Regency I2100M - Manuals - manualsarea.com

Page 2 - Thank-you for purchasing a; REGENCY FIREPLACE PRODUCT.

Regency Insert & Hearth Heater 2 Thank-you for purchasing a REGENCY FIREPLACE PRODUCT. The pride of workmanship that goes into each of our products will give you years of trouble-freeenjoyment. Should you have any questions about your product that are not covered in this manual,please contact th...

Page 3 - THE REGENCY FIREPLACE INSERT; TABLE OF CONTENTS; Page; Insert Safety Labels

Regency Insert & Hearth Heater 3 THE REGENCY FIREPLACE INSERT & HEARTH HEATER TABLE OF CONTENTS OPERATING INSTRUCTIONS First Fire ..................................................................... 13Fan / Blower Operation (all units) ................................ 13Ash Disposal ..........

Page 4 - INSTALLATION; CAUTION

Regency Insert & Hearth Heater 4 INSTALLATION This is a copy of the label that accompanieseach Regency Small Flush Insert and Me-dium Flush Insert. We have printed a copy ofthe contents here for your review. UNITED STATES ENVIRONMENTAL PROTECTION AGENCY CERTIFIED TO COMPLY WITH JULY 1990, PARTIC...

Page 5 - HOT WHILE IN OPERATION

Regency Insert & Hearth Heater 5 INSTALLATION This is a copy of the label that accompanieseach Regency Hearth Heater and LargeFlush Insert. We have printed a copy of thecontents here for your review. LISTED FACTORY BUILT FIREPLACE INSERT CERTIFIED FOR USE IN CANADA AND U.S.A. MODEL: I3100L TESTE...

Page 6 - Requirements for Installing

Regency Insert & Hearth Heater 6 INSTALLATION CHIMNEY SPECIFICATIONS Before installing, check and clean your chim-ney system thoroughly. If in doubt about itscondition, seek professional advice. Your Re-gency Insert is designed for installation into amasonry fireplace that is constructed in ac-c...

Page 7 - MASONRY AND FACTORY BUILT FIREPLACE CLEARANCES; OPTIONAL FLUE

Regency Insert & Hearth Heater 7 Clearance diagram for installations INSTALLATION Side and Top facing is a maximum of 1.5" thick.Floor protection must non-combustible, insula-tive material with an R value of 1.1 or greater. * If the hearth extension is flush with the floor (F) it must extend...

Page 9 - ) Attach the assembled faceplate to the face-; Note: It may be easier to install the insu-; FACEPLATE AND TRIM; ) Fasten the faceplate mounting bracket to

Regency Insert & Hearth Heater 9 INSTALLATION Diagram 4: H2100M, I2100M and I3100L FaceplateAssembly 3 ) Attach the assembled faceplate to the face- plate mounting brackets. Diagram 2: I1100S Rear View Diagram 3: I1100S B) H2100M, I2100M and I3100L Inserts 1 ) Slide the spring nuts (supplied) ov...

Page 10 - ) Slide the supports into the clips. The tension; ) Push the Regency logo plate into the two; ) Align the fan support with the offset clip on; Electrical Grounding Instructions

Regency Insert & Hearth Heater 10 Thermo Switch Sensor Thermo Switch Sensor INSTALLATION FAN/BLOWER Blower/Fan Wiring Diagram 3 ) Slide the supports into the clips. The tension holding the clips in place may be adjusted byincreasing or decreasing the offset spacingof the clips. 4 ) Ensure that t...

Page 11 - SECONDARY AIR TUBE; FLOOR PROTECTION

Regency Insert & Hearth Heater 11 Medium Insert I2100M The unit arrives with the 2 baffle bricks on thefloor of the firebox. 1 ) If all 3 air tubes are installed continue on to Step 2), if not, follow the instructions be-low. Install the air tube into the holes in theside channels. The notch goe...

Page 12 - Steel Baffle; DRAFT CONTROL

Regency Insert & Hearth Heater 12 Pull Open Push Closed INSTALLATION A tighter fit will ensure the tube will not movewhen the unit is burning. See the diagramfor the large air tube installation (page 11),though there are only three air tubes in themedium units. 2 ) Slide the left baffle brick ov...

Page 13 - ASH DISPOSAL; OPERATING INSTRUCTIONS; FIRST FIRE

Regency Insert & Hearth Heater 13 The automatic temperature sensor will engagethe blower when the unit is at temperature andwill shut off the blower once the fire has goneout and the unit has cooled to below a usefulheat output range. To manually operate the fan system, push thefirst switch to &...

Page 14 - Removal for Cleaning etc.; MAINTENANCE

Regency Insert & Hearth Heater 14 6 ) Do not permit creosote or soot buildup in the chimney system. Check and clean chimneyat regular intervals. 7 ) Your Regency Insert can be very hot. You may be seriously burned if you touch theinsert while it is operating. Warn children ofthe burn hazard. 8 )...

Page 15 - PARTS

Regency Insert & Hearth Heater 15 PARTS LIST - I1100, I2100, I3100 Part # Description 846-913 Door Assembly-Small Gold (I1100)-no glass 846-915 Door Assembly-Small Black (I1100)-no glass 846-910 Door Assembly-Large Gold (I2100, I3100)-no glass 846-916 Door Assembly-Large Black (I2100, I3100)-no ...

Page 19 - WARRANTY

Regency Insert & Hearth Heater 19 WARRANTY Regency Fireplace Products are designed with reliability and simplicity in mind. In addition, our internal QualityAssurance Team carefully inspects each unit thoroughly before it leaves our door. Regency Industries Ltd. ispleased to extend this limited ...

Page 20 - Printed in Canada

Printed in Canada Installer: Please complete the following information Dealer Name & Address: ______________________________________________ __________________________________________________________________ Installer: ___________________________________________________________ Phone #: ________...