Robertshaw 9401 - Manuals - manualsarea.com

Page 2 - IMPORTANT SAFETY INFORMATION; Step 1: Replacing Existing Thermostat; Old Terminal; Figure 1

IMPORTANT SAFETY INFORMATION WARNING: • Always turn off power at main fuse or circuit breaker panel before installing, removing, cleaning, or servicing thermostat. • Read all the information in this manual before installing this thermostat. • This is a 24 VAC low-voltage thermostat. Do not install o...

Page 3 - NOTE: FOR NEW INSTALLATIONS, MOUNT THERMOSTAT ON; Turn power off to the heating and cooling systems.; TM

Recycling Thermostat If this thermostat is replacing a thermostat that contains mercuryin a sealed tube, do not place your old thermostat in the garbage.Contact your local waste management authority for instructionsregarding proper disposal of the thermostat. If you have any ques-tions, call Roberts...

Page 4 - Wiring Diagrams; Figure 4; R h R c; Figure 5

5. Place thermostat against the wall at desired location. Make sure wires will feed through opening (Figure 4) on base of thermostat. 6. Mark placement of mounting holes (Figure 4). Set base aside. 7. If mounting on drywall, tap plastic anchors into wall. NOTE: ENCLOSED PLASTIC ANCHORS DO NOT REQUIR...

Page 6 - Figure 6; TERM

15. Set the GAS/ELEC switch to either GAS for a gas/oil heating system or ELEC for an electric heating system (Figure 6). 16. Set the HP/NON-HP switch to either the HP for heat pump or NON-HP for furnace applications (Figure 6). 17. Replace thermostat cover by snapping into place. 6 R E S E T N O N ...

Page 7 - Step 3: Testing the Thermostat; CAUTION: DO NOT SWITCH SYSTEM TO COOL IF THE TEMPERATURE

7 Step 3: Testing the Thermostat WARNING: DO NOT SHORT (JUMPER) ACROSS TERMINALS OF GAS VALVE OR SYSTEM CONTROL TO TEST OPERATION. THIS WILLDAMAGE THE THERMOSTAT AND VOID YOUR WARRANTY. CAUTION: DO NOT SWITCH SYSTEM TO COOL IF THE TEMPERATURE IS BELOW 50°F (10°C). THIS CAN DAMAGE THE AIR CONDITIONIN...

Page 8 - System; Figure 7

7. Put the -ON-AUTO switch into the ON position. The blower fan should turn on. The display will show a and ON. 8. Put the -ON-AUTO switch into the AUTO position. The blower fan should turn off. Step 4: Customizing the Thermostat ◆ Settings System Cool: The thermostat controls the cooling.Off: The h...

Page 10 - Step 5: Troubleshooting; Symptom; Thermostat does not turn on system.; Installation; If problems with thermostat cannot be resolved, call:; Changing the Temperature

Step 5: Troubleshooting Symptom Remedy Thermostat does not turn on system. Check wiring (see Installation section). If problems with thermostat cannot be resolved, call: Technical Support: (800) 445-8299 Monday-Friday 7:30 AM - 5:30 PM CST 10 Thermostat turns system on andoff too frequently. Increas...

Page 11 - Two Year Limited Warranty; warrants to the original contractor installer, or to; Climate Controls NA; recommendations and instructions.; Climate Controls NA; agrees to repair or replace at its option any; Climate Controls NA; shall not be liable for; Invensys Climate Controls NA; Warranty Claims Department

Two Year Limited Warranty Climate Controls NA warrants to the original contractor installer, or to the original consumer user, each new Robertshaw thermostat to be freefrom defects in materials and workmanship under normal use and service for a period of two (2) years from date of purchase. This war...

Page 12 - NOTES