Robertshaw 9520 - Manuals - manualsarea.com

Page 2 - Features; Step 1: Replacing Existing Thermostat; Figure 1

Features • Multi-stage heating and cooling control • Zone system compatible as a master thermostat • Multi-colored LED indicators for system status • Low battery indicator. • Fahrenheit/Celsius display option. • Adjustable from 45°F (4°C) to 90°F (32°C). • Accuracy within ± 1 degree. • Adjustable te...

Page 3 - Table 1; Recycling Thermostat; Turn off power to the heating

Table 1 Old Terminal New Label Description R, V-VR or VR-R R 24 VAC Return Y, Y1 or M Y Stage 1 Cooling/HeatingCircuit O or R O Reversing Valve(Cooling Mode) B B Reversing Valve(Heating Mode) F or G G Fan Control Relay Y2 Y2 2nd Stage CoolingCircuit W1 or W2 or W-U W2 2nd Stage HeatingControl L or X...

Page 5 - Terminal screws are loosened. Insert wires into terminal strip; FIGURE 4

11. Terminal screws are loosened. Insert wires into terminal strip (Figure 4) matching the label to the corresponding terminal (see Wiring Diagrams below). Tighten screws. 5 Typical heat pump with cool active reversing valve and auxiliary/emergency heat. O B 9520 WIRING SAMPLE #1 Y1 E G W2 C L R Y2 ...

Page 7 - Figure 5; Step 3: Testing the Thermostat; DO NOT SHORT (JUMPER) ACROSS TERMINALS OF GAS VALVE OR

12. Put the °F/°C switch to either °F for Fahrenheit display or °C for Celsius display (see Figure 5). Figure 5 13. Replace cover on thermostat by snapping into place. 14. Turn on power to system . Test thermostat as described in the following section. Step 3: Testing the Thermostat WARNING: DO NOT ...

Page 8 - Step 4: Customizing Your Thermostat; Setting or Changing; Settings; System; or

5. Press the button until the temperature setting is at least 3 degrees above room temperature. The heating system should turn on. The fan may not turn on immediately, depending on the fan delay built into the furnace. 6. Put the COOL-OFF-HEAT-EM switch into the OFF position. The heating system shou...

Page 9 - Changing Temperature Differential; both and buttons; LED Indicators

◆ Changing Temperature Differential IMPORTANT: The temperature differential is factory set at 1 (1°). Thismeans that whenever the room temperature changes by one half of adegree from the temperature setting, the system will turn on. If the systemturns on too often, increase the temperature different...

Page 10 - If problems with thermostat cannot be resolved, call:; Troubleshooting; Symptom Remedy

If problems with thermostat cannot be resolved, call: Technical Support: (800) 445-8299 Monday-Friday 7:30-5:30 CST 10 Thermostat does not turn on system. Check wiring. (See Installing Model 9520Thermostat) Check fuse. Replace with 2 ampfuse if fuse has opened. Thermostat turns on and off too freque...

Page 11 - Five Year Limited Warranty; warrants to the original contractor installer or; Maple Chase Company; agrees to repair or replace at its option any; Maple Chase Company; shall not be liable for

Five Year Limited Warranty Maple Chase Company warrants to the original contractor installer or to the original consumer user, each new Robertshaw thermostat to befree from defects in materials and workmanship under normal use andservice for a period of five (5) years from date of purchase. This war...

Page 12 - NOTES