Razor 15130658 - Manuals - manualsarea.com

Page 2 - SAFETY WARNINGS

WARNING: Riding the Pocket Mod can be a hazardous activity. Certain conditions may cause the equipment to fail without fault of the manufacturer. Like other electric products, the Pocket Mod can and is intended to move, and it is therefore possible to lose control, fall off and/or get into dangerous...

Page 3 - Estimated Assembly and Set-Up Time; BEFORE YOU BEGIN; Required Tools

Remove contents from box. Remove the plastic separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the Pocket Mod is 95 percent assembled and packed at the...

Page 4 - Checking Spoke Tension; Attaching the Front Wheel

3 ASSEMBLY AND SET-UP 1 Remove plastic protector and insert handlebar assembly through front fairing and into fork until it stops. Raise to desired height keeping the handlebars and fairing aligned within the red arrows of the safety zone. 2 Tighten down the hexagonal bolt with the 6mm hexagonal key...

Page 5 - Charging the Battery; Inflating the Tires

4 q Charging the Battery Your Pocket Mod may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use. • Initial charge time: 18 hours • Run time: Up to 30 minutes of continuous ride time • Recharge time: up to 12 hours • Average battery life: 250 charge/disch...

Page 6 - REPAIR AND MAINTENANCE; Chain and Rear Tire Replacement; Turn power “OFF” before conducting any maintenance procedures.

5 REPAIR AND MAINTENANCE 4 With two 15mm wrenches, loosen the axle. Slide the wheel forward to loosen the chain and remove the wheel. Note the sequence of the hardware. Note: Your hands will get greasy doing this. q Chain and Rear Tire Replacement Tools required: Phillips screwdriver, 10mm wrench, t...

Page 7 - Replacing the Fuse; Turn power switch OFF.

66 REPAIR AND MAINTENANCE WARNING: To prevent shock, please follow the instructions accordingly and do not skip or combine any steps. 1 Lift up the seat and unscrew the four (4) Phillips head screws in the storage compartment and remove the tray. 3 Remove the fuse and replace with a new one of equal...

Page 9 - TroubleShooTing guide

8 Product does not run Product suddenly stopped working while in use Short run time (less than 15 minutes per charge) Product runs sluggishly Sometimes the product doesn’t run, but other times it does Product makes loud noises or grinding sounds Problem Possible Cause Solution Undercharged battery L...

Page 10 - POCKET MOD PARTS

Keep your Pocket Mod running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) POCKET MOD PARTS 9 01 Handlebar Grip (Right/Left) 02 Single Speed Twist Grip Throttle 02-1 Sleeve 03 Ha...

Page 12 - WARRANTY; Loose Parts; SAFETY REMINDERS; DO NOT RETURN TO STORE; Do not use this product for the first time until you

Tire Inflation Periodically inspect the tires for excess wear and replace as needed. Regularly check the tire pressure and inflate as needed. If you get a flat tire, the inner tube can be patched or a new tube can be purchased from Razor or an authorized repair center. Safety Gear Always wear proper...