299 Monday-Friday 7:30 AM - 5:30 PM CST 10 Thermostat turns system on andoff too frequently. Increas...

Page 11 - Two Year Limited Warranty; warrants to the original contractor installer, or to the; Maple Chase; recommendations and instructions.; Maple Chase; agrees to repair or replace at its option any thermostat; Maple Chase; shall not be liable for any; Uni-Line North America; Warranty Claims Department

Two Year Limited Warranty Maple Chase warrants to the original contractor installer, or to the original consumer user, each new Robertshaw thermostat to be free fromdefects in materials and workmanship under normal use and service for aperiod of two (2) years from date of purchase. This warranty and...

Page 12 - NOTES